running the phone only by charger - HTC Vox

anybody know any tweak to run the phone only by the power supplied by the charger because when i used the wmwifirouter it drains a considerable amount of power and so the phone heats very soon.pls help me
thanks in advance

Normally, when you boot you device with your battery in and it's connect to the charger, you can remove the battery and it will work.

Related

Usb fast charging

I can't understand why it is so slow to charge!
I tried also nuePower... but with no results.
The phone charge slow (in the same usb port where other htc phones charge quickly!)...
Do you have suggestions?
usb charging is just like that.. if you want it to charge faster, use the wall charger. although, from what i've heard, slow charging is better for the battery anyways.
yes but I usually use my tp as modem and happens that phone discharge quickly than what it charges!!! so after 3 hours phone is completely discharged!!!
This happens only with tp and not with touchHD neither with TytnII!
Incredible!
Although the voltage is the same on a PC USB port as on the wall charger, the amperage is much lower. Thus, the phone will charge significantly faster on the wall charger.
However...
I also use my TP as a modem, and I can leave it on the web indefinitely. If yours is running down, perhaps there's a different issue at play - if you don't have any power hungry apps running in the background you might just have a borked battery or USB port...
* double post, mods please delete *
Just put your phone off... the charching goes much faster...
enigma243 said:
Although the voltage is the same on a PC USB port as on the wall charger, the amperage is much lower. Thus, the phone will charge significantly faster on the wall charger.
However...
I also use my TP as a modem, and I can leave it on the web indefinitely. If yours is running down, perhaps there's a different issue at play - if you don't have any power hungry apps running in the background you might just have a borked battery or USB port...
Click to expand...
Click to collapse
I tried just after hard reset without installing any application before.
I'm using Energy ROM and I'm quite sure ROM doesn't have any problem...
I do have the same problem with my Touch Diamond. When connected to my PC or even using my car charger, it will discharge completely after 2 or three hours of using, say, GPS and a few 3G connections to check traffic.
I can't use my Diamond as a modem for the same reason... I have flashed several roms and radios, nothing changed.
Double post
Check if the TP really charges! The unit switches off the charging mode when it gets too hot or better too warm. So e.g. when in use as a GPS in car typically mounted on the windshield, it gets too warm pretty easily as GPS is quite an energy hungry application and quick discharging also heats up the battery.
CU,
Cactus World
P.S. If you are using the TP in car and have aircon, then try to direct one of the cold air streams to the TP to keep it cool. That helps to prevent the switching off of charging mode.
Try tbattery
I use the Energy Rom and it has a utility called tbattery that can show you whether the phone is charging or not and at what rate. Would at least tell you what's happening in the phone. Also gives you the internal temperature of the phone. I've found anything higher than 41 degrees c causes the phone to go into a slower charge mode; it's possible that a higher temp could stop charging altogether - however it should still allow you to power the phone and not use the battery....
I can use phone as modem and still charge it via usb. maybe try a different rom?
I can do that, too ! The problem is the phone charges too slowly, so that the actual power consumption is higher than the charging...
I think that it depends on how you use your phone as an Internet source. I use wmwifirouter, and last time I plugged into ac, my batery still ran down. If your phone lasts 4 hours as a wifi router with no power and charging takes 5 hours, you are operating at a defecit.
I'm using 3G and Internet Connection Sharing through USB cable.
And my diamond charges completely in less than two hours using the wall charger.
Normal behavior, USB port doesn't have enough "juice" to charge it faster.
If you want a quick charge - use wall charger.
1) I can't use tethering through USB if I use the wall charger
2) I use tethering when i'm NOT near a wall power outlet, obviously
3) I don't want a "quick charge"... I just want the phone not to loose charge.
4) I have owned many WinMo devices and this is the first one that will not hold charge while connected to USB
Start -> Settings-> System tab -> Power
There will be a check box that says "When device is turned on, do not charge the battery when connected to the PC." Make sure it isn't checked.
That's the only thing I can think of right now. If I think of anything else, I'll post it.
bassman79 said:
Start -> Settings-> System tab -> Power
There will be a check box that says "When device is turned on, do not charge the battery when connected to the PC." Make sure it isn't checked.
That's the only thing I can think of right now. If I think of anything else, I'll post it.
Click to expand...
Click to collapse
Thanks for the hint, but it isn't checked.
I think it's just that the phone requires too much power
And it's getting very hot very fast, which will hinder proper charging, too.
I wonder if other modern HTC devices have the same overheating problem...
hello
sorry for pushing up the topic with no sloution but new question, but yesterday i get mad when after two hours of playing streamed music + being connected to wifi my TP battery died :/ Phone was connected to wall charger (oryginal from HTC) and still i was not enough. Damn it didnt happent ever to my blueangel/eten/hermes or any other earlyer device i had. Really im starting to be angry on my latest choice of this phone i should have stay with kaiser
sorry for spelling mistakes but my English is more verbal than writable

My s3 is losing battery while plugged in.

