[Completed] [Q] Eken_MID7_W70_GSL1680_Z7Z67-030A Bricked - XDA Assist

Hello everyone I'm new to XDA, and a total noobie when it comes to tablets and computers. I have a tablet which was purchased over 1 year ago from one of the shopping on the internet sites, it was supposed to be a Wondermedia WM8850. 7" tablet.
But it turns out to be a Eken Mid 7 W70 GSL.1680.Z7Z67 030A. It is showing just a blank screen you can see that the light is on in the back ground but it doesn't respond to anything. I have tried all the button pressing, run battery till empty, and then recharged, but it won't respond. I did get it to go into recovery mode once but it wouldn't go any further. I thought I would ask if anyone had had the same problem and was able to solve it. Thanks for any information, its much appreciated. pin62.:fingers-crossed:

Hi,
You likely need to try flashing the stock firmware again. But I can't find anything relevant on XDA for that. You can ask in the following section about it, or you can try contacting the manufacturer about firmware and flashing instructions.
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
Good luck!

Related

[Completed] Overmax Quattor10+ brick

Hello. I have problem tablet Overmax Quattor 10+ (my friend give it to me, becouse she pushed too hard power on button, so I had to open tablet and repair it by home-made solution). Everything gone perfect, tablet went on to the PIN screen. I asked her if she know it, but she said that the tablet hadn't any PIN secure. I was searching a lot how to crack PIN (not for SIMcard, just Android secure), but I didnt find anything so I started to install software again. I downloaded everything from here : overmax site. After download I pressed HomeButton connected to PC, program has found the device and asked me to format or not device. I pressed yes, the formatting went to 4% and device has disconnected (I didnt touch the USB cable or something). After this tablet couldn't boot (nothing show on screen), when I try again to format it, the program show info, that the Tablet or system image is incorrect. Windows detect the device in Device Manager. Anyone have solution for this?
Thank you in advice. Greetings.
Hi,
I'm sorry but I don't find anything related to your device, so you must start asking in one of this Q&A forum:
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
or
> General discussion > Questions and Answers
Good luck
Thread closed, thank you.

[Completed] [Q] JXD S6600C Tablet not booting

Hello,
I currently have a JXD S6600C Tablet [Device model: S6600C-A13-01-20131100926] which is not booting up. It is switching on, but the screen is not going past the "JXD" logo. I left it switched on for several hours, but it stays stuck on that screen.
I also reset the tablet to its factory settings through the recovery mode, but it is still getting stuck on the "JXD" screen. :crying:
Also, before I encountered this particular problem, I rooted the tablet, and was installing several games and apps. I restarted the tablet after rooting it, and had no problems; it is only after I installed some games that I encountered this problem.
Now, I don't have the drivers of this particular tablet, and I don't really know what I am supposed to do.
I would be very grateful if someone would be so kind to help me with this dilemma.
Thank You.
Hi there,
I'm sorry but I can't find anything related to your question/device.
Please post that in the forum bellow for more answers from the experts.
> General discussion > Questions and Answers or > Android Development and Hacking > Android Q&A, Help & Troubleshooting
Good luck
Thank you very much. I shall do so.

[Completed] Cube U55GT Talk79 Stuck in Boot Loop :(

Hi all,
This is my first post so be gentle! I will try and help others as my knowledge improves to keep the circle going!
My Cube U55GT Talk79 tablet has been stuck in bootloop for a long time now.
The cause was I attempted to install an update to it through "settings">"about tablet">"update" within Android. The update failed but I could still use the tablet just fine after this. A day or so later I decided to hit the "factory reset" button in Android to wipe the whole tablet clean.
Since then it has been stuck in its boot loop.
I was thinking of flashing the firmware by USB or by SD card but, to be honest, I am not sure of how to do this. I have tried to boot into a recovery mood but that doesn't seem to do anything at all.
I am really stuck and confused and would be so grateful if anyone on here could help me. I know many of you have no reason to help an utter stranger but if you could spare the time to I would really appreciate it.
Hi,
I'm sorry but I don't find anything related to your device, so you must start asking in one of this Q&A forum:
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
or
> General discussion > Questions and Answers
Good luck

[Completed] [Q] [WANTED] STOCK ROM FOR Mini Pad Android i9977 Model: 6.0HD PAD [MTK6577]

Hi! I've got myself in trouble. :crying: I've researched the forums and Google without success.
Long story short: The phone ran out of storage constantly. I'd successfully rooted the device.
The Mt657xRepartition_EN.apk used to repartition the storage got the phone stuck at the boot logo.
I can enter in recovery (Power + Volume Up) but I do not have the stock ROM to flash it back, nor I know how to use the ADB listed as one of the recovery options.
The ROM was identified as: e1911_v77_mt6628_hjy1_9p017_v20
I've photos from the phone and internal label, but as a new poster, I cannot offer the links in this message yet.
I'd no luck in finding it anywhere. It's frustrating...
Would a kind soul with the same phone provide me a copy of the firmware and point me to a tutorial on flashing it back to the phone?
I do not want to mess with the repartitioning anymore, just get the phone back to a working state so my daughter can use it again, despite it's limitations. It's a fine phone but it's awfully limited by the poor partitioning scheme of it's 4GB memory.
Any assistance will be highly appreciated.
Thanks a lot!
Hi there,
I'm sorry but I can't find anything related to your question/device.
Please post that in the forum bellow for more answers from the experts:
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
Good luck

[Completed] Android Tablet(noname) Bootloop, HELP

Hey Guys, I have a problem. I got an Chinese or something like that lol^^, Tablet and it stucks in a Bootloop or something like that, when I start it , it goes till the android logo and then it just stays there, I cant go into a recovery Mode I tryed a lot of combinations, Power and the sound+- buttons (it has no more buttons than this 3). Now my question is can I do Something ? Can I make a new fresh Android version on this Tablet using my PC ? Or is there another way to rescue the tablet, pls help me guys
XDA Visitor said:
Hey Guys, I have a problem. I got an Chinese or something like that lol^^, Tablet and it stucks in a Bootloop or something like that, when I start it , it goes till the android logo and then it just stays there, I cant go into a recovery Mode I tryed a lot of combinations, Power and the sound+- buttons (it has no more buttons than this 3). Now my question is can I do Something ? Can I make a new fresh Android version on this Tablet using my PC ? Or is there another way to rescue the tablet, pls help me guys
Click to expand...
Click to collapse
Hello, and welcome to XDA!
Now you have me curious as to the name of the tablet!
Without knowing the device name (because there is a myriad of things one can do, but only a small handful for any particular device), all I can do is point you to the direction of the [Ask Any Question][Newbie Friendly] thread of the > Android Development and Hacking > Android Q&A, Help & Troubleshooting forum.
Just so you know, in order to get any useful help, they will need to know as much info about the tablet as you can dig up (make and model number are good starters).
Hope this helps, and good luck!

Categories

Resources