Ok so today my triumph stopped responding so i restarted it (took out the battery). then rebooted. upon reboot phone shuts down and now will hang at the motorola logo for about 10 min before boots but will shut back down due to the battery being dead(but had full charge when this started). Dont know what happened. So i try to get into clockworkmod to flash backup. cant get into it. the only thing i can do is get to the recovery.img file(pressing power+volume down). Other than that nothing.
also tried to boot with power pluged in. it stayed on but would not respond to any touches or button press except the lock button.
I have cwm 5.0.2.6 installed and tickerguy's cm7.
never had this problem till today. Any help would be appreciated.
a new development has occurred. now when i try to access recovery, the phone will just vibrate without stopping.
and i believe its stuck in a boot loop but without recovery i dont know anyway to exit the loop.
Are you able to get into download mode (power off then simultaneously press power button & vol- (should show polling))
Sent from my Triumph using xda premium
Yes i am able to get to download mode
Well after some tinkering (replacing the recovery image, assuming something corrupted it) i can now get to recovery, still takes 10 min to load it though. But i am unable to do anything in recovery because i have to press the menu button to confirm selection but the buttons wont respond. Some help would be appreciated.
Related
i have a Galaxy Tab 2 7.0 p3113.
i used heimdall to flash CWM into the tablet.
after what seemed like a succesful flash, my tablet rebooted. but for some reason, it would only go as far as showing the galaxy tab logo. it seems stuck there. i could not turn the unit off. i would hold the power button to force shutdown, but it always starts right back up. it seemed like i could only shut it down if it was connected to my mac while holding down the power button. i can however, boot into download mode.
after consulting google, it seems like the appropriate step was to restore the unit to stock. problem is, i can't seem to boot into recovery. i'm being told by the internet that to boot into recovery, i need to hold [power] and [volume down] until it turns on and then release [power] but keep on holding [volume down] and CWM will load. but nothing happens.
i know this is a total noob post, but i've been scouring the web for two days. i'm at my wits end. any help would be greatly appreciated.
I think recovery mode accessed via volume up+power if you could not so use download mode to flash stock or so to return to normal operation
Sent from my GT-I9100 using xda app-developers app
I press the power and UP ( button next to the power button) I normally hold BOTH buttons down at once and let the boot cycle process twice just to make sure i am going into recovery .....so i see the white samsung text twice i mean. It may take around 10 seconds to complete the process. Then release BOTH keys at once.
The battery needs a good charge for it to work.. Try charging over night before you try it via the mains supply.
Holding the power button and down will bring you into download mode and thats what you use for an odin/heimdall flash.
Hope that works for you
Let us know how you get on .....
Thanks. The battery of the gtab2 drained overnight, so i've got it charging back up now. Will definitely post my results when i have something.
Thank you guys. I'm able to boot into recovery now.
But unfortunately, i still need a little guidance on my original problem. And that problem being that my gtab2 will not startup. After rebooting, it gets stuck on the logo screen. It also plays a startup audio clip. But after that, it just displays the startup logo screen. It does not go into the animation screen and start.
I should also mention that when i plug my gtab2 into my computer, no drives show up.
My question now is, if i were to select [wipe data/factory reset] in CWM, would this restore my gtab2 to it's original factory state? Or would I need to flash a ROM for this? And if i need to flash a ROM, could i place a ROM on a microsd card and flash from there?
*********UPDATE*************
Everything is fine (so far).
I went poking around CWM and realized that I had put a cyanogenmod 9 update.zip in the root of the internal sd card before all this happened. So i went back to cyanogenmods wiki on how to install it on my gtab2 and followed the rest of the instructions on flashing it and VOILA!! I have my gtab2 back.
you should use ODIN instead CWM.
CWM is not designed specifically for Gtab2.
Hello to everyone. I have a problem. I rebooted my ZTE-Skate and it stuck on boot animation.. I waited for about 15 min and noting happened. I took the battery out and put it in again but same situation. I booted in CWM recovery (Volume down+power button ) and i cant navigate in it. I can't go up or down and i can't chose anything. And also it makes clicking sound when i try to turn it on. I don't think its bricked because it passes black screen with android and it stuck on boot animation. If someone has solution to this problem please reply. Thanks in forward.
My power button decides to become unresponsive.
So I tried to unroot my phone and bring it back to a stock image and when I go into download mode, 2 seconds later, it turns off. :crying:
I try another method by using mobile odin to see if that helps. Tried to flash the stock image and it tried to reboot to Recovery mode. Nothing. It stays in a black screen after the samsung galaxy s3 logo. After pulling the battery, it tries to reboot to recovery again and still, a black screen. The only way to stop it from booting to recovery is to set it back to download mode. I hold the power button and it restarts. ( The power button seems to work when I try to go to recovery, download, power on.
I am running Cleanrom 6.0 R2.
I am in deep [email protected]#!. I do not want to go to verizon and notice my phone is rooted and I can't fix it without a huge bill.
