[Q & Help] Hi There, I was trying to flash my Rogers Galaxy S II LTE back to the Rogers ROM , but during the procedure the phone got disconnected and went OFF. I can't turn it on anymore and I am lost. Any help please??
P.S.: I am a n00b and this is my first android experience.
There is a reason it says do not turn off target when its flashing. What did u do to disconnect it when it was flashing?
So u cant get into download mode either? All you can do is try a jig if it does not work your out of luck.
Although I put it in a safe place while it was flashing, my "evil" nephew got to it, disconnected it and removed the battery :-(((
USB jig is your only hope
Sent from my SAMSUNG-SGH-I777 using xda premium
You have an expensive paperweight now
renegadefunk said:
You have an expensive paperweight now
Click to expand...
Click to collapse
Do you think that usb jig won't do it?
It is deffinately worth a shot. Before youhave to pay for a new phone
Sounds like your nephew may have an imminent appointment out in the woodshed.
Related
my samsung vibarant is in same problem bricked samsung vibrant
somebody helps me??? (youtube.com/watch?v=jfkPHQbBcJ4
pham.0763 said:
my samsung vibarant is in same problem bricked samsung vibrant
somebody helps me??? (youtube.com/watch?v=jfkPHQbBcJ4
Click to expand...
Click to collapse
If your having the same problem then most likely your hard bricked. This is not the Samsung Vibrant section. This is the Galaxy S 4G section. If you have insurance, just get a replacement.
i dont have insurance, hic, so...
So you have the regular Vibrant correct? So you tried taking out the battery, SIM card and memory card and get into download mode?
my phone is samsung galaxy s 4G, i dont have insurance, , i buy it on ebay 400usd , i tried turn it into downloading mode, but it didnt work.
pham.0763 said:
my phone is samsung galaxy s 4G, i dont have insurance, , i buy it on ebay 400usd , i tried turn it into downloading mode, but it didnt work.
Click to expand...
Click to collapse
Ok. Do you get any lights at all or it doesn't have anything on the screen at all if the battery is in or plugged in the USB? What were you doing before it was bricked?
it doesn't have anything on the screen, it is black screen, i flashed this rom multiupload.com/GZT6ZYFX46 by odin, and then my fone doesn't work.
pham.0763 said:
it doesn't have anything on the screen, it is black screen, i flashed this rom multiupload.com/GZT6ZYFX46 by odin, and then my fone doesn't work.
Click to expand...
Click to collapse
What made you decide to use a Vibrant ROM? Did you happen to use the Vibrant PIT file too? Or did you just use the TAR file only when you used Odin?
well i bricked my phone to what u can try is buying a unbrick jig from ebay or making one to put urself into download mode then once in download mode use odin and put T959VKB5 as your tar folder (no pit) then run it
Vietxjdm said:
well i bricked my phone to what u can try is buying a unbrick jig from ebay or making one to put urself into download mode then once in download mode use odin and put T959VKB5 as your tar folder (no pit) then run it
Click to expand...
Click to collapse
I would have recommended that if he was able to get the phone to turn on but it doesn't look like it. I've read many threads saying jig's won't work unless the phone powers on at least or the screen has some kind of back light at least.
thanks, i'm buying jig, i'm trying with my fone, i will post result early.
Hi ! by mistake and installed a bootloader incompatible with my galaxy S, now will not start, no download mode, no recovery .... : (
Please help me
if your phone can't go into download mode, the only option is the USB Jig Method. This video will help you http://tinyurl.com/6wb9c5l
Click Thanks if my post helped you
But this work 100% ??, the error is when i flashing other bootloader...
should work in this case ??
PS.: the link don't work
try this link http://www.youtube.com/watch?v=Rdn5GoRjhn0 ...whatever you have done that caused your phone to be bricked, the only solution is the jig method or you could go to any service center...but if you can still go to download mode, then there is no problem...
Click Thanks if my post helped you
Usb jig works 100% . Tested on galaxy s , s2 , ace, nexus s
Sent from my GT-I9000 using xda premium
you can also view this link http://code.google.com/p/android-roms/wiki/Unbrick and read other methods of unbricking your phone.
Used the mutilated USB cable jig and worked. You should try that.
