Hello, I made a live Ubuntu. Did everything as it was written. The process started and stopped at writing 'zip'.. and didn't move any further. I have a 16gb micro sd card inside. What could be the problem? Should I use the stock sd that came with the phone? I read about changing the flash mode by pressing t for toggle...
I unplugged and restarted the phone. Now it is ok. I have a question? What could happen to the phone if the process is interrupted.
Also, how long should the process normally take? Thank you very much.
during the flash rom, unplugged it, I think that will not boot up properly, I'm sure ..
the whole process takes about 3 to 5 minutes, in part because it depends on the sdcard speed, as well as the set of rom initialization.
I just started the Ace kit
I am not doing flashing of rom yet... just trying to to do one step process using the kit.
HTC Desire HD
I have Android 2.3.3
someone help
with Sense 2.1 and software number 2.50.110.5. Did someone rooted this phone successfully? Should I use the stock 8gb card instead of new 16 gb?
How can I back up my current rom in case something goes wrong?
I would like to know the same, if someone with soft 2.50 managed to root it without downgrading?
Related
Hi, I've been using my unbranded HTC Desire for a few months now, did the OTA update to Android 2.2 about a month ago. About 5 days ago I got a notification that there was an update available, I started the installation, got an error that it could not back up my data and acknowledged that but to my surprise it continued to perform the installation. Now the phone reboots about every 2 minutes, the status bar shows no connection even when I'm surfing the web, checking e-mail or answering a call. After kicking it back to factory defaults at the advice of HTC I had no change in conditions. ATT naturally said an HTC what? Flash a ROM, what’s a ROM (HTC recommended that move as well). So I figured well I'll flash the ROM myself, only problem with that idea is I can't create a gold card because the device does not recognize the SD card. I put the SD card in a Samsung GalaxyS and it reads it fine. I used several WWE bravo trying to flash it across the usb but it failed stating the ROM was not correct for my hardware.
Any help finding a ROM I can flash across a USB or any other ideas you may have would be of great help.
You could downgrade HBOOT 0.92 to 0.80 and maybe install an older update rom to see if it changes your situation, it might work!
Hi I Wanted to flash my Evo so that I would have more room for my apps. The 427mb was not cutting it. I was always getting the low memory error. So I used the Firerats http://forum.xda-developers.com/showthread.php?t=855424 way Of flashing my EVO. The problem its that my phone will not restart to the main User Interface. My phone is essentially a brick at the moment. Any Help would be greatly appreciated. thanks
which hboot are you on? I used the bottom two links to root a couple evos and had no problems with either one. Just make sure you use the right guide for your respective hboot.
http://forum.xda-developers.com/showthread.php?t=1218386
http://forum.xda-developers.com/showthread.php?t=1473373
HI Thanks for the reply yes I used the first link you posted to root my phone. the 1218386 It worked fine my phone was rooted. I was having an issue with the memory availability I had 73 mb left and the low memory message. I wanted to reallocate the rom and cashe MB that is were I ran into the phone not booting to the UI.
Hey I have just downloaded a rom from this thread
http://forum.xda-developers.com/showthread.php?t=1482728
I have followed the instructions by putting the msd5 or w/e its called and the leeDroid file in the SD card, the device is rooted, its a DHD currently installed with CM7 mod on it but each time i try to install the new rom it just boots back up as CM7, im not sure what i'm doing wrong as i followed step by step ...
Also the whole process usually takes around 10 minutes from memory but this doesnt even take 30 seconds .. Can someone please help me to complete this process or even to revert it back to stock as the wifi gives a signal but wont connect properly ? Thanks
I went to restart my Xoom Wifi a couple days ago because it wasn't detecting my local wifi signal and upon doing so it got stuck on the Motorola Dual Core screen.
I was able to access fastboot and send commands to it but could not get it to start up past the dual core screen.
I erased everything on my xoom, reset it to factory and still nothing. I downloaded RSD Lite and flashed what I thought was the US stock ROM and nothing happened...until I pulled out my SD card.
Now it boots all the way and has not issues running. If I put the SD card back in, problems start up again. What in the hell caused my SD card to do this?
So I'm also stuck back on Honeycomb 3.2 and it says my Xoom is up to date?
I guess this is as good a time as any to root and put a different ROM on it.
Has anyone had these issues? If I wasn't clear, this was a stock Xoom Wifi I hadn't done anything to it. I'd been using the SD card for about a month and then this happened.
I think it is a good time for you to root it and flash ICS 4.0.4 custom Rom fro EOS on your wifi xoom.
For the SD Card issue, try to format it first or try another one just to test.
To root and flash ICS ROM, the best out there, use this:
http://forum.xda-developers.com/showthread.php?t=1717402
Good Luck...
+1
10 char.
While having root access and being rom'd might be a way to go... You should also try formatting your sd card. Perhaps it is corrupted and that is messing with your xoom. Honeycomb doesn't write to the sdcard without root in 3.2 and doesn't even look at the sdcard in 3.0, which is probably why honeycomb is working for you.
Hello,
I am very new to all of this and any help would be appreciated. I just rooted and unlocked the bootloader on my verizon galaxy s3 for the first time without any issues (its my second android phone, but my first time rooting). for my first custom ROM i downloaded and flashed CM10.0.0-d2vzw and did everything through ROM mananger. everything went through cleanly, but since it finished i have had a message in my drawer that says the SD card is damaged and that i should try to reformat it. i have the card backed up on my desktop, so if i need to do that its okay, but i was wondering if this is something that happens when you flash new ROMs and if there is something i should have done differently through the process to avoid this and if there is anything i can do to fix it now. Thanks.