[q] g tablet won't power on after installing clocworkmode - G Tablet General

Help needed. After installing clockwork mode 0.8, i did reboot viewsonic g tablet , but tablet won't power on and stay on. It gets to the point where you see viewsonic logo for few seconds and then comes g-tablet logo for few seconds and that goes forever. Basically it powers on and off by itself. I can still go into clockwork mode menu when i press +volume button and power, but don't know what to do after that. If i connect tablet to pc nothing happens. Any help will be much appreciated. Thank you.

Under advance in clockwork mod is an option to mount USB. Do this to connect to PC and drop rom onto your internal SD card. Load new rom with clockwork and don't forget to wipe data/cash/davlic before restarting gtab.
Sent from my Chromatic Magic using XDA Premium App

Related

[Q] Problem Installing Clockwordmod

I just got my g tab today and tried to install clockwork mod following the guide. device detected the recovery key and went into the install screen but immediately rebooted and now when i try to install it doesnt even detect the recovery key. the viewsonic splash screen comes up when i hold power and vol + buttons and then shuts off immediately, but if i try a normal powerup i get the stock UI. I know this is a stupid question but i am new to this so some help would be appreciated.
thanks

[Q] Triumph stuck at moto logo, cant get into clockworkmod

Ok so today my triumph stopped responding so i restarted it (took out the battery). then rebooted. upon reboot phone shuts down and now will hang at the motorola logo for about 10 min before boots but will shut back down due to the battery being dead(but had full charge when this started). Dont know what happened. So i try to get into clockworkmod to flash backup. cant get into it. the only thing i can do is get to the recovery.img file(pressing power+volume down). Other than that nothing.
also tried to boot with power pluged in. it stayed on but would not respond to any touches or button press except the lock button.
I have cwm 5.0.2.6 installed and tickerguy's cm7.
never had this problem till today. Any help would be appreciated.
a new development has occurred. now when i try to access recovery, the phone will just vibrate without stopping.
and i believe its stuck in a boot loop but without recovery i dont know anyway to exit the loop.
Are you able to get into download mode (power off then simultaneously press power button & vol- (should show polling))
Sent from my Triumph using xda premium
Yes i am able to get to download mode
Well after some tinkering (replacing the recovery image, assuming something corrupted it) i can now get to recovery, still takes 10 min to load it though. But i am unable to do anything in recovery because i have to press the menu button to confirm selection but the buttons wont respond. Some help would be appreciated.

Cannot boot into recovery

i have a Galaxy Tab 2 7.0 p3113.
i used heimdall to flash CWM into the tablet.
after what seemed like a succesful flash, my tablet rebooted. but for some reason, it would only go as far as showing the galaxy tab logo. it seems stuck there. i could not turn the unit off. i would hold the power button to force shutdown, but it always starts right back up. it seemed like i could only shut it down if it was connected to my mac while holding down the power button. i can however, boot into download mode.
after consulting google, it seems like the appropriate step was to restore the unit to stock. problem is, i can't seem to boot into recovery. i'm being told by the internet that to boot into recovery, i need to hold [power] and [volume down] until it turns on and then release [power] but keep on holding [volume down] and CWM will load. but nothing happens.
i know this is a total noob post, but i've been scouring the web for two days. i'm at my wits end. any help would be greatly appreciated.
I think recovery mode accessed via volume up+power if you could not so use download mode to flash stock or so to return to normal operation
Sent from my GT-I9100 using xda app-developers app
I press the power and UP ( button next to the power button) I normally hold BOTH buttons down at once and let the boot cycle process twice just to make sure i am going into recovery .....so i see the white samsung text twice i mean. It may take around 10 seconds to complete the process. Then release BOTH keys at once.
The battery needs a good charge for it to work.. Try charging over night before you try it via the mains supply.
Holding the power button and down will bring you into download mode and thats what you use for an odin/heimdall flash.
Hope that works for you
Let us know how you get on .....
Thanks. The battery of the gtab2 drained overnight, so i've got it charging back up now. Will definitely post my results when i have something.
Thank you guys. I'm able to boot into recovery now.
But unfortunately, i still need a little guidance on my original problem. And that problem being that my gtab2 will not startup. After rebooting, it gets stuck on the logo screen. It also plays a startup audio clip. But after that, it just displays the startup logo screen. It does not go into the animation screen and start.
I should also mention that when i plug my gtab2 into my computer, no drives show up.
My question now is, if i were to select [wipe data/factory reset] in CWM, would this restore my gtab2 to it's original factory state? Or would I need to flash a ROM for this? And if i need to flash a ROM, could i place a ROM on a microsd card and flash from there?
*********UPDATE*************
Everything is fine (so far).
I went poking around CWM and realized that I had put a cyanogenmod 9 update.zip in the root of the internal sd card before all this happened. So i went back to cyanogenmods wiki on how to install it on my gtab2 and followed the rest of the instructions on flashing it and VOILA!! I have my gtab2 back.
you should use ODIN instead CWM.
CWM is not designed specifically for Gtab2.