Sent from my GT-I9000 using XDA Premium App
Umm... guys... the thread was moved here.
will this work on galaxy sl tooo..
and after getting an usb jig what to do
Finally, the last week i send the phone to SAT...
When i go to the shop to take the phone, the shopgirl says I can not fix ...
When i arrives to my home... i try "Volume down + Home + Turn on, and the download mode appears !!!
Hi everybody, im new here.. so i'll go to the point.. i had recently buy a samsung galaxy s2 tmobile t989 version, im from south america, so i need it to root the phone in order to unlock it for all the operators.. so i followed this tutorial step by step http: //galaxys2root.com /galaxy-s2-root/ how-to-root-t-mobile-galaxy-s2-sgh-t989/ (just fill the spaces)
Now.. once the the odin finished.. the cellphone got in a boot loop, i couldn't even go to the recovery mode.. because in the recovery mode also reboots.. and now.. the phone wont turn on.. and when i connect to the pc via usb.. y get that noise.. its like two fast tinun (dont know how to explain) and now i dont know what to do because the only way i think this could be fixed is via JTAG but no one does that here.. only in the USA.. anybody can tell me why that tutorial didnt work and what can i do now?
Post this in the phones forums and you will get a lot more help.
Sent from my SGH-T989 using xda premium
its not a battery issue cuz i have another galaxy s2, the international version.. and i managed to put the battery from the t989 in the international and charged it.. still.. the phone doesnt turn on.. so i cant do any odin stuff..
Sansung GALAXY S2 T989 Bricked
Hey. Some nimwit knocked my laptop cord out of the wall while my battery was low and scewed up the rooting process when my laptop died. I have a sprint galaxy s2 T989. My screen now says "Firmware upgrade encountered an issue. Please select recovery mode in Kies & try again" It also displays a yellow triangle with an exclamation mark. I've tried the Kies but Kiew isn't connecting to phone. Also odin is reading phone when connected. I DL a stock rom now for ICS but I have a feeling this wont work. I just bought this phone. Please help me.
Greetings to all senior member.
My Samsung Galaxt Tab 7.0 Plus went dead this morning. I cant turn it on, cant charge.. Nothing happen.
Previously i flash my GT P6200 with Austrian firm. Everything works fine except for the "insufficient memory availabl"
This morning i decided to flash my GT P6200 to P6200DXLPB, it went fine until i was about to root the phone back, when i flashed the CWM.zip it works just fine but when i try to flash the root.zip it went stuck and turned off.
I tried to turn it on again,but not luck. try to plug a charger, no respon.
I cant get into Recovery and Download mode.
But my GT P6200 generated a lil bit heat. Even in its dead state.
Please help me with some ideas on how to revive back my GT P6200.
Sending my GT P6200 to Samsung is my last resort.
*Sorry for my bad english*
Regards,
Bani from Malaysia
lowcothiradee said:
Greetings to all senior member.
My Samsung Galaxt Tab 7.0 Plus went dead this morning. I cant turn it on, cant charge.. Nothing happen.
Previously i flash my GT P6200 with Austrian firm. Everything works fine except for the "insufficient memory availabl"
This morning i decided to flash my GT P6200 to P6200DXLPB, it went fine until i was about to root the phone back, when i flashed the CWM.zip it works just fine but when i try to flash the root.zip it went stuck and turned off.
I tried to turn it on again,but not luck. try to plug a charger, no respon.
I cant get into Recovery and Download mode.
But my GT P6200 generated a lil bit heat. Even in its dead state.
Please help me with some ideas on how to revive back my GT P6200.
Sending my GT P6200 to Samsung is my last resort.
*Sorry for my bad english*
Regards,
Bani from Malaysia
Click to expand...
Click to collapse
Jtag- http://forum.gsmhosting.com/vbb/f47...galaxy-tab-7-0-plus-repair-dead-boot-1484728/
i have to buy the jtag tools? or its just a software which i can download?
enlighten please.
lowcothiradee said:
i have to buy the jtag tools? or its just a software which i can download?
enlighten please.
Click to expand...
Click to collapse
Please anyone help me with this issue.
Is my device bricked?
lowcothiradee said:
Please anyone help me with this issue.
