Hello! Today I wanted to install the dual speaker mod for s8 +. I installed the zip via twrp and it told me that the mod was succesfully installed. After I restarted the phone, I got a bootloop.i entered twrp to give it a factory reset and gave me a direct failure, and after i thought to give it a format data.I restarted the phone, and after i got a bootloop again and after about 5 minutes it will give itself a restart and i still get a bootloop. Normally after i use format data in twrp i usually wait around 2-3 minutes until my phone opens and goes into the setup to initiate my phone.I tried the stock rom for s8+ flashing in odin and it fails again.I've tried everything I know and I've searched on google and I have not found anything. One thing I get in download mode after I get fail in odin is: SW REV.CHECK FAIL (BOOTLOADER) DEVICE: 2, BINARY: 1.
Generally if odin is failing to flash the rom it is the wrong firmware you're trying to flash.
If you were running 8 and try installing 7 it will fail due to the bootloader being updated and it's impossible to downgrade after that.
Another reason is incorrect firmware for you phone.
Related
I am having some serious troubles with upgrading my Galaxy Note 4 SM-910P (Sprint). All was well in rooting, un-rooting, etc... I have the original 4.4.4 and the new 5.0 backed up and now I can't use anything other than the firmware the original firmware package through Odin. The problem started when I installed the [ROM]ViSiON-X N4 SPR 5.0.1 [Android L 5.0][N910PVPU1BOB7-R1][03-11-15]. It installed fine but when ever I was not watching it a problem occurred such as getting locked out of ny ext SD, or just plain un-rooting itself. It finally came down to it just kicked my device into download mode and would not reboot. I did used chains Odin root method and installed TWRP, which I can still do but can not flash or restore from TWRP or CWM recovery. It will take the firmware package fine and download the 5.0 update but always gets stopped from any other upgrade at recovery be it stock or custom. I have even used Kies to try and upgrade a few time. It will upgrade from NK1 to NK2 but still will not upgrade anything else past recovery. Every time I reboot I lose my WIFI password. After every boot it takes a minute for any network to be able to reach the device. It is paused until I re enter my WiFi password then it will say that Android is done upgrading and there is a toast message that says "device is set to factory mode some items won't work on this mode set device to user mode". Can someone please tell me how to set my device to user mode or erase what ever is lockled in my device between download and recovery. The issue I described with the device wanting to stay in download mode and how to handle it is described her http://forum.xda-developers.com/showpost.php?p=59372208&postcount=3 but as I mentioned I can't get passed anything that is not firmware through Odin. If I had to be locked in one version forever I would have preferred it be 5.0
I figured it out
planb234 said:
I am having some serious troubles with upgrading my Galaxy Note 4 SM-910P (Sprint). All was well in rooting, un-rooting, etc... I have the original 4.4.4 and the new 5.0 backed up and now I can't use anything other than the firmware the original firmware package through Odin. The problem started when I installed the [ROM]ViSiON-X N4 SPR 5.0.1 [Android L 5.0][N910PVPU1BOB7-R1][03-11-15]. It installed fine but when ever I was not watching it a problem occurred such as getting locked out of ny ext SD, or just plain un-rooting itself. It finally came down to it just kicked my device into download mode and would not reboot. I did used chains Odin root method and installed TWRP, which I can still do but can not flash or restore from TWRP or CWM recovery. It will take the firmware package fine and download the 5.0 update but always gets stopped from any other upgrade at recovery be it stock or custom. I have even used Kies to try and upgrade a few time. It will upgrade from NK1 to NK2 but still will not upgrade anything else past recovery. Every time I reboot I lose my WIFI password. After every boot it takes a minute for any network to be able to reach the device. It is paused until I re enter my WiFi password then it will say that Android is done upgrading and there is a toast message that says "device is set to factory mode some items won't work on this mode set device to user mode". Can someone please tell me how to set my device to user mode or erase what ever is lockled in my device between download and recovery. The issue I described with the device wanting to stay in download mode and how to handle it is described her http://forum.xda-developers.com/showpost.php?p=59372208&postcount=3 but as I mentioned I can't get passed anything that is not firmware through Odin. If I had to be locked in one version forever I would have preferred it be 5.0
Click to expand...
Click to collapse
I fianlly figured out the deal with TWRP not flashing.
The change between file systems is what TWRP won't flash.
To flash into the new, the old, or back up property check the file type.
Ext 2, Ext 4, F2FS, etc ...
To get recovery to load install from odin with auto boot disabled, remove battery, than vol + - menu and power.
the steps below..
1. Power off (complete) boot to download.
2. Load Odin, uncheck auto reboot, PDA TWRP. after it installs pull battery to exit.
3. Boot to recovery - wipe- advanced wipe -Repairor Change File System - Check System (go thruough each)
4. Repair and change each to the file type you want to flash
5. repair and or change the files for the zip you are going to flash
6. you have done all the rest before ....
Issue resolved, thread closed, thanks.