Ive been using my s3 for about 40 minutes on CM10. Plugged into a dual usb charger connected to not ip port, which in the past i have used fine. I have lost 5% battery in this time. Current widget doesn't work yet with S3. Suggestions?
Edit - The first time I got the phone after a full charge and discharge, while plugged into stock charger and before anything root, the same problem happened.
sfetaz said:
Ive been using my s3 for about 40 minutes on CM10. Plugged into a dual usb charger connected to not ip port, which in the past i have used fine. I have lost 5% battery in this time. Current widget doesn't work yet with S3. Suggestions?
Edit - The first time I got the phone after a full charge and discharge, while plugged into stock charger and before anything root, the same problem happened.
Click to expand...
Click to collapse
From what I heard, the charger can't charge the phone fast enough when you are using it thus the losing charge while plugging in. If you are talking about losing percentage right after you disconnect the phone from the charger, that is a feature, I do not know at the top of my head why it does it.
If charging through USB port (and many car chargers) you're capped at 500mA vs 700+ for wall chargers. You can install a kernel that supports fast charging and you will get 700mA through USB.
Sent from my SCH-I535 using Tapatalk 2
I'm having the same issue whether charging from usb or a power outlet. Charges for a bit initially, then drains. Happens with different cords, too. I'll pick it up and it will feel warm, see that the battery is lower than when I plugged it in, then put it down. Then it cools off and starts charging again. Any ideas?
Same here except
i have the same issue, i had stock Touchwiz and suddenly the phone started to discharge while on charging outlet, tried different chargers, outlets, different ports, etc. still wouldnt work, i even deleted several applications and turned off several phone functions, etc. still nothing, then i rooted to CM10.1 and the same issue still presists, the phone charges a bit then discharges weather i use it or not. the only solution to charge it, it seems to be by turning off the phone. i think it has to do with the usb port on the phone as i even had the battery changed and it still would discharge while on a charger.
S3 Battery Decreasing while charging SOLVED !!
Hey i have 100% Solution of this with this you will your battery life !
i got same problem too but i solved now i'm happy
this is so easy , for all samsung phones and android phones !
Just install battery doctor (cheetah Software) from play store
optimize your phone and then charge
your phone will charge fastly !!!!!!!!!!!!!!!!!!!!!!!!!!
with this your battery life will also increased !!

[Q] Phone Discharged Offline charging disabled

I have installed a custom ICS ROM with OFFLINE charge disabled. Now my phone is fully discharged. It bots up but as the discharge is happening more quickly than charge, it is rebooting again.
Can somebody please help here. Phone is as good as bricked.
Thanks,
abhising said:
I have installed a custom ICS ROM with OFFLINE charge disabled. Now my phone is fully discharged. It bots up but as the discharge is happening more quickly than charge, it is rebooting again.
Can somebody please help here. Phone is as good as bricked.
Thanks,
Click to expand...
Click to collapse
Try wall charger if you are on USB charging, secondly you can have a charger of higher capacity to draw more current.
Tried wall charger, laptop and desktop but same result. How and where to get High capacity charger?
abhising said:
Tried wall charger, laptop and desktop but same result. How and where to get High capacity charger?
Click to expand...
Click to collapse
Try getting higher Amp rating charger.
There is one more interesting trick you can do, keep pressing power button before connecting charger (your phone won't boot as battery is dead) then connect charger but keep pressing your power button. Let it go after like 1 minute approximately. Hopefully by then it will have enough charge.
Put your phone in recovery ... charge fr a bit and reboot phone via recovery ... worked for me a couple of times ...
Sent from my LG-P500 using xda app-developers app

[Q] Wont charge when plugged in

Hello.
I have a new Moto g 4g and sometimes when I plug it into the mains to charge the charging battery icon appears and the phone says charging on the lock screen. But as soon as the % number should go up (i.e. after a couple of mins on charge), the battery charge icon is still there but the phone no longer says charging on the lock screen, and it doesn't charge no matter how long it is plugged in for (although the battery doesnt drain either).
I turned the phone off and plugged it in and when it got to the charge screen it kept flicking between a question mark, and the percentage charged amount.
It seems to always charge fine when I plug it into a USB on my computer (although slowly).
Has anyone else seen this? Is it worth completly draining the battery and charging from flat, or would this do more harm than good?
Thanks for the help.
apr_1985 said:
Hello.
I have a new Moto g 4g and sometimes when I plug it into the mains to charge the charging battery icon appears and the phone says charging on the lock screen. But as soon as the % number should go up (i.e. after a couple of mins on charge), the battery charge icon is still there but the phone no longer says charging on the lock screen, and it doesn't charge no matter how long it is plugged in for (although the battery doesnt drain either).
I turned the phone off and plugged it in and when it got to the charge screen it kept flicking between a question mark, and the percentage charged amount.
It seems to always charge fine when I plug it into a USB on my computer (although slowly).
Has anyone else seen this? Is it worth completly draining the battery and charging from flat, or would this do more harm than good?
Thanks for the help.
Click to expand...
Click to collapse
did u try a different charger?

[Q] Using an external battery to power phone: Some problems...

I hope this is the right forum for the topic.
First I want to describe my situation:
I want to use an older phone as a webcam. The webcam is outdoor and there was no power source available.
So I bought a solarpanel which has an inbuilt USB charger for phones. The solar panel works great and it doesn't take long until the battery is full.
The problem is that the sun is not allways there when you need it I needed a battery with higher capacity that the phone (webcam) can be used longer without the need to get charged. So I bought two 5000mAh batteries from Amazon, connected them in parallel and changed them with the orignal battery from the phone. (btw. the phone is a Huawei Ascend Y201 Pro)
The problem is that the phone won't charge the battery. I found out that the third pin in the phone is to monitor the battery. If that pin is not connected the battery won't be charged.
Do you have any idea how to solve this problem?
First I thought about buying one of these external battery packs. But all that I found have a button that has to be pressed in order to charge the battery. But that is not possible because the phone (webcam) should work autarkical.
Some have an autostart function but after the battery is full it is required to replug the phone in order to get the battery charged again. Is there an app maybe that can disconnect and reconnect the USB connection without unplugging the cable?

Categories

Resources