I have a HTC Kaiser phone with HTC oficial spanish rom.
My problem is...that after some weeks after a fresh rom load, calls start instantly failing when dialed. Ill explain myself, when I open my contact list and dial someone, i dont have a problem, but when i actually dial a new number and press send, the call will last 00.00 and just shows "Call finished".
Any clues??
Thanks for your time and answers =)
bump, help please?
it amy have been a bad rom flash , or you may not have hard reset after the flash.
also sometimes phone problems require only a soft reset (put your stylus in the little hole in the bottom to do this)
HARD RESET:
for a hard reset hold down the two soft buttons and then put your stylus in the hole HOLD THE BUTTONS DDOWN UNTIL THE SCREEN COMES BACK UP it will ask for confirmation and select yes by hitting the send button
Related
I'm using "Dutty's TouchFlo Rom 2 Final" on my tilt, but am facing problem with call end key. It doesn't respond during call and even in sleep mode...
I installed Tilt keyboard fix but no success..
Any help would be appreciated..
Regards..
I tried original ATT ROM... I think its hardware problem... coz when I press repeatedly it works... Can anyone help me out or tell me any solution..
Function design issue!
It is a design issue. To end a call you must either press the End Call (Hang-Up) button twice or press and hold on it. From a design stand point, this would prevent inadvertent hanging up on your caller while holding onto the phone and just clicking the hang-up button by mistake. At least that is what I was told by HTC.
Thank you so much asfoor. But sometimes i just end call with a single click and some time I have to press hard to end the call, same is when it goes to sleep mode...
I don't have that issue on the TyTN II. If it happens with different ROMs, then it's a hardware issue -- probably something in the contacts area.
it means i have to open it
ok..recently aquired this phone...
I've discovered that there is no sound from the speaker at all, no mp3 alarm ringtones .... I've used the slider on the side with no luck, and also tried changing the profile, volume control ect...no luck
Does anybody fancy talking me through any possible fixes for this...
Somebody suggested a hard reset?.... Any suggestions on doing this?...
Is this likely to be a software / registry change to fix this, or is it likely to be a case of sending it back for repair?... I'm sure its under warranty... but if its not, any suggestions on where I could take / send for repair?.... I'm in the Beckenham, bromley, south London region....
I have a basic understanding of pc's, but am not confident of doing registry changes without step - by - step instructions....
Anybody fancy a challenge?.... Thanx in advance...
PS.. just curious...any reason why this forum site is very simular layout to AV Forum site?....
Bump......
Try a Hard Reset first :
festermania said:
To perform a hard reset :
Press and hold the GPS/MESSAGING and INTERNET EXPLORER buttons, and at the same time, use the stylus to press the RESET button at the bottom of your device.
Release the RESET button, but continue pressing the GPS/MESSAGING and INTERNET EXPLORER buttons until you see this message on the screen:
"Release the buttons, and then press SEND on your device to perform the hard reset, or press any other button to cancel the reset."
To see bootloader page :
Hold power button + Camera button and push reset button with stylus wait 3 seconds and then release the reset button but keep pressing the power button + camera button u will be then in bootloader page
Click to expand...
Click to collapse
...did you go to Start Menu->Settings->Personal Tab->Sounds & Notifications to make sure that you've Enabled Sounds for Programs? a Hard-Reset certainly seems to be the option of choice here if nothing else is working. you can perform the Hard-Reset by selecting Start Menu->Settings->System Tab->Clear Storage and then follow the prompts to complete the process.
Nope...hard reset didnt work...just to say... I can hear through the earpeice when speaking in a phone conversation...just no other sound at all... even tried the option for beeps or clicks when using the keypad and still no sound... Also...that bootloader option...It just takes me to a screen with 4 different coloured stripes and some writing..I'll try it again and post what it says, but basicly it just freezes, then I have to do a soft reset to get the phone back on....
Bumpity bump....
m3uch4 said:
Press and hold the GPS/MESSAGING and INTERNET EXPLORER buttons
Click to expand...
Click to collapse
Please remember that the Orbit II does NOT have these buttons!
Update...
I've done another hard reset using this method....
1) Get your stylus and place it in the hole next to the USB port, BUT DONT PUSH! Just get it ready but dont actually push the button inside the hole.
2)Place your fingers on the Windows and OK buttons
3)Press and hold the buttons, dont let go.
