Database Info

[Completed] How to approach solving a boot loop for an unpopular device

I have an ematic egp010 tablet that is stuck in a bootloop
I think there are a few different tactics for getting this solved, but I am kind of at a loss as to where to start (and which forums to ask questions on)
I can get the device to be recognized as adb by a computer, but I can't get into the device recovery mode directly (it boots, I see an ematic logo, then an android system update type logo and then the device reboots)
So I feel like something should be doable, but due to the fact this is not a very popular device, I don't really know where to ask
Suggestions on what to do/where to start?

Hi,
The best place to ask for help with your device would be here,
Android Development and HackingAndroid Q&A, Help & Troubleshooting
Hopefully someone who knows your device can assist you!

[Completed] [Q] Am I Bricked/SoftBricked , lose my Rom? Help please.

Please be patient,& Gentle with me, I'm new here,,, (TY) Hi, I have a Pantech P9060 (old I know ) Android 2.3.4 , Gingerbread( Stock Rom). It's rooted. It will turn on, load in the boot screen- and stop there, and if I touch the power/menu keys, it will start the loop acting boot process, without re-starting the phone , just continuous boot screen. I have changed the boot screen probably 3/4 times from the original AT&T screen using Jimmy Rummel apps, Rom Installer . I've tried returning back from backup, Titanium Pro, I backed up to google drive as well, but regardless I can't seem to reset to factory( which I've done before), or even update, Nothing.. It's so frustrating. I've searched these forums inside out for a solution as to not bother you guys with my old phone issues, but I have to admit, I need help with this. I don't think it's hard bricked, I'm thinking I may have flashed the wrong Rom( im not sure though) trying to upgrade from 2.3.4 .. Not positive though. I sure hope there's someone to help me here, It wont connect to the PC syncing, Pantech PC Suite, yet my pc shows the phone in Device Manager and Computer. So I'm hoping I've done something simple, :/ stupid,,but simple. Anyone help me out ? Thanks in advance.......

Hi,
I can't find a relevant thread on XDA for your issue, so you'll need to ask for help here,
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
Good luck!

Thank you. Thread closed.

[Completed] [Q] Eken_MID7_W70_GSL1680_Z7Z67-030A Bricked

Hello everyone I'm new to XDA, and a total noobie when it comes to tablets and computers. I have a tablet which was purchased over 1 year ago from one of the shopping on the internet sites, it was supposed to be a Wondermedia WM8850. 7" tablet.
But it turns out to be a Eken Mid 7 W70 GSL.1680.Z7Z67 030A. It is showing just a blank screen you can see that the light is on in the back ground but it doesn't respond to anything. I have tried all the button pressing, run battery till empty, and then recharged, but it won't respond. I did get it to go into recovery mode once but it wouldn't go any further. I thought I would ask if anyone had had the same problem and was able to solve it. Thanks for any information, its much appreciated. pin62.:fingers-crossed:

Hi,
You likely need to try flashing the stock firmware again. But I can't find anything relevant on XDA for that. You can ask in the following section about it, or you can try contacting the manufacturer about firmware and flashing instructions.
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
Good luck!

[Completed] Cube U55GT Talk79 Stuck in Boot Loop :(

Hi all,
This is my first post so be gentle! I will try and help others as my knowledge improves to keep the circle going!
My Cube U55GT Talk79 tablet has been stuck in bootloop for a long time now.
The cause was I attempted to install an update to it through "settings">"about tablet">"update" within Android. The update failed but I could still use the tablet just fine after this. A day or so later I decided to hit the "factory reset" button in Android to wipe the whole tablet clean.
Since then it has been stuck in its boot loop.
I was thinking of flashing the firmware by USB or by SD card but, to be honest, I am not sure of how to do this. I have tried to boot into a recovery mood but that doesn't seem to do anything at all.
I am really stuck and confused and would be so grateful if anyone on here could help me. I know many of you have no reason to help an utter stranger but if you could spare the time to I would really appreciate it.

Hi,
I'm sorry but I don't find anything related to your device, so you must start asking in one of this Q&A forum:
> Android Development and Hacking > Android Q&A, Help & Troubleshooting
or
> General discussion > Questions and Answers
Good luck

[Completed] Polaroid S7 Android Tablet stuck on Boot Screen

I have charged it to full, tried entering recovery mode, the screen remains black when doing so.... I can't connect it to my computer because the device drivers always fail to install.. I'm clueless into what i can do to fix this problem, if anyone could help me before I decide to go purchase a brand new tablet, that'd be great.

XDA Visitor said:
I have charged it to full, tried entering recovery mode, the screen remains black when doing so.... I can't connect it to my computer because the device drivers always fail to install.. I'm clueless into what i can do to fix this problem, if anyone could help me before I decide to go purchase a brand new tablet, that'd be great.
Click to expand...
Click to collapse
Hello there! Welcome to XDA!
There is no Forum for your device on XDA...
but... First register an XDA account, then try asking here:
Android Q&A, Help & Troubleshooting
or here:
General Q&A
Good Luck!