[Completed] [Q] [WANTED] STOCK ROM FOR Mini Pad Android i9977 Model: 6.0HD PAD [MTK6577] - XDA Assist

Hi! I've got myself in trouble. :crying: I've researched the forums and Google without success.
Long story short: The phone ran out of storage constantly. I'd successfully rooted the device.
The Mt657xRepartition_EN.apk used to repartition the storage got the phone stuck at the boot logo.
I can enter in recovery (Power + Volume Up) but I do not have the stock ROM to flash it back, nor I know how to use the ADB listed as one of the recovery options.
The ROM was identified as: e1911_v77_mt6628_hjy1_9p017_v20
I've photos from the phone and internal label, but as a new poster, I cannot offer the links in this message yet.
I'd no luck in finding it anywhere. It's frustrating...
Would a kind soul with the same phone provide me a copy of the firmware and point me to a tutorial on flashing it back to the phone?
I do not want to mess with the repartitioning anymore, just get the phone back to a working state so my daughter can use it again, despite it's limitations. It's a fine phone but it's awfully limited by the poor partitioning scheme of it's 4GB memory.
Any assistance will be highly appreciated.
Thanks a lot!

Hi there,
I'm sorry but I can't find anything related to your question/device.
Please post that in the forum bellow for more answers from the experts:
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
Good luck

Related

[Completed] [Q] Eken_MID7_W70_GSL1680_Z7Z67-030A Bricked

Hello everyone I'm new to XDA, and a total noobie when it comes to tablets and computers. I have a tablet which was purchased over 1 year ago from one of the shopping on the internet sites, it was supposed to be a Wondermedia WM8850. 7" tablet.
But it turns out to be a Eken Mid 7 W70 GSL.1680.Z7Z67 030A. It is showing just a blank screen you can see that the light is on in the back ground but it doesn't respond to anything. I have tried all the button pressing, run battery till empty, and then recharged, but it won't respond. I did get it to go into recovery mode once but it wouldn't go any further. I thought I would ask if anyone had had the same problem and was able to solve it. Thanks for any information, its much appreciated. pin62.:fingers-crossed:
Hi,
You likely need to try flashing the stock firmware again. But I can't find anything relevant on XDA for that. You can ask in the following section about it, or you can try contacting the manufacturer about firmware and flashing instructions.
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
Good luck!

[Completed] Bootloop on RK3066 tablet

(I'm not sure where I should put this thread, and this section seemed to be the most apropriate. If it is not, sorry)
Hey.
So, I had a tablet I weren''t using. It is a Sunstech Tab7Dual, with RK3066.
I tried to turn it on, to give it to my father, who needs it. When I did, the tablet went on a bootloop. It turns on, then shows the brand's logo, and then the boot animation, and just repeats the boot animation forever. I noticed that when the device's battery is about to run out, it initiates the tablet for a half of a second.
I didn't have anything special that might mess with the system on it, just Mounts2SD and root. And I can't access recovery on this tablet (I don't have a Custom Recovery).
My PC seems to detect the device, but doesn't recognize it.
I tried SD Firmware Tool and had no success. Also had no success with RKBatchtool, that only displays a pink square instead of a green one.
What can I do?
Hi there,
I'm sorry but I can't find anything relevant to your question/device.
Please post that in the forum bellow for more answers from the experts:
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
Good luck

[Completed] [Q] I think i hardbricked my Phicomm i813... any help?

As the topic said,
I accidentally format the bootloader (its a 8KB partition that asked for format before you can use it that pop up during rooting process)
The moment i hit the format button, my phone goes for a quick vibrates and died. No power, no recovery/diagnosis mode, wont charge, pc goes error on driver while connected with the phone. Tried taking the battery out and hold the power button, leave it there for 2 days, tried any other stuff. It just wont flinch.
Is the phone hardbricked? Or is the battery faults? Is there a chance that the recovery can be made just to make my phone alive again? It was hard for me to find as this phone is kinda underground brand. Any help would be appreciated. Thanks!
Hi there,
I'm sorry but I can't find anything relevant to your question/device except this thread where you can ask: [Q] Phicomm FWS 710 Pro stuck before boot animation
Please post that in the forum bellow for more answers from the experts:
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
Good luck

[Completed] [Q] Prestigio bootloop, please help!

Hi!
I own a Prestigio 3400 and I believe I'm in need of an android 4.2.2. ROM (if I correctly understood how that whole system works).
I rooted my phone and everything was working perfectly until I decided to reboot it. Now, the phone got stuck at the booting screen (after the manufacturer logo everything turns like dark blue and stops dead in its tracks). I can access the recovery options, but nothing seems to work; tried everything, from cleaning the cache to completely wiping the system. I figured that a new OS should do the trick so I've tried to find the original firmware (long shot or a completely wrong move?) but that doesn't seem to be a thing. Also, I couldn't find any kind of ROM that would suit my phone and from what I understood (and admittedly, that's not so much) only certain ROMs go to certain phones.
Since my phone is now but a worthless brick and hours and hours of googling only left me in tears, I would greatly appreciate any kind of help or guidance.
I didn't, because I can't find it.
All of the links on the prestigio site are actually updates. The link to v.1.0.16 is the 1.0.13 to 1.0.16 update, not the firmware itself. I tried all of them though (better safe than sorry), but nothing seems to be working.
I think I found a 1.0.11 firmware but it requires the phone to be connected to the pc and seeing I can't make my pc to acknowledge the phone, that's not doing much for me. A kitkat version [for which is said that could be applied to my phone] isn't working either (installation just aborts).
Hi there,
I'm sorry but I can't find anything related to your question/device.
Please post that in the forum bellow for more answers from the experts:
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
Good luck

[Completed] Failed MTK6577 (Dapeng i9977) - Logo bootloop

I've researched the forums and Google without success.
Long story short: The phone ran out of storage constantly. I'd successfully rooted the device.
The Mt657xRepartition_EN.apk used to repartition the storage got the phone stuck at the boot logo.
I can enter in recovery (Power + Volume Up) and have a compatible ROM to flash it back, but the phone is not recognized (USB keeps ringing device on/off).
Alternatively, the recovery working allows the use of the ADB with microsd storage, but requires a signed image to accept the update.
The ROM is identified as: e1911_v77_mt6628_hjy1_9p017_v20 .
I've photos from the phone and internal label, but as a new poster, I cannot offer the links in this message yet.
Would a kind soul knowlgeable of same phone provide me guidance to a tutorial/procedure on flashing it back to the phone?
Any assistance will be highly appreciated.
Thanks a lot!
Hi there,
I'm sorry but I have not found anything related to your question/device, so you must start asking in one of this Q&A forum:
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
or
> General discussion > Questions and Answers
Good luck

Categories

Resources