4)Stright away push the stylus into the hole and press the button inside. You can let go of the stylus once the button inside has been pushed
5)Keep holding onto the Windows and OK buttons
6)After 5 seconds let go of the Windows and OK buttons
7)If asked to press SEND, just press the green pickup call button.
....
And still no sound!....
Any ideas?
Yes that's the correct procedure, strange about that sound though.
What ROMs it running?
Any clue about what it might be?....
hang on I'll find out........
ROM Version. 1.25.206.3 WWE
Is that the latest Rom..Would it be worth updating if there is a newer version?....
Is that an official ROM or cooked?
I think its official...
you could have a hardware problem...i would have sent it back for a replacement 3-4 days ago!
I cant, bought it second hand. Will take it back for refund if I cant get it fixed...just thought it might be a common problem with a easy fix!...
i believe you've tried most options without any success. the only other options are to open it up and see if maybe the speaker has been dislodged. not sure how easy that would be. good luck!
OK.... thanx anyway!... Damned tiny little screws inside...cant get to the speaker... Ok...off to the shop it goes!
No sound
I had this problem on another HTC device 'the Kaiser' and was informed some specific Roms are not compatible with the radio on the device ( does your device have the original Rom? ) Flashing a new may have caused this problem.
Hi all, i hope someone can help me out here.
i inadvertently installed "themechanger" onto my imate sp5, but this app was intended for my old imate sp2, the app installed no probs so i thought it might work.
but after installing it i can no longer access the start menu when i push the "start" button.
i am still able to make calls from the phonebook and recieve calls. i cannot dial a number anymore as when i start entering a number i get a blank screen and the numbers i enter don't show up.
i can still sms but only via the sms shortcut button.
i have no access to the start menu whatsoever.
i want to reinstall the rom, but when i attempt to, i get an error message saying "upgrade only, get newer version rom" i already have the latest rom from imate.
how can i reflash the rom?
Hard Reset
Hi Baskarz you can try a Hard Reset.
On a turned off device press simultaneously both softkeys and then the power button for 2-3 sec, leave power button once on (keep holding the soft keys). A black screen with a message will appear. Press 0 (zero) and enjoy, the phone will be reset and you lost all information an apps installed.
I hope that it works for you
ah excellent, all fixed!
i thought there must have been a hard reset, just didn't know how
I often don't go around asking questions often since I believe others have more important things to do than to answer inane questions. Unfortunately, I do have a tricky one so bear with me.
I have a GSM Raphael where the volume buttons do not work because of a torn ribbon. A dodgy SIP gave my phone the white screen of death upon uninstall. If I wait a while, a screen promising a hard reset if I simply press the Send button does not work. How can I hard reset the phone if I need a volume button for even entering the tricolor bootloader?
Can you still sync even you when the screen is white? You can try plugging in the sync cable while the phone boots... uninstall the SIP via WMDC.
I don't think I can unfortunately. Otherwise I'd just registry edit on my computer to set default sip to the normal keyboard.
same problem
I have the same probleme did you solf it yet??
In the end, I had to buy a replacement cable for it.
hi,
sorry for this lengthy message. But pls, experts look into this.
my father was having an Imate jama 201. 3 yrs ago, he kept inside since it did not work properly for him. That time i did not know what the problem was. Now i have caught hold of that.
The phone switches on properly. The welcome screen is seen. If there is no Sim card, it displays a msg. When i put a Sim card, it displays the operator name as well as the G- GPRS symbol. But when i click the start button or any key, it operates very very slowly.
In the navigation buttons i can only press the down button to go down a menu, but that too, by pressing the left key along with it. The right selection button( long rectangle near back button,) does not respond when i click it. But if the phone back light goes out, the phone responds back by coming back again to the home screen, on clicking that button.
I dont know whether this is a software or a hardware problem. The phone, very rarely is able to work without any sluggishness. I am able to view the preloaded gifs and images in the pictures menu and even go to camera mode.
I am able to receive calls and messages, but since the buttons don't respond properly, i am not able to answer them. The ring tone is loud enough to hear when i get a call.
I have no important data in it, so i am willing to flash it irrespective of any data loss, if required.
I am ready to answer any of your queries regarding this issue.
Thanks in Advance
You should try to make a hard-reset!
actually, most of the keys in it wont work properly. You just press randomly some keys in it, only a letter appears. i am able to go till the hard reset menu, but not able to enter the number: 1234