Hi everyone
In need some advice. I think my device is dead.
I`ve updated my mda about 5 times and i never had any problems now i updated my device with rom version from qtek.nl version MDA_TA_WWE_DutchRetail_11200_550_11200_ship but at the second part it hangs up at 47 % and gave me a error, like de message sad i disconnect my device soft reset the device and tried to update it again but it`s not working.
If i connect my device on my pc it does not show up, also if i connect it to the power suppl now light is burning (so i think it`s now charging) the only thing i see on my device is the QTEK logo and some kind of picture of a night city below i see R 1.12.00 / 1337 42 / D 1.12.00 WWE on the left side i see the logo of windows. I have removed the battery but still i see the same screen and i can not turn it of.... if any one can help me with this pleas let me know.
It may be that my q-tek is bricked. To cut a long story short I am rebooting and it is getting stuck on the QTEK page displaying:
IPL 2.20.0001
SPL 2.20.0001
GSM 02.47.21
It also had OS2.20.7.34 but this is not showing.
Problem is - this is a swisscom fone and therefore I cannot access the original QTEK site as it fails to recongise my IMEI.
I have also tried in my ignorance to reflash it but now its stuck.
Is there anyway I can have access to the original English software so that I can try to reflash and re-install from scratch?
I also wanted to add that even a hard reset is not getting it to start up.
And another thing - sometimes the screen just freezes and breaks up in line and colours. What is that? Is my fone dead or dying?
Any help will be appreciated.
Delgada
The three colour screen is bootloader. If you can get that, your device is recoverable.
edit: http://wiki.xda-developers.com/index.php?pagename=Prophet_recovery
This does work, I wrote it from past experience....
Hi,
thanks for your help. Did all your link said.
IT LIVES AGAIN!!!!! THANKS
One question though - if my fone still goes off and the screen feezes and fades out or breaks into lines - what sort of problem would that be?
Cheer!
Delgada
Depends... It could be the ROM, it could be the ribbon cable connecting the screen to the motherboard, it could be an IC (but I doubt that as you say it works)...
Hi.
I realised that last time i opened my Qtek something must have not been in place as I was pressing the case and the pda was freezing. I opened it up for the umpteenth time and made sure all contacts were ok and closed it carefully. It now works fine. Last hiccup - getting it to read my home wifi when it reads everyone elses already.
Thanks
Delgada
Hy,
I ve got the problem that suddenly my TP shows unusually hanging after a few minutes playing around. If i do a softreset then it hangs on the splash screen and nothing happens. I can do a hr then and the same story begins. After tast appeared i flashed some other roms to be sure that its not depending from the rom. Also i restored different backups, with all its the same... i fear that a part of the memory is defect ... Any ideas how to test the memory or other suggestions? thx in advance.... i dont want to use my microwave
Greetz
Boris
Did this happen suddenly or did you do something before it happened (eg install something, etc)?
Mine just today won't turn on, I had it off all day and now it just sits on the splash screen.
Trying some things, if I figure anything out I'll let you know.
No, i didnt do anything special today or yesterday, but a week ago i set it up completly new, cause i had equal problems.... to set it up completly new with all progs and cosmetic "operations" costs me nearly one week so i dont want to do it again ...
If i find a way to solve, i will post here too
Greetz
Boris
I flashed EnergyROM (booted into the tricolor screen by holding down Power and Volume Down), and it seems to be working.
Youre the lucky one, congrats...
I have a similar problem. The only change/new install is the updated version of Microsoft MyPhone. Now my TP will not connect to my telephone provider: T-Mobile. It just tries and tries but never connects.
Also, sometimes when I try to open any program, I get the error message that the certificate cannot be read. a soft reset fixes this but this problem is driving me crazy.
Is this another Microsoft update ****up?
same here: today more than 3 times problems with certificate or similar message ... thinking of the last timebomb in my old romeos rom ... was no fun..
Borisku,
Are you running Microsoft MyPhone? If so, did you do the software update within the past 4 days?
i do, but i didnt update ... ??? This morning my TP hung again, and i tried to sr it.... seemed to work until tp vibrates 3 times and then nothing anymore, no screen, no button, nothing
.... took out battery, left it out for 30 minutes, then i could HR again and restore my backup... since then no problems.... do you think it could run too long, getting too hot or something like this??
Greetz
Boris..
Edit: was too fast just 1 minute after i wrote that, tp hangs while in connection to active sync.... hr now, will test how it runs with pure romeos2 for 2 days now... rport follows
Edit II: The last days i always flashed from SD Card... i will now try to flash ROMEoS2 from PC ... maybe theres a difference, especially cause the text at the end of flashing from SD was confused. there were mor than one words at one place one the screen, and i found i typing on the screen RaphSimg.nbh, although the file is named as usual raphimg.nbh (without the "s" in the centre...)
I hope i m not too early: i think i solved the prob, maybe that helps somebody & prevents a tp from ending in a microwave
in preparing to bury my tp in the microwave i flashed back to the german stock rom or - correct - to the official update that can be loaded from the HTC Homepage; it contains not only the Rom but also radio & Splash Screen. I flashed it to my tp and was prepared to undo Hard SPL, but it gave it a chance.... and it ran like a VW beetle, flashed back to ROMeOS2, it runs.... i will wait till tomorrow & hope that it will not change to freeze or change clock Font colour partly as it did before...
Hope it will help somebody...
Greetz
Boris
Edit: its now 14th of december and it runs like a charm... seems like the failure is gone through flashing to stock ROM & then flashing ROMeOS again
Still is okay ...
So.. I found a update for my Qtek 2020i and while it was updating it disconnected from the PC. It turned on and I checked the version to see the update didn't work so I wanted to try again. I restarted it and it didn't want to turn on anymore. I tried the soft reset and hard reset it didn't work. It's just being numb without any signs of working. Any idea what might had happened? Also any idea where I can find a cd for it? Like the main cd which comes with it cuz I assume it has the update manager which works when something like this happens.
Hey guys... Ive had my tf300t for a few months now without any problems... The keyboard dock is giving some trouble... Some letter keys dont work... Z/F/V/./, etc dont work... Is there any way to fix it?... Its really annoying because i cant type a email/memo etc... The on-screen keyboard on the tablet itself works flawlessly... But when i attach the dock it dont work... The mouse/SD card reader/USB etc works great... Can anyone please help...
Maybe try other input method, like External Keyboard Helper (from Play store)
I believe its a hardware issue... I wonder if i open it up if i can fix it... I live in trinidad and to order a new dock from amazon would cost me over $1000... lol...
I ae exactly te same problem! Using te dock rigt now I don't tink it's ardware tb but I can't ind a way to cange te sotware on te dock!