Please help if possible
Unusual bootloop - can't access recovery OR fastboot but loops on "optimzing apps"
I had my US version OpO 64GB working with CM12 for quite a while, rooted and bootloader unlocked with TWRP (possibly 2.8.6) installed, then some months ago I tried upgrading to CM12.1 through CM updater. This failed miserably - The phone started bootlooping on "Optimizing apps n of N" - as soon as it finished optimizing apps, the phone would reboot and start optimizing again. Booting to safe-mode (Power + VolUpDown) also fails in the same way (though optimizing fewer apps).
I tried rebooting to recovery mode holding Power + VolDown but it just gives a quick buzz (vibration motor) at the "1+" screen and reboots. The same thing happens when I try to boot to fastboot mode with Power + VolUp. So I'm completely stuck. All the guides show being able to boot either to fastboot or recovery (soft-brick) or else the screen being completely black/unresponsive (hard-brick). My phone is neither of these!
I got frustrated enough that I've let it sit on the shelf for the past 6 months, but now I'd like to fix this. All help appreciated.
---danq989
Did you try clearing the cache and doing a factory reset ?
SpectreFang said:
Did you try clearing the cache and doing a factory reset ?
Click to expand...
Click to collapse
That's impossible for me to do since I can't get to launcher or recovery.
No acess to recovery?? Then better take it to service center... Atleast can u boot to fastboot mode or adb accesible then use oneplus one toolkits
---------- Post added at 11:34 AM ---------- Previous post was at 11:31 AM ----------
Install oneplus tool kit, while optimising apps it gets dectected by pc, just make it reboot mode & do reset.... Dnt worry this can be fixed, if all these seems messy then take it to service center
danq989 said:
I had my US version OpO 64GB working with CM12 for quite a while, rooted and bootloader unlocked with TWRP (possibly 2.8.6) installed, then some months ago I tried upgrading to CM12.1 through CM updater. This failed miserably - The phone started bootlooping on "Optimizing apps n of N" - as soon as it finished optimizing apps, the phone would reboot and start optimizing again. Booting to safe-mode (Power + VolUpDown) also fails in the same way (though optimizing fewer apps).
I tried rebooting to recovery mode holding Power + VolDown but it just gives a quick buzz (vibration motor) at the "1+" screen and reboots. The same thing happens when I try to boot to fastboot mode with Power + VolUp. So I'm completely stuck. All the guides show being able to boot either to fastboot or recovery (soft-brick) or else the screen being completely black/unresponsive (hard-brick). My phone is neither of these!
I got frustrated enough that I've let it sit on the shelf for the past 6 months, but now I'd like to fix this. All help appreciated.
---danq989
Click to expand...
Click to collapse
while things are loading, have u tried to hold vol up + power for 10 seconds or until the screen turns off and then hold vol down + power button until the oneplus logo?
Bradl79 said:
while things are loading, have u tried to hold vol up + power for 10 seconds or until the screen turns off and then hold vol down + power button until the oneplus logo?
Click to expand...
Click to collapse
Yes, just tried it. Same thing as described in my original post. When I hold power+volup the screen goes blank. I switch to power+voldown until the 1+ logo. At that point:
1. If I continue to hold the power+voldown key through the 1+ logo, the screen goes blank briefly, the phone vibrates once and reboots. If I continue to hold the power+voldown key, the vibrate&reboot cycle continues indefinitely
2. If I let go of either the power button, the voldown button, or both at or before the 1+ logo, the phone boots normally and goes to "Android is starting... Optimizing app n of 119). When the optimization finishes, the phone instantly reboots.
It's like the phone recovery is gone or inaccessible. Could this have to do with the phone tampering setting? As I said, I had this phone rooted and bootloader unlocked, working fine with CM12 for some time before trying an in-place upgrade to 12.1. That's when things went south.
---danq989
Hello
My stock A515F/DS received an OTA about 3 days ago. After it restarted to finish the update, it got stuck in the boot logo. It will reboot on itself from time to time, and I was able to reboot it manually by pressing vol down + power, but I can't get into recovery or donwload mode (by pressing vol up as soon as it reboots). The screen flickers for a moment, but it reboots again. We are under quarantine by federal law so I can't get my phone to samsung. Is there any way you guys know to flash it without going into recovery/download mode? I don't mind losing my data, everything is on my drive account, I just want my phone again
Thanks in advance
I think there is no way without entering in download mode or bootloader. Try with this:
When the phone is on, no matter which state, press Vol down + power until it reboots. As soon as the screen goes black, change to Vol. up+power. If this is successful, you can then select Reboot to bootloader to enter in download mode.
If this doesn't work, the next solution is waiting the end of quarantine
AlexLink89 said:
I think there is no way without entering in download mode or bootloader. Try with this:
When the phone is on, no matter which state, press Vol down + power until it reboots. As soon as the screen goes black, change to Vol. up+power. If this is successful, you can then select Reboot to bootloader to enter in download mode.
If this doesn't work, the next solution is waiting the end of quarantine
Click to expand...
Click to collapse
Been trying this since day one, it seems like the phone tries to go into recovery as the screen flickers, but this lasts for less than a second and it reboots itself again.
Hi i have gala y a51. Also.
Suddenly it hanged up and restarted.ans stucked on boot screen after 10 sec it vibrates and screen goes dim(while still on boot logo) and notification bell rings and then goes black.
Cant get into recovery mode .
Plz help