i was installing windows mobile 6 and then my device failed the copying of the new rom on step 3. after the setup i did a hard reset on my phone hoping it would get back to wm5 but now all i see is a screen freezing indicating
IPL 1.00
SPL 2.13.0000
GSM 02.07.20
OS 10.1.0.811
please help thanks in advance
Related
Hi!
Please help ......... SOS
I bricked my friend's Jamin
It booted fine after I put wm6 but now after I rebooted it,it shows the splash screen with imate logo : ipl : 1.00 , spl : 1.00.0000 , gsm: 01.14.20 , os : 10.1.0.811
any ideas ? pleasee help.......
same thing happened to me when it was softreset with a charger connected. Try removing the battery and/or hardreseting it. should do the trick
just try to hardreset..and then flash it with new ROM
hi...
i installed ROM v4.0.0.0
since it had a lot of problem i went to ROM v4.0.0.0.3a
but my cell still hanged a couple of times so i had another installation of ROM v4.0.0.0.3
during the installation it hanged and i got a msg on my screen that itwrite cannot finish
i reset my cell and now it does not start. only thing i get is my start up screen that is HTC and
IPL 2.15.0001
SPL 2.15.0001
GSM 02.19.21
OS 4.0.0.0
Dopod Enjoy mobility.
Can someone help me.....
i am stuck badly.
hi
Go Into BootLoaded mode, Reflash with Aku2.2_Novid. once complete install anyrom you want
Check out this post http://forum.xda-developers.com/showthread.php?t=310452
I have a Imate Jamin, Well i never upgraded it so i tried to upgrade to Gullum WM6 touch, I tried to upgrade through this method http://forum.xda-developers.com/showthread.php?t=323013
But i had battery error battery was below 50%, so i upgraded it through Shell tool, i didn't knew its camera button is not working, after flashing complete i couldn't hard reset device so i have to flash to through RUU again, After this IPL and SPL both were 1.XX, OS 2.20.XX. but after it was complete it is stuck on imate splash screen, Then i flashed it with official RUU after which my Ipl, SPL and Rom where back to 1.XX but no results, and then someone here suggested to Flash with PROPHET NVID RUU i also did that now my splash screen is Qtek Ipl 1.00 Spl 2.20.00 Gsm 02.47.21, OS 2.20.7.34 but still it is stuck on slash screen, in all case USb is been detected and i m able to load bootloader through Holding Power off and Communition Mana Buttons. Please help me and reply what should i do now. I think my Phone is Bricked and dead.
Thank you,
Arvin.
could please anyone resolve this for me.......
After i run hardspl ,i do a soft reset .. then i try to connect again but activesync not moovin at all.... it's appeard usb did not recognise and windows failed to read........
mine is :
ipl 2.20.0001
spl 2.15.0001
os 2.15.0001
While booting my htc neo showing a screen which contains:
IPL 2.15.0001
SPL 2.G4.4PDA
GSM 02.47.21
OS 2.20.7.35
My problem is I cant upgrade my prophet. I have tried more than 7 - 8 different roms but everytime its showing connection error . and trying to recover the updradation process. please help me.
more details
Hi,
Can you give some more details like what OS you have in PC, does it show USB in the left corner of the phone.
Regards,
V.Balaji