Hi,
Hope this it the correct place to ask this question, if not i can someone please give me a hint where to post.
Have an issue with my Xperia V / lt25i after installing a boot animation with ROM Toolbax Pro, think it was the Xperia Play animation, or one with an animation in the start and ends with a Sony Ericson logo.
When i turn on the phone, the animation runs for a few seconds, then the geen/white Sony E logo appears, and after some seconds the screen dims the light and then it goes black, like when the screen turns of before the phone locks normaly.
Pressing the on/off / lock button turns the screen back on again, and the logo is shown, and after some seconds it goes black again.
Flashed the LT25i_9.1.A.1.140_1268-6904.ftf file downloaded from another thread on this site.
The phone is flashed with Flashtool (v 0.9.10.1 for Windows) and then rooted with Bin4ry (v 26) and worked fine before installing the boot animation.
Have disabled USB Debugging after i rooted the phone, so no luck getting access to it so far.
Is there a way to bypass the boot animation?
Or a way to reset the phone, so the original boot animation will be re-installed and getting access to the phone?
Did try the guide on this site phonetipsandtricks.com to perform factory reset and hard reset, but no luck, the phone just starts up with the same animation and ends with the logo, and then the screen goes black.
Any suggestions ?
Kind regards,
Alex
Maybe there is a way to re-flash ...
Hi ...
Started pressing the screen to see weather or not the boot animation actually just stopped, or it maybe just blocked the screen from the actual startupscreen with the pattern to unlock.
Managed to unlock the phone, still with the SonyE logo on the screen and otherwise a black screen, and pressed the voloume up/down and heard the beep when pressing, getting louder or weaker, so managed to get into the phone in "the blind" sort of say.
Will try to get into the USB Debugging setting from what i remember of the structure of the menu, if i can just get that one enabled, then maybe it will be possible to use Flashtool and re-flash.
Time for a little experiment with fingers on the display.
Kind regards,
Alex
Phone re-flashed and rooted again.
Hi.
Just an update ...
Managed to find the USB Debugging setting and activate it on the black screen and have now re-flashed and rooted the phone and looks like it's working just fine now.
Alex
Related
Hi
the phone always displays smart mobility then it resets over and over again.
I tryed the way expalined on WIKI bot can't get it into boot screen.is there any other way to do this?I tryed a hard reset but it is all the same.
BR
hello
You can enter in boot screen mode only if you press Power and Camera buttons in the same time (but EXACTLY in the same time) with the phone turned off ....I've tried this for 2 days, 'till my wife came with her long nails and managed to press the two buttons in the same time...( maybe it sounds stupid but is true) ...connect the usb cable when you enter in boot loader screen ....and download the ROM image you want from ftp://ftp.xda-developers.com/Uploads/Kaiser/Roms/ and simple run it from windows
For me it works ok.
i tryed ...but still can't get it to enter boot
i am sure the button are pressed at the same time.Any other advice?
BR
UPDATE:
when it resets it enters in boot but just for 1/4 of a second then it goes back to SMART MOBILITY
I just bought an LG V905 tablet used but there is a password on it.
I can't get it to do a factory reset.
I tried holding the volume button ( both up and down ) with the reset button.
when i use the up volume button i get a screen that says "entering lg mdp mode"
and "DO NOT POWER DOWN" downloading now..."
i left it over night like that and it still was at the same screen in the morning.
when i try it with the down volumne it get
"Starting fastboot usb download protocol" anf the LG logo and it sits there.
can anybody tell me how to reset this tablet ?
Thanks In Advance
JP
I'm in the same boat.
I had a force close happen while installing a 3d wallpaper apk that rendered my touch screen insensitive to touch. This virtually bricks my device as I cannot unlock the screen during start up. Everything else works as I can hear notifications and watch it connect to my wifi network.
I've tried flashing stock images for the lg-909 (system.img, bootloader.bin, flashboot.img) and this did not work on my LG-905. It would get stuck in a continuous boot loop in the t-mobile animations.
My LG-905 is a Rogers device so the stock images are now obviously different than the T-Mobile's.
I need fresh images for the LG-905. If anyone has rooted their device using the instructions for the LG-909 they will have one of these back-up images available. I would ask someone help me out by making this available to me. Mine has been corrupted and is unusable.
Other than this, perhaps someone can help me restore my screen sensitivity by some other means as I have access to the file system using ADB, APX and sometimes fastboot (when it works).
I used triangle away after rooting and triangle has gone ... but now no boot screen and no download mode, even with rig.BUT I can still boot into phone. It takes tons longer to load, ... black screen and soft buttons on and off then sound and eventually lock screen appears. Other than that the phone is working!
My question is how to get into download mode and reflash my phone?
Please anyone???
Hello,
I accidentally dropped my Galaxy s6. When i picked it up, the screen was blank.
Fearing the worst i rebooted the phone. The screen works fine when in recovery/download mode, but when the phone boots normally, it doesn't show anything. The odd thing is that the when it boots normally, the phone appears to be ok... i can press the Vol+ and Vol- and get the usual beep I would expect.
In recovery mode the screen is fine. I can see the bright greeny blue glow with white writing etc...
Please can anyone advise on some tech support for this? I can;t see that the screen is broken becuase it works fine when in downlaod.recoivery.
Help me Obi Wan! You're my only hope!
Try flashing stock firmware
SrikarPrayaga said:
Try flashing stock firmware
Click to expand...
Click to collapse
Hello.... thanks for the reply. I flashed stock firmware and I can turn the phone on.... see the samsung logo load and it gets to the first welcome / customise screen and freezes.
its very odd.
I did the factory reset normally on via the setting menus. Then the phone restarted normally and stuck at at the XPERIA screen with changing colors for hours.
Did a force restart and the same thing happens. If I boot holding volume up and power at the first vibration it says 'Your device is corrupt. It can’t be trusted and may not work properly.' and boot into a screen with three dots (apparently a corrupted software).
Xperia Companion wouldn't help as it says "locked screen" when both power off and on.
I tried to fastboot via adb to factory reset again hoping things will get better. But the device is not detected despite installing the driver a million time.
I can't think of any other options. PLEASE HELP
GettAC said:
I did the factory reset normally on via the setting menus. Then the phone restarted normally and stuck at at the XPERIA screen with changing colors for hours.
Did a force restart and the same thing happens. If I boot holding volume up and power at the first vibration it says 'Your device is corrupt. It can’t be trusted and may not work properly.' and boot into a screen with three dots (apparently a corrupted software).
Xperia Companion wouldn't help as it says "locked screen" when both power off and on.
I tried to fastboot via adb to factory reset again hoping things will get better. But the device is not detected despite installing the driver a million time.
I can't think of any other options. PLEASE HELP
Click to expand...
Click to collapse
Clean flash ftf with Flashtool. See this If you don't know