How much screen bleeding is normal? - Xiaomi Redmi Note 6 Pro Questions & Answers

Hello,
I bought the RN6P recently and noticed there were some reports about a backlight bleeding issue like on the Poco F1 on the internet. But I also saw other people mention, that a certain amount of bleeding is normal, since the screen is being lit from the side.
So I took a picture and I want you opinions on this. The 'bleeding' appears on the chin (maybe 1 - 2 mm; you can see it fading away towards the corners of the screen) and on the top (not really visible on the picture) of the phone, is this a normal ammount or should I try to return it?
From the Xiaomi Forums (better pic quality):
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Mine:

well usually there are some bleed mostly around notch as you must have read it, but I am not sure if this yellow ting on the down side is real or just present on this photo - however if it is seen in real this yellow-ish like, it is quite not normal, as it is not close to the screen end, but is rather centered .. I would try to return/replace the piece at the reseller, if possible.

clemenza011 said:
well usually there are some bleed mostly around notch as you must have read it, but I am not sure if this yellow ting on the down side is real or just present on this photo - however if it is seen in real this yellow-ish like, it is quite not normal, as it is not close to the screen end, but is rather centered .. I would try to return/replace the piece at the reseller, if possible.
Click to expand...
Click to collapse
That yellowish stuff are just the apps on the screen. I was reffering to the chin, where it's the most obvious. It's not as bad as with the Poco F1, but it still catches my eye time to time.

Related

Craig CMP738A Panel Defect

This is my second one not purchased in the same store. I see the same issue that I had with the prior. Funny a different state and different CVS upscale drug store and it still has the same issue. I bet all of them this way and most buyers are unaware of this issue with the panel. Either Anti-Glare film wasn't applied correctly or the the panel is not assembled correctly. No QCI, if there were this wouldn't have pass inspection and be rejected.
Down below you can see what's going on. If you do firmware update or factory reset i you can see how bad it is.
Craig
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Coby
Maylong
I've posted the above at many forums so far this reply was the best answer.
I have noticed that text cutoff on the left edge of mine, too (landscape with "Craig" logo on top). Looks either like a classic video adjustment issue (hsync on LCD possible?), or imprecise placement of the LCD panel within the bezel, which I suspect is more likely considering the price point. Simple fix: rotate 180 degrees for apps where it matters like a terminal session
But then the placement of the top layer on the screen (protector? anti-glare? digitizer?) might be more noticeable as there is a gap of about that same 1mm or so on that side. Hmm... maybe that is also imprecise screen placement issue - everything shifted that way? Oh well, for <$100 we may have to overlook the "edge cases"
Click to expand...
Click to collapse
Simple test to see if you run CM3.apk

Amoled screen color consistency...

On my new s6, with a completely white screen...it's noticeably redder at the top, and gets whiter/yellower as it moves towards the bottom of the screen. How is everyone else's screens?
nathan118 said:
On my new s6, with a completely white screen...it's noticeably redder at the top, and gets whiter/yellower as it moves towards the bottom of the screen. How is everyone else's screens?
Click to expand...
Click to collapse
Pic would probably help, but I would return it. My edge has a green/yellow tinge to it, I'm going to be sending it back as well.
thawk720 said:
Pic would probably help, but I would return it. My edge has a green/yellow tinge to it, I'm going to be sending it back as well.
Click to expand...
Click to collapse
Will try and take one. Just opened up the second S6 I ordered, and its screen looks a lot better. Got two white phones, and think I'd rather have black, so will probably just return the one with a bad screen for a black one.
Here's a pic. Top and bottom of the screen seem pretty different.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I never noticed it until now but the lower 1/5th of my screen is actually very slightly red compared to the top. Ugh.
poweroutlet said:
I never noticed it until now but the lower 1/5th of my screen is actually very slightly red compared to the top. Ugh.
Click to expand...
Click to collapse
Yeah I would send that **** back to Vietnam or wherever it came from.

backlight edge bleed?

