hi . i have an Allview x2soul ( a rebranded gionee elife s5.5) and since a week ago i am facing random reboot problems. when i am in recovery (twrp 2.8.6) the device is not rebooting , is working normaly but when it fully boots it is restarting imediatly or after few minutes . i"ve tried flashing another custom rom but no succes , i"ve used battery calibration but without succes. today i"ve flashed the stock rom from gionee s5.5 kk , and as üsual" it rebooted but i"ve seen something strange . the phone was plugged and the charging screen popped up showing low battery (it was the screen from the original rom) after that the battery screen from gionee popped up showing 68 % battery and after that it booted into system . now [email protected] flashed a custom rom ported by me ( pussyfap v4 beast edition mt 6592 ) and the reboots are a bit fewer than the reboots from the gionee rom . any advice ? i don"t think that the battery is dead because in twrp is doing just fine . thanks in advance
Hi,
Try posting your question here:
Android Q&A, Help & Troubleshooting
The experts there may be able to help.
Good luck!
Related
[BHi Everyone,
I was flashing with a new Rom OPPO_Umi_V1.zip and on rebooting it stopped at the UMi motive. I rebooted same again.I then did the unthinkable I flashed another ROM LeWa UMI X1 JB Rom 13.04.02 8F and after reboot nothing but the same. I was running Shuame and using that to recovery, until I removed the usb cable before it was finished ( I was interupted, no excuses).
How can I unbrick this phone?. There dos'ent seem to be an unbricking for this model what will work Please.
Thanks in advance ][/B]
I own a ZTE Blade G 4.1.2 Android device , i recently installed a stock Belgium ROM from the ZTE official site .
I installed it straight from the phone it didnt require CWM , so I installed it straight from settings -> developer settings -> install update from SD Card . The installation went smoothly , i was very satisfied. I then rooted it. And then because i'm very smart of course , i decided that my speakers need a 'boost' so i downloaded an app called Beats Audio Installer . The app installed and then asked for a reboot. It rebooted and it's stuck on the ZTE Logo . From what i've heard i need to have a custom recovery so that i could do anything , which i don't . I can go in to the stock recovery fine , i tried installing the rom again from the stock one but it just says install /sdcard and then shuts off . Im guessing it's some sort of a verification process which this Rom isn't passing . Please Help , i'm a total noob at this.
Hi, thank you for using XDA Assist. You might have to start by bringing your device back to stock. See this, http://forum.xda-developers.com/showthread.php?t=2163493 And if you have further question you can hopefully find then here, http://forum.xda-developers.com/zte-blade
I resolved my issue by downloading the stock firmware that came with the phone from the ZTE website , installed it in the stock recovery , then after installed back to the belgium and installed the clockwork mod . Thank you for your response , even though my device is Zte Blade G , not Zte Blade , but still
I'm glad you got it fixed.
Thread closed.
Hi People!
I hope that somebody can help me out with the problem i have. I flashed an Updated ROM via needrom on my Lenovo A816 but for some reason it turned to be with some kind off error.
The ROM seems to work fine but eats battery like mad. Another thing that happens is, it lags on reboot and does bootloop at least 15 times and then suddenly it boots in.
Can somebody help me out with this problem. I can't install twrp or CWM. I tried adb, but no luck at all. I can get into Lenovo-recovery but fno luck.
I would like to copy ROM from my other Lenovo A816 to this so it can be healthy again. I need instructions please.
someone help me , i flashed a custom rom using cwm . After flashing the rom after few hours i made a data wipe , after that the phone showed the boot logo and then went blank , It didn't went to recovery even . after few hours the battery drained , I wasn't near any pc so that i could flash stock rom now the battery is compeletly drained and my pc won't recognize my device even . someone help me please.......????
phone model :- Micromax nitro 2 e311 , processor :- MTk6592 , non - removable battery.
Luna.99 said:
someone help me , i flashed a custom rom using cwm . After flashing the rom after few hours i made a data wipe , after that the phone showed the boot logo and then went blank , It didn't went to recovery even . after few hours the battery drained , I wasn't near any pc so that i could flash stock rom now the battery is compeletly drained and my pc won't recognize my device even . someone help me please.......????
Click to expand...
Click to collapse
Luna.99 said:
phone model :- Micromax nitro 2 e311 , processor :- MTk6592 , non - removable battery.
Click to expand...
Click to collapse
Greetings,
Please do not create a thread or post more than once. You have already asked in the correct section. Please wait for a response there.
Thread closed.
Good day gurus please help me out with this my infinix x551 16+1 the phone was on xui lollipop before i flashed a cm 13 custom rom, the phone started behaving abnormally, the phone went totally dead not charging not going to recovery just dead.
I tried to Flash the stock rom and it gave me boot error,
Error21002.00 pls help me out
I have used nck, spflashtool, cm2 mtk and miracle box all was to no avail.