I've motorola quench phone, i noticed something weird. on various occasions when I plugin the charger or usb cable connected to computer the phone doesn't pickup the connection. It just doesn't detect the connection. the battery doesn't charge and the charging led doesn't turn on. But when i restart the phone, the phone gets detected or starts charging. I've tried multiple cables and multiple roms (even stock rom). Has any seen this issue with any android phone? Looks like a software issue to me.
Any help is really appreciated.
Related
Today my Triumph seemed to be draining the battery faster than normal, though I was also making a lot more calls than normal. I have a cable plugged into my PC at work which I plugged into my phone but the driver install window didn't pop up like it normally does and my PC's network connection got very slow. I unplugged it and my PC connection was fine again. I left my phone unplugged for the most part after that though I did plug it in once or twice. I don't think it was ever truly recognized by my PC at work today (it has worked before) though I'm not certain.
When I was about to go home I noticed my phone was off. I knew it was low on battery so I assumed that it had turned off due to low battery. It couldn't have been off any more than 30-60 minutes. I didn't think it should have turned off already for low battery yet though.
I plugged it into my car charger and my phone refused to turn on. About 20 minutes later i unplugged my phone and the red charging light was still on. I had to pull the battery. I then turned on my phone and it was working, but low on battery.
About 45 minutes later I drove home with my phone plugged in, but I didn't check to see if the charging light was on. The phone was still on. When I got home I tried plugging in the phone and I noticed that it was not charging. It still isn't. I have tried the following:
Restarting phone
Plug in while it is turned off (charge light comes on but not charging animation, must pull battery for light to go off. phone will not start while plugged in or charge light is on)
Try plugging into computer rather than wall
Try car charger
Swap battery to stock battery (I use an Anker battery rather than the stock. I haven't used my stock battery for a few weeks to a month. It should have been fully charged but only had less than 50%) and try everything again with same results
Right now I have my Anker battery in which was nearly dead (below 10%) plugged into the wall with it off hoping it will charge. My phone is mostly stock other than I rooted it using the b_randon14's method, installed b_randon14's tweak mod, and flashed in the Sprint PRL using a method from howard forums with the 60681 version. I had links but had to remove them due to not previously posting on this forum.
I noticed the usb cable is not solid in the prot on my phone, but it never was and doesn't seem any different. For example I can move the cable back and forth a little bit while plugged in. It remains plugged in when I do this and while the phone is off it knows it is plugged in obviously. Any ideas?
Ok... I left it plugged in while off for an hour then it started working... very odd. Nevermind then I guess, lol.
Saw this thread, was going to suggest that. Your issue seems to be one that happens across all sorts of devices that have rechargeable batteries, even Android phones (and especially $&!t MP3 players that you'll find at K-Mart). I once made the mistake of buying a $30 MP3 player that refused to turn on once its battery dropped to a certain level. Twice. From K-Mart, of course.
Thank goodness for returns.
I am still having issues and it is really frustrating. Sometimes it will charge when on, some times it won't. The only thing I think MIGHT be common between when it does and doesn't work is how much battery is left. I think it might work more often when the battery is closer to a full charge. What I often do is plug in the phone, shut it off, it will charge but charging animation isn't there and I cannot turn it on until the charging animation shows up. I think it only shows up when the phone is fully charge or close to it (I've only ever seen it when it is fully charged).
Unfortunately I don't have a lot of concrete information on this as i haven't had much time to troubleshoot and verify any of my suspicions. I do know that USB Debugging has nothing to do with it and clearing my battery statistics didn't have any affect either. This issue is very frustrating and I believe are all software based, not hardware.
Any ideas or pointers?
Out of curiosity, have tried a different USB cable? I know that you talked about switching chargers, and I couldn't tell if this was just the base unit and you plugged the same cable in or, if it was a completely different charger and cable.
I have a wall charger with a usb cable at my office, a wall charger with a (different) usb cable at my house, and a car charger with its own non detachable usb cable. All have the same issue.
I love my Z3, and I've had no problems with the device, until this morning. I unplugged my charger as usual, and when I connected my phone to my second charger at work, my device didn't charge. I then tried connecting it to my pc, and no luck. Anyone else having trouble with charging their Z3? The weird part about this, is that when I restart my phone, the red LED light comes on for 3 seconds and then disappears while it's connected via charger / computer. Any help would be appreciated
I have the same issue, how did you fix it?
So a problem reared its ugly head a few days ago...
I tried to connect my phone to my PC to transfer files, but the PC wouldn't detect the phone. It wasn't charging when connected to the computer either. I tried different USB cables and different computers - same problem. If I turn the phone off it suddenly charges, which tells me the USB port on the phone is working. I also tried different chargers too.
My device is rooted, so I thought it may be the ROM I'm running. I wiped the device and flashed another ROM, but still the same problem persists.
It seems like a firmware issue to me as it charges when the phone is switched off. I hardly ever use the USB port on my S6 as I usually charge wireless. I tried cleaning any lint and dust out the port too using compressed air and a toothpick - it didn't help.
Does anyone have any idea what the fault may be?
Are You using USB 3.0 port? Cause I had the same problem. Usb 3.0 never recognised my device. Now after I flashed 6.0.1 the problem is gone.
ProtoDeVNan0 said:
Are You using USB 3.0 port? Cause I had the same problem. Usb 3.0 never recognised my device. Now after I flashed 6.0.1 the problem is gone.
Click to expand...
