I used triangle away after rooting and triangle has gone ... but now no boot screen and no download mode, even with rig.BUT I can still boot into phone. It takes tons longer to load, ... black screen and soft buttons on and off then sound and eventually lock screen appears. Other than that the phone is working!
My question is how to get into download mode and reflash my phone?
Please anyone???
Related
Well, I am quite certain i have bricked my phone. I was trying to flash CM9 from openrecovery and everything was normal. When the phone rebooted out of OR it stayed on the M logo for quite some time. I figured usually it takes awhile so I let it go. Needless to say, it didn't boot up or do anything, it was stuck. I pulled the battery and tried to put it into recovery mode. at first it looked as if it was going to go into recovery, had the progress bar at the bottom, but then it quickly went blank and the phone rebooted. I tried again. This time it gave me the triangle with the exclamation mark. I tried accessing the recovery option to hard reset and wipe the phone both with and without the SD card by pressing Volume up + Gallery key down + camera shutter. It did nothing. I have tried to access the bootloader, but to my horror, the phone will not go into bootloader mode for me to flash with RSD! No matter what button combination I try the phone just stays on the M logo, it will not go into bootloader mode. This is both with and without the SD card inserted. Battery is/should be 90-100%.
Any suggestions on what I can do at this point? Or is all hope lost? It is a Motorola XT720 (not Motoroi) Singapore model.
I forgot to also mention, when the M logo is on screen, pressing the gallery button turns on and off the flashlight (red light)
Hi,
Hope this it the correct place to ask this question, if not i can someone please give me a hint where to post.
Have an issue with my Xperia V / lt25i after installing a boot animation with ROM Toolbax Pro, think it was the Xperia Play animation, or one with an animation in the start and ends with a Sony Ericson logo.
When i turn on the phone, the animation runs for a few seconds, then the geen/white Sony E logo appears, and after some seconds the screen dims the light and then it goes black, like when the screen turns of before the phone locks normaly.
Pressing the on/off / lock button turns the screen back on again, and the logo is shown, and after some seconds it goes black again.
Flashed the LT25i_9.1.A.1.140_1268-6904.ftf file downloaded from another thread on this site.
The phone is flashed with Flashtool (v 0.9.10.1 for Windows) and then rooted with Bin4ry (v 26) and worked fine before installing the boot animation.
Have disabled USB Debugging after i rooted the phone, so no luck getting access to it so far.
Is there a way to bypass the boot animation?
Or a way to reset the phone, so the original boot animation will be re-installed and getting access to the phone?
Did try the guide on this site phonetipsandtricks.com to perform factory reset and hard reset, but no luck, the phone just starts up with the same animation and ends with the logo, and then the screen goes black.
Any suggestions ?
Kind regards,
Alex
Maybe there is a way to re-flash ...
Hi ...
Started pressing the screen to see weather or not the boot animation actually just stopped, or it maybe just blocked the screen from the actual startupscreen with the pattern to unlock.
Managed to unlock the phone, still with the SonyE logo on the screen and otherwise a black screen, and pressed the voloume up/down and heard the beep when pressing, getting louder or weaker, so managed to get into the phone in "the blind" sort of say.
Will try to get into the USB Debugging setting from what i remember of the structure of the menu, if i can just get that one enabled, then maybe it will be possible to use Flashtool and re-flash.
Time for a little experiment with fingers on the display.
Kind regards,
Alex
Phone re-flashed and rooted again.
Hi.
Just an update ...
Managed to find the USB Debugging setting and activate it on the black screen and have now re-flashed and rooted the phone and looks like it's working just fine now.
Alex
Nothing was done to the phone. It's all stock and bootloader is locked.
Every time I go into the bootloader no options appear, but If I use Nexus Root Toolkit it gives me the options. But when I use it reboots the phone and gets stuck and when I remove the battery and Check to see if it save it, it still lock.
When I try Recovery mode a little android robot pops up and quickly takes me to a blank screen. The keys like the home, back those light up.
I try to flash it but since bootloader is locked everything fails.
Hello,
I accidentally dropped my Galaxy s6. When i picked it up, the screen was blank.
Fearing the worst i rebooted the phone. The screen works fine when in recovery/download mode, but when the phone boots normally, it doesn't show anything. The odd thing is that the when it boots normally, the phone appears to be ok... i can press the Vol+ and Vol- and get the usual beep I would expect.
In recovery mode the screen is fine. I can see the bright greeny blue glow with white writing etc...
Please can anyone advise on some tech support for this? I can;t see that the screen is broken becuase it works fine when in downlaod.recoivery.
Help me Obi Wan! You're my only hope!
Try flashing stock firmware
SrikarPrayaga said:
Try flashing stock firmware
Click to expand...
Click to collapse
Hello.... thanks for the reply. I flashed stock firmware and I can turn the phone on.... see the samsung logo load and it gets to the first welcome / customise screen and freezes.
its very odd.
Hey my cell phone suddenly showed me a black screen and he was just lying on the table. It responds to pressing the screen but does not show after booting.
I have already reset the firmware with Odin3, but that did not help either.
The phone was not rooted
I can still get into the download and recovery mode