Hello,
the bottom connector from my Himalaya is broken...
Does anybody knows if there is a sync-cabel for the back-side connector ?
Or a female plug (perhaps from a cable extension) would help me to solve the problem as well...
Thanks in advance!
I have exactly the same problem. Any advice on where to find that connector. I can't take to a authorized service, because there's none in Macedonia
Thanks
Hey guys, can anyone help please. At least if you can tell me where to find that connector on the internet, so I can change it.
I think it's the same connector as for the IPaq 3800 series, can anyone confirm that. Thanks
ATC
go to www.merconline.co.uk for xda2 parts very good for conector repairs
was you finding that cable. I am also searching it, pls tell from where i can get it. i also not sure is it for synch and to charge xda.
cant you charge just the battery on the xda dock?
and sync with bluetooth?
flyboy
but problem is this i cant flash through bluetooth
Exactly same?
I have a Himalaya(i-mate Pocket PC) with a broken USB , repalaced by only a charging port so that I can charge it but cannot flash it! Got the intact cradle though. Is there anyone who can repair my USB port so I can flash it again?
this happenend on My first Himalaya too,i´ve searched a lot through the Net
and couldn´t find any spare parts,what I want to say is...
theres a bigger Problem to find Spare Parts then to solder the Port to the board
(yeahyeah...which isn´t easy too..i know...)
But is there anyone who knows what is the backside connector? And is there cable for it?! It will be good to use it! Just to avoid, soldering and finding spare parts! Any info will be good! I have soldered mini usb 2 times and every time i do that after fall it came of! I'm sick of soldering!!!
MMMMMM That`s it!!!
Look all!!!
The backside connector isn`t for syncornizing an charging!!
It`s just for connecting the "High capacity" battery, you know the big battry with 2400 mAh.
All i want to say, you have to put a new connector to flash roms and charge the battery without take it off from your devices.
Hope i`ve help you with you problem!!!!
Noaman Atassi
I knew that! But if u open a himalaya, and if u see below the back side connector there is a number of small dots, and every single of them are corespondenting for ones where the connector was soldered... So if anyone can find a corespodence for usb connection that will be good project... Just to avoid a use of old and crapy original connector, then u can use any connector u want! (for about 4 pins which is need for charge and usb sync) !!!!
Check this thread http://forum.xda-developers.com/showthread.php?t=636549
AUDIOVOX PPC4100
Can use Chager with XDAII or HP 63XX Serie ?
Please Tell me thank u.
I have a Mda II and today after 2 years it stopped charging via the car kit or via electricity . And then it died .
I found I can only charge it via the USB on my computer.
Any ideas how to solve this?
Thanks in advance!
Rafiki
Hi all,
The USB input for my O2 XDA Orbit, from where we charge the mobile phone has broken and I cannot charge the phone. The repair guy says that a pin has broken at the USB charging point and he needs the diagram to repair it.
Does any one have the circuit diagram or know from where I can get one.
Any help most welcome.
Hi
i have a question, i will buy a backpack for my mda2, now i have wm5 on it, would backpack tv out work?????
will use it to show gps-navigation in car.
if no what can i do so the tv out work???
I hope you can help me!!!
thx
Can't answer for WM5 but my WM6.1 ROM doesn't seem to see the backpack at all.
Belongs to the ROM you use
This German has no probs with the VGA Output and the Extended Battery----But there is no WM5 or WM6 driver to use the SF-Slot of the backpack till someone writes one.
Search backpack and you will get this answer everywhere.
http://rapidshare.de/files/38610887/WM6ger.zip.html
backpack apaan sih?what is abackpack..and there are extended battery for xda 2?
http://www.mobilefun.co.uk/product/3342.htm
http://www.expansys.com/p.aspx?i=108741