I tried to reflash factory image and then flash Magisk. Now, whenever i try to boot my phone up it only boots to TWRP. But TWRP doesnt even work. It is stuck on the splash screen and it flashes between the splash screen and black. TWRP never actually loads up. I am using a Moto G4/athene.
Related
Just used TWRP manager to flash the new 2.8.0.1 wlv build to my m8 and now it just bootloops into recovery everytime I reboot. What do I need to do to resolve this issue. thanks
jwt98 said:
Just used TWRP manager to flash the new 2.8.0.1 wlv build to my m8 and now it just bootloops into recovery everytime I reboot. What do I need to do to resolve this issue. thanks
Click to expand...
Click to collapse
Reflash the previous version you were running.
jwt98 said:
Just used TWRP manager to flash the new 2.8.0.1 wlv build to my m8 and now it just bootloops into recovery everytime I reboot. What do I need to do to resolve this issue. thanks
Click to expand...
Click to collapse
Do not use TWRP manager to install recovery. Use Flashify.
TWRP manager flashes to the wrong block. It flashes to mmcblk0p43 where as you need to have it on mmcblk0p44.
What version of firmware are you on. You will need to update your boot image.
To get out on the bootloop I had to install a Rom which was viper Rom 2.4. When I boot my phone, it still shows the twrp splash screen with the red text at the bottom. Doesn't even show boot animation. Seems like it freezes then home screen pops up like nothing's wrong. Any way I can get my HTC splash and aninmation back. Tried flashing a new boot animation but won't take. Is it still trying to boot to twrp.
jwt98 said:
To get out on the bootloop I had to install a Rom which was viper Rom 2.4. When I boot my phone, it still shows the twrp splash screen with the red text at the bottom. Doesn't even show boot animation. Seems like it freezes then home screen pops up like nothing's wrong. Any way I can get my HTC splash and aninmation back. Tried flashing a new boot animation but won't take. Is it still trying to boot to twrp.
Click to expand...
Click to collapse
Like other person said. You flashed your recovery to your system. You need to go to boot loader an fastboot recovery so it goes where it is supposed to. Then enter recovery via bootloader so you r really in recovery then flash your ROM an it will take care of your issue. Always fastboot recovery to avoid these problems.
I did the same thing through TWRP manager, and reflashed recovery through fastboot, restored, works fine. Thanks for the fix
greydelta38 said:
I did the same thing through TWRP manager, and reflashed recovery through fastboot, restored, works fine. Thanks for the fix
Click to expand...
Click to collapse
Glad to hear I could help.
My phone keeps restarting. Black screen -> Warning bootloader unlocked -> Black screen... etc. I also cannot access the recovery, gives me a black screen only.
Is the phone broken, or is there something that can be done?
What phone do you have? What caused this to happen?
XT1032
Installed PhilZ Advanced Recovery. Made a backup, rebooted devices, and stuck in this bootloop. When enter Bootloader to get to recovery, all i get is a black screen.
Can't even shut the phone off, because it keeps restarting.
Flash Philz again but don't reboot the phone. When Philz flashes successfully, use the phone's volume buttons to go to recovery from fastboot.
The problem here is i cannot get the phone to show up as an attached device, unless i do it "manually" where i reboot into bootloader from the standard android/phone interface.
You need to be in fastboot mode on the phone to flash Philz. Re-booting to bootloader from Android is fine.
After a little tweaking and some work, I managed to get it working.
Thank you for your help.
i unlocked and rooted this device a year or so ago and now i wanted to factory reset it. i go into the settings and factory reset from there. the phone reboot into recovery, but it just boot loops. i see the green android for a split second, then a black screen, repeat. other than that, i can boot up normally to my home screen, but rebooting into recovery get a boot loop. any suggestions?
android 4.4.2
philz touch recovery.
I unlocked my fully stock 32 GB Nexus 5 (6.0.1) and then proceeded to flash the latest TWRP. When I rebooted into recovery, the TWRP splash screen shows briefly, the screen flickers black, and then the TWRP splash screen reappears and it does this ad infinitem. When I try to reboot normally it also tries to reboot into recovery, leading to the recovery bootloop.
I also tried flashing CWM and that did nothing either. So currently I can neither boot into the ROM nor boot into recovery. I've tried 3 different versions of TWRP as well.
Thoughts/help?
EDIT: I flashed another version of TWRP (https://dl.twrp.me/hammerhead/twrp-2.8.7.1-hammerhead.img) and it manages to start booting into recovery and briefly shows the attached screen (took a picture) before rebooting and bootlooping recovery again.
Flashed factory images from Google and it seems to be booting into the OS normally. Will try recovery again soon…
I start my tablet up. It shows the Samsung screen, then the TWRP splash screen. After a few seconds, the screen flickers, and TWRP splash screen shows again. It does this indefinitely.
I can get into download mode, but Odin doesn't recognize that it's connected (yes I have drivers installed).
Any suggestions on how to get this tablet usable again?
Thanks!
Can you boot to recovery and factory reset ?
Nope...if I try to boot to recovery, it just does the screen flicker and keeps showing the TWRP splash screen.