I bought Z3 LTE from Sony Store last week but I returned it because it had edge light bleed problem on the left side and I returned it. I ordered a second unit few days ago and I received it and seems it has the same thin light edge bleed as pictured below.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Note this is only visible at an extreme angle and is not visible straight on or looking at the phone at a small angle. Also it's only visible on non-black colored background
Is that normal for and LCD screen? should I return it, or don't worry about it?
Thanks!
your chances of finding a perfect panel is basically "zero." if there arent any dead pixels and the backlight bleeding doest affect your viewing experiences then just stick with it. the chances of you getting a more defected one is higher.
you should also go into dial pad and test it with the service menu by inputting
*#*#service#*#*
I believe that is normal.
LitoNi said:
your chances of finding a perfect panel is basically "zero." if there arent any dead pixels and the backlight bleeding doest affect your viewing experiences then just stick with it. the chances of you getting a more defected one is higher.
you should also go into dial pad and test it with the service menu by inputting
*#*#service#*#*
Click to expand...
Click to collapse
I ran a complete diagnostics when I received the phone. Luckily everything passed and got zero sight of dead pixels, stuck pixels or clouding! Its not the first time I have seen this, I had similar problem with my xperia S, Z and Z1. So its seems like its a normal thing
I'll take your advice and stick with it. :good:

Screen Problem?

Hi!
I have a mix my 2s new but I see some spots on the screen are noticeable especially with the color white.
It is normal?
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
This is called backlight bleeding and normal if it's not too much
Flash updates,that's a little bug.
hbbxmjbb said:
Flash updates,that's a little bug.
Click to expand...
Click to collapse
That's not a bug. It's completely normal for screens to have a little bit of background bleeding. Just check your computer monitor in the corners for example
I have that as well, its not a problem once you get accustomed to it. when I first got the phone from aliexpress, I opened a dispute regarding the order as I thought that the screen is faulty. But actually turned out to be a common problem so I just made my peace with it
Hi. I was searching this forum because i just got my mix 2s. Immediately noticed the light grayish discoloration at the lower part of display. I was planning to have it replaced by the store when i posted this issue at the miui forum. 4 replied to my post, all having the same concern. Then this. So i guess its pretty normal.
elsyndy said:
Hi!
I have a mix my 2s new but I see some spots on the screen are noticeable especially with the color white.
It is normal?
Click to expand...
Click to collapse
Hi elsyndy.
What app did you use to test the lcd screen? I cant get one that display the full white screen.
vince_junior said:
Hi elsyndy.
What app did you use to test the lcd screen? I cant get one that display the full white screen.
Click to expand...
Click to collapse
It is a blank image placed in full screen.
Regards

S10e display manufacturing error?

Hi guys
I am really having some trouble loving my S10e. The phone would be great - if it wasn't for the screen. The glass is simply glued on the front and thus sticks out by 0.75mm. The corners are not rounded but quite sharp. When I put the phone to my ear, the sharp end scratches my ear and it feels uncomfortable. On top of that, with the glass being exposed like that, it obviously lead to it cracking within the first 3 weeks (see
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
).
Is this the same for all S10e? I have searched the Internet for any reviews or complaints mentioning this issue, to no avail. I simply can't believe that this is normal (I have never seen a phone with the glass glued on like that).
Cheers,
Will
This sounds like a faulty handset to me. You'll need to see if you can get it replaced under warranty.
Unfortunately as with all Android phones, this will mean sending your current handset off somewhere and waiting up to 2 weeks to have it inspected, repaired or replaced. You'll need to make sure you have a spare handset lying around. This is one of the things I hate about Androids compared to iPhones. Maybe try putting on a case to see if it helps?
If you had an iPhone, you'll have been able to book an appointment and have your iPhone replaced the same day.
Hey Wutang, thanks a lot for your reply! And all along I thought the glass being glued on like that was (a little silly but) normal for the S10e. I have contacted Samsung again, so I guess we will see.

Categories

Resources