Is my device bricked?
Click to expand...
Click to collapse
If you can't enter in the recovery and Download mode bricked device , solution tool jtag http://www.youtube.com/watch?v=Ami4TQH3cmc
devid801 said:
If you can't enter in the recovery and Download mode bricked device , solution tool jtag
nevermind then, i send my device to Samsung this evening. BTW thanks.
Click to expand...
Click to collapse
is your p6200 working now?
bani,same me too..P6200DXLPB,first stock ics for malaysia,thailand&indonesia..easy make hard brick...
pojeng said:
bani,same me too..P6200DXLPB,first stock ics for malaysia,thailand&indonesia..easy make hard brick...
Click to expand...
Click to collapse
Easy make hard brick bcoz u wipe data n cache through recovery..thats y..now u need to solve it ur self or, send it to centre bcoz u need to change ur motherboard
Ps: i read ur previous threat..
Sent from my GT-P6200 using XDA Premium HD app
Member90 said:
Easy make hard brick bcoz u wipe data n cache through recovery..thats y..now u need to solve it ur self or, send it to centre bcoz u need to change ur motherboard
Ps: i read ur previous threat..
Sent from my GT-P6200 using XDA Premium HD app
Click to expand...
Click to collapse
my gt-p6200 totally brick now.otg JTAG servise cant write or read internal memory(emmc)..its yes,change motherboard
is the proplem gone
lowcothiradee said:
devid801 said:
If you can't enter in the recovery and Download mode bricked device , solution tool jtag
nevermind then, i send my device to Samsung this evening. BTW thanks.
Click to expand...
Click to collapse
how much does it cost u to repair it....
-samsung user from malaysia-
Click to expand...
Click to collapse
Hi everyone! First i want to apologize in advance if i made a mistake or something. Not too sure where to post! Kinda new to forums and forum rules...I need help seriously! For almost a year now, my Galaxy S3 isn't recognizable by any PC, Mac or whatever. Mavericks, Yosemite, Windows 7 or 8, nothing recognizes it. Downloaded the latest Samsung USB drivers, Kies and still didn't work. Went to a shop and they fixed the mini usb thingy where you plug it. They said it was partially unsolded so the data couldn't get through...Don't know if it's true. Got it recognized by my mac the 1st time. Thought it was finally recognized until the 2nd time i plugged it in. Usb device not recognized, again. 70$ thrown out the window. Anyways. Not too long ago, while still unrecognizable, the phone started shutting down by itself every 2 hours or so so i kinda got fed up and decided to wipe it to factory settings. Tried it through Kies instead of using the vol up/home button/power. Was never able to do so. Kies was doing fine until it told me that i needed to go in emergency recovery mode cause something had went wrong. Tried to go on recovery mode but no can do. Odin mode shows up all the time even though i'm doing the recovery mode manipulation. Got fed up of that too so i decided to flash to a stock firmware through Odin. Forgot to mention: the download mode works...well looks like it. Odin didn't recognize my phone too. Actually, i got it see the phone like 5 times over 100 trys and everytime (the 5 times) it started the flashing process, it would fail right at beginning of the process. Like 3 seconds later. Tried all kinds of pc's, usb cables, etc. My phone was rooted and i lost the root by updating. Was that a mistake? I don't know since the thing was functionning very well. The whole point: now i'm stuck with a phone that goes straight in Odin mode! The same tech from the same shop kept my phone for a few days to check it out and still nothing! Even the guy from the store doesn't know what to do. He spoke to me about flashing the phone's CMOS but he looked soooo unsure...And he was asking 50$ to do so....so no thank you. What can i do people? What is wrong with my phone? Wish i knew more about those things so i wouldn't have to cry for help! Don't know if i explained it well since english is not my natural language...Will answer your questions if you guys wanna know more...Seriously, heeeeeeeeeeelp! Thanks in advance people!
Hi there,
You'd be best served asking for help from the experts who own your device, here but first register an account on XDA :
AT&T Galaxy S III Q&A, Help & Troubleshooting
Also please read this thread:
Problem connecting Galaxy S3 with PC
[HOW TO GUIDE] How To Unbrick AT&T I747 and I747M
Good luck