Click to collapse
Tried on USB 3.0, USB 2.0 and a power brick, Mac and PC - all the same result.
Similar Problem
I have similar problem too. My phone is Samsung Galaxy Alpha. Yesterday, I charge my phone using Pineng Powerbank and then i notice that it show the lightning symbol but the battery is not charging but decrease and my phone become too hot. Since I don't bring the charger, I'd try to connect with different USB cable to PC and the problem is still the same. Then I remove the battery for few minute until the phone is cooling down. After switch on the phone again, my phone quickly heating up but the battery is normal. I'd buy new battery for replacement but the problem still occur. My phone also is not charging when in safe mode and only charging when it is turn off. Then I made a factory reset and it's work. Both of my battery is working too. What is actually happening? Does the powerbank is the culprit or virus? Thank you.
The phone one day stopped charging, when i plug the charger it doesn't seem to recognize it, but when it is turned off and i plug it it starts charging but really slow (3 hours= 10%) and if i unplug it afterwards the screen still shows as if it is charging, if i turn the phone on while plugged in the phone says it is charging but again, really slow, if i use the phone while it is "charging" it discharges and when i unplug it, it still shows as if it is charging, NOW if i turn the phone on while unplugged it doesn't recognize the charger, also, i have tried to plug it to the PC but the PC doesn't recognize it either, the PC did play the sound of something being plugged when i entered in boot mode in the phone, i have already flashed another ROM and installed a different kernel, it doesn't seem to work, i have also disassembled the USB port (which is very easy on this phone) and nothing... Do you think it is a hardware problem? or more like a software bug/problem?
Please help, Im kinda new to XDA so sorry if i have problems with the redaction of the problem im having.
I'm also having issues with the port, but it does seem different than yours. For me the connector is just broken. Some cables still work (barely), other don't work anymore at all. Did you try with different cables?
mouse256 said:
I'm also having issues with the port, but it does seem different than yours. For me the connector is just broken. Some cables still work (barely), other don't work anymore at all. Did you try with different cables?
Click to expand...
Click to collapse
i did! even tho, the problem is still bothering...
solution to usb port
steps:-
1. switch off the device
2. charge it with a fast charges or the power charger then
3. unplug that cahrger and use your moto charger and left it untill it become 100% charge
it might take alonger time about 8-9 hrs
4. then switch on your phone
note: after it work properly dont use any other cable other then which comes with the phone
I have a T-Mobile OnePlus 7 Pro that I converted to the international firmware and recently got Android 10. Everything has mostly been good except since the upgrade I've noticed that a lot of the power adapters I have around the house just aren't charging the device. I'll plug my phone in and the battery icon will show a charging symbol, but the lock screen won't show that it's charging. Curiously, I have my phone set to display a clock as a screensaver only when charging, and that will activate when plugged in, so the phone definitely thinks it's charging. Two of the chargers were from my old Pixel 2 XL, and over the weekend I bought a third, brand new charger that initially seemed to work but I woke up this morning and my phone hadn't charged at all. Tried multiple outlets in the house and it's the same story. I have the Warp Charger at my desk at work and haven't had any issues with that.
Has anyone else experienced this?
UserNumberZero said:
I have a T-Mobile OnePlus 7 Pro that I converted to the international firmware and recently got Android 10. Everything has mostly been good except since the upgrade I've noticed that a lot of the power adapters I have around the house just aren't charging the device. I'll plug my phone in and the battery icon will show a charging symbol, but the lock screen won't show that it's charging. Curiously, I have my phone set to display a clock as a screensaver only when charging, and that will activate when plugged in, so the phone definitely thinks it's charging. Two of the chargers were from my old Pixel 2 XL, and over the weekend I bought a third, brand new charger that initially seemed to work but I woke up this morning and my phone hadn't charged at all. Tried multiple outlets in the house and it's the same story. I have the Warp Charger at my desk at work and haven't had any issues with that.
Has anyone else experienced this?
Click to expand...
Click to collapse
I am experiencing this too. As are a few others on the OP Community forums. If you look into the battery settings it will say "plugged in- can't charge" or something like that. With the USB plugged in and rebooting the device it will start charging. Others have said a roll-back to Pie will fix the issue, but other than that no solution yet. I think the issue has been more with alternative cables. Using the stock brick and cable should work still.
I am having the same issue. My MacBook and pixel chargers used to charge my phone but as the person above mentioned now says my phone is plugged in and unable to charge. So it essentially maintains the phone at the same percentage indefinitely.
Using the original OnePlus charger works. I'm assuming this is a bug OnePlus needs to work out with Android 10 as this wasn't the case with Pie.
I'm in the same boat. It's driving me NUTS. The same USB C cables worked just fine on Pie. Now it's almost every single time I plug my phone in it says "Plugged in, but can't charge" or something like that.
Here how I fixed the problem on my Oneplus 7 pro running android 10
Same thing happened to me. It was very annoying, so I test many usb cables. I found out that the issue is with the usb cables not from the charger.
So I enabled developer options, and I went to the debugging section and I enabled USB debugging option. And all the USB cables started working and my phone started charging ?.
I turned off the USB debugging and it's still charging.
Hope this method will work with you guys.
I had assumed it had something to do with Android 10's new features regarding USB security and preventing USB based attacks and exploits, but I figured that Android would show some notification about it being turned on whenever USB was plugged in. At least I know I'm not alone in this, I was scared my phone might have been going bad.