[Q] Can anyone help me a bricked Samsung Galaxy Exhibit 2 4G?

Guys, I need help on my Samsung Galaxy Exhibit 2 4G. I had tried to do a factory reset but it looked like it got stuck after several minutes. I turned it off and after that, it i stuck on start-up. The Samsung logo would appear, eventually the green android mascot would appear (where it would look like it is rocketing up) the the samsung logo would appear again, then the green android mascot would appear again, and that would loop over and over again. This happens every time I turn on the phone.
Hooking the phone to the PC will try to install driver, (I have installed a lot of drivers) but it will fail and say unidentified device and the phone drive does not come up on the computer so I can not copy any file to the phone or card.
When I try to go into download mode (Power and Volume down combo) and attach Odin, it will recognize the phone but it gets stuck on Setup connection.
When I try to hold Power + Vol up and vol down combo, it will say ramdump mode cause: force upload
When I do manage to get into CWM with Power and Vol up combo, anything I choose (Romwipe, wipe data, etc) will just get stuck on the clockwork logo (hat and wheel like thing).
I would be very grateful if anyone could help me get my phone back to working.
WRONG FOTUM
Sent from my SGH-T959V using xda app-developers app
^^forum^^

Brick note 10.1 no CWM or Odin

Hi guys, today I was trying to install the new Android Revolution HD v8 and the f***** aroma fails....
So, my tab is stuck on a bootloop on samsung logo, the fact is that if I press vol + or - nothing appear...neither CWM recovery, neither dowload mode. It just reboot continually when I press the power button.
My pc makes a sound when I plug it into the usb port, but I have no idea what I have to do...someone can help me?
Thanks
eddy2302 said:
Hi guys, today I was trying to install the new Android Revolution HD v8 and the f***** aroma fails....
So, my tab is stuck on a bootloop on samsung logo, the fact is that if I press vol + or - nothing appear...neither CWM recovery, neither dowload mode. It just reboot continually when I press the power button.
My pc makes a sound when I plug it into the usb port, but I have no idea what I have to do...someone can help me?
Thanks
Click to expand...
Click to collapse
Try turning it off by long pressing the power button untill the screen goes off .... then follow the steps to open CWM ... press the power and volume up until Samsung Galaxy Note 10.1 logo appears then stop pressing the power and keep pressing vol up and if it fails try with another turn off ... because trying to open CWM when the samsung logo is there wont work
Try to install again but if it fails again I'd try to re-download the rom... Hope you have an sd card reader cos the note WON'T be recognised by the PC....
You could also try to do a factory reset, format system, data and sd card, remove your external card before doing this so you don't accidentally loose everything there...
ok guys, fortunatly my note woke up and decided to enter in download mode...i flash the phil touch recovery and upgraded to the v8!
Many thanks to @wolvie80 who helped me :laugh:
Cheers and thanks to the other guys who wrote there

Categories

Resources