My imate Jamin struck at bootloader
showing:
IPL 1.00
SPL 2.20\
what can i do now???????
Please read this: http://wiki.xda-developers.com/index.php?pagename=Prophet_recovery
If you got stuck in bootloader, you did not HardSPL properly.
Related
Hi!
Please help ......... SOS
I bricked my friend's Jamin
It booted fine after I put wm6 but now after I rebooted it,it shows the splash screen with imate logo : ipl : 1.00 , spl : 1.00.0000 , gsm: 01.14.20 , os : 10.1.0.811
any ideas ? pleasee help.......
same thing happened to me when it was softreset with a charger connected. Try removing the battery and/or hardreseting it. should do the trick
just try to hardreset..and then flash it with new ROM
I have a Imate Jamin, Well i never upgraded it so i tried to upgrade to Gullum WM6 touch, I tried to upgrade through this method http://forum.xda-developers.com/showthread.php?t=323013
But i had battery error battery was below 50%, so i upgraded it through Shell tool, i didn't knew its camera button is not working, after flashing complete i couldn't hard reset device so i have to flash to through RUU again, After this IPL and SPL both were 1.XX, OS 2.20.XX. but after it was complete it is stuck on imate splash screen, Then i flashed it with official RUU after which my Ipl, SPL and Rom where back to 1.XX but no results, and then someone here suggested to Flash with PROPHET NVID RUU i also did that now my splash screen is Qtek Ipl 1.00 Spl 2.20.00 Gsm 02.47.21, OS 2.20.7.34 but still it is stuck on slash screen, in all case USb is been detected and i m able to load bootloader through Holding Power off and Communition Mana Buttons. Please help me and reply what should i do now. I think my Phone is Bricked and dead.
Thank you,
Arvin.
Hello
I've tried to upgrade S200 ROM and i had a big problem:
The phone doesn't startup. it's dead....
It stops in the following screen:
IPL 2.10.0001
SPL 2.10.0001
GSM 02.07.20
OS 10.1.0.811
How can I "save" my PROPHET?!
Can someone Help me, please...
Thanks a lot
could please anyone resolve this for me.......
After i run hardspl ,i do a soft reset .. then i try to connect again but activesync not moovin at all.... it's appeard usb did not recognise and windows failed to read........
mine is :
ipl 2.20.0001
spl 2.15.0001
os 2.15.0001
i made a .nbf with spl and os .nb file .then i setup my imate jamin when it finish setup it dead .not charging or hard reset.or bootload mode. What should i do.Any one plz help me
It's bricked probably... cause: wrong SPL