Hello. I have problem tablet Overmax Quattor 10+ (my friend give it to me, becouse she pushed too hard power on button, so I had to open tablet and repair it by home-made solution). Everything gone perfect, tablet went on to the PIN screen. I asked her if she know it, but she said that the tablet hadn't any PIN secure. I was searching a lot how to crack PIN (not for SIMcard, just Android secure), but I didnt find anything so I started to install software again. I downloaded everything from here : overmax site. After download I pressed HomeButton connected to PC, program has found the device and asked me to format or not device. I pressed yes, the formatting went to 4% and device has disconnected (I didnt touch the USB cable or something). After this tablet couldn't boot (nothing show on screen), when I try again to format it, the program show info, that the Tablet or system image is incorrect. Windows detect the device in Device Manager. Anyone have solution for this?
Thank you in advice. Greetings.
Hi,
I'm sorry but I don't find anything related to your device, so you must start asking in one of this Q&A forum:
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
or
> General discussion > Questions and Answers
Good luck
Thread closed, thank you.
Related
Hi everyone and all the gurus here!
Help is much needed, the sad story is below.
1. Lauched LagFix (a trim utility) on my Fujitsu Stylistic M532
2. Some time passed, the device switched off by itself
3. Tried to boot with no luck, then to rest or enter in recovery mode - no effect, no any Android logos appeared. Just black screen, but a vibration when using power button and a lid lights when charging.
4. Win7 sees the tablet as Android device, but no discs are accessible (the Android device appears and dissappears subsequently in Win when pushing power button on/ off).
5. Tried several utilities (both Win and Dos) to restore the firmware, but all of them said there's "No device connected". Though Win sees the tablet in devices list anaway.
The LagFix developer stated that there's a so-called "Brick Bug" occurs to some devices because of the faulty memory controller when using his utility.
Couldn't someone please advice what to do or try to reanimate the tablet?
Million thanks in advance!
Hi,
As there's no section for your device on XDA, and I can't find a relevant thread for you.... This would be where to ask for help...
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
Good luck!
Thank you. Thread closed.
Mt Toto tv lap one netbook boots to the Toto icon with the message: Boot into recovery mode. I forgot the password so I used Android Device Manager to wipe and reset to factory defaults. Now I'm stuck at the icon screen. I tried the recommended procedure to boot into recovery mode: Press reset button, unplug power cord, continue pressing reset button and replug power cord. Nothing changes. In the comments section of the one blog with the reset procedure. a lot of people wrote in that the procedure didn't work. No one has replied with another option. The netbook is a year old and worked fine, as I wrote, I just forgot the password. The problem, as I see it, is: I need to find a way to discover the proper procedure to boot into recovery mode or perhaps there is some software out there that would let me reinstall the os. I'm open to any suggestions. I appreciate you taking the time to read this and for any advice you may have. Thank you.
Hi there,
I'm sorry but I can't find anything related to your question/device.
Please post that in the forum bellow for more answers from the experts.
> General discussion > Questions and Answers or > Android Development and Hacking > Android Q&A, Help & Troubleshooting
Good luck
Thread closed, thank you.
Hello everyone I'm new to XDA, and a total noobie when it comes to tablets and computers. I have a tablet which was purchased over 1 year ago from one of the shopping on the internet sites, it was supposed to be a Wondermedia WM8850. 7" tablet.
But it turns out to be a Eken Mid 7 W70 GSL.1680.Z7Z67 030A. It is showing just a blank screen you can see that the light is on in the back ground but it doesn't respond to anything. I have tried all the button pressing, run battery till empty, and then recharged, but it won't respond. I did get it to go into recovery mode once but it wouldn't go any further. I thought I would ask if anyone had had the same problem and was able to solve it. Thanks for any information, its much appreciated. pin62.:fingers-crossed:
Hi,
You likely need to try flashing the stock firmware again. But I can't find anything relevant on XDA for that. You can ask in the following section about it, or you can try contacting the manufacturer about firmware and flashing instructions.
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
Good luck!
As the topic said,
I accidentally format the bootloader (its a 8KB partition that asked for format before you can use it that pop up during rooting process)
The moment i hit the format button, my phone goes for a quick vibrates and died. No power, no recovery/diagnosis mode, wont charge, pc goes error on driver while connected with the phone. Tried taking the battery out and hold the power button, leave it there for 2 days, tried any other stuff. It just wont flinch.
Is the phone hardbricked? Or is the battery faults? Is there a chance that the recovery can be made just to make my phone alive again? It was hard for me to find as this phone is kinda underground brand. Any help would be appreciated. Thanks!
Hi there,
I'm sorry but I can't find anything relevant to your question/device except this thread where you can ask: [Q] Phicomm FWS 710 Pro stuck before boot animation
Please post that in the forum bellow for more answers from the experts:
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
Good luck
I've researched the forums and Google without success.
Long story short: The phone ran out of storage constantly. I'd successfully rooted the device.
The Mt657xRepartition_EN.apk used to repartition the storage got the phone stuck at the boot logo.
I can enter in recovery (Power + Volume Up) and have a compatible ROM to flash it back, but the phone is not recognized (USB keeps ringing device on/off).
Alternatively, the recovery working allows the use of the ADB with microsd storage, but requires a signed image to accept the update.
The ROM is identified as: e1911_v77_mt6628_hjy1_9p017_v20 .
I've photos from the phone and internal label, but as a new poster, I cannot offer the links in this message yet.
Would a kind soul knowlgeable of same phone provide me guidance to a tutorial/procedure on flashing it back to the phone?
Any assistance will be highly appreciated.
Thanks a lot!
Hi there,
I'm sorry but I have not found anything related to your question/device, so you must start asking in one of this Q&A forum:
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
or
> General discussion > Questions and Answers
Good luck