So recently updated to 7.0 nougat version and did not like so i tried to flash a stock firmware which then soft bricked my phone , i got an error saying , error has occured use smart switch something like that, anywayz i was incapable of accessing the recovery mode ( i have stock recovery atm) but i could access the download mode , so luckly i had screen shot of my build number and baseband number using that i was able to find a stock firmware but the first time i tried i got an error caused by sboot.bin so then i saw some videos and apparently asked me to remove it from the stock firmware file and i did and i tried again AND NOW i get cm.bin error..... so now i remove that too after reading in a forum , so i tried again and this it worked ..... but D: ...... now it stuck on boot loop but i have now access to my stock recovery mode and atm downloading another stock firmware to try but this time i did wipe cache and factory reset but before i proceed i need advice on what to do now because i think theres a way to fix it now that i have access to the recovery mode maybe i need to add some custom recovery or something idk i need help. So far its been a hell of journey and im hoping it has a happy ending
My device has been bricked after attempting to root the device using Odin. (Samsung Galaxy S8+)
The device is stuck in a bootloop with the following accompanying error message in red on the boot screen:
"Only official released binaries are allowed to be flashed"
Here is what happened:
I flashed TWRP using Prince Comsy Odin. (The only Odin that actually works on the s8+)
I then booted into the TWRP recovery.
I followed a set of instructions, clearing the Cash and wiping
I restarted once then booted back into TWRP using Vol-Up + Power + Bixby
I was preparing to install Magisk & "no-verity-opt-encrypt-5.1" according to instructions to complete the root.
After installing "no-verity-opt-encrypt-5.1" with TWRP, the system rebooted and i was stuck in a boot loop.
I then got the error message in the bootloop "Only official released binaries are allowed to be flashed"
Since then i have not been able to successfully re-flash TWRP.
I now cant enter TWRP recovery boot using Vol-Up + Power + Bixby anymore
The bootloop is about 2 seconds long and too short to enter TWRP recovery
I can enter download mode and thats all
I have gotten the EXACT official stock ROM for the galaxy s8+ in South Africa with the carrier, Vodacom. (XFV-G955FXXU4CRL4-20181228165540)
If i flash with any official Odin version, it either fails or doesnt do anything for hours...
If i flash any Official stock Rom using Prince Comsy Odin then i do get the whole process of flashing with stock firmware being successful with the result saying "PASS".
The phone then reboots and i am still stuck in the same loop saying "Only official released binaries are allowed to be flashed"
This is after countless times and hours and hours of reflashing successfully with Official stock rom
I still cant get back into TWRP to do any partitioning or formatting or anything
I really don't mind if i lose all of my data and format the phone but PLEASE can you help me get my phone to work again..."?
Do i need to wait 7 days for the official flash to work?
Is there a way to completely wipe my phone without requiring going into Recovery mode with TWRP? Since i cant get into that state anymore either because of the Error Knox block or because of the Loop being too fast.
Please, please, PLEASE....please help me get my phone to work again...
Sincerely,
I know that Odin 3.13.1 works on the s8+ G955F as I flashed the latest BTU stock yesterday so try that version. I had a similar problem with the G950F and after flashing the files I booted into recovery mode and did a data and cache wipe and the phone rebooted. Flashing a stock rom should have wiped TWRP from the phone.
Reflash your rom or a later one, don't forget to take the tick out of the auto reboot box in Odin, boot to recovery and wipe everything and hopefully you will be good to go. Rebooting on mine took around 35 mins or so when going back to stock.
GalaxyS8+ SM-G955F: BRICK (Only official released binaries are allowed to be flashed
I have the same problem with the model G955F binaries 4 I can not always rooted
le_pentium said:
I have the same problem with the model G955F binaries 4 I can not always rooted
Click to expand...
Click to collapse
same for me !someone asked me to delete the RMM to resolve the problem
le_pentium said:
I have the same problem with the model G955F binaries 4 I can not always rooted
Click to expand...
Click to collapse
My problem is fix
I hope someone reads this as I'm lost for ideas. First time trying to root a device, I'm using an s8+ and somehow managed to mess up installing twrp using Odin.
Now when I try to re flash twrp it comes up with error, 'only official released binaries are allowed to be flashed'. Also I think I managed to erase the recovery program that comes with the phone as when I try to boot in recovery it now comes up with error message 'No command'.
I have reinstalled the stock firmware using Odin but that hasn't fixed anything.
Anyone got any ideas or insite into this problem. Any advice would be very appreciated as I'm so keen to discover rooting!!
Philnicolls89 said:
I hope someone reads this as I'm lost for ideas. First time trying to root a device, I'm using an s8+ and somehow managed to mess up installing twrp using Odin.
Now when I try to re flash twrp it comes up with error, 'only official released binaries are allowed to be flashed'. Also I think I managed to erase the recovery program that comes with the phone as when I try to boot in recovery it now comes up with error message 'No command'.
I have reinstalled the stock firmware using Odin but that hasn't fixed anything.
Anyone got any ideas or insite into this problem. Any advice would be very appreciated as I'm so keen to discover rooting!!
Click to expand...
Click to collapse
Seeing No command is normal, with an icon of a dead android lol, thats stock recovery, blue screen, i got that all time, but after waiting about 30 seconds and pressing the buttons, i got the mnue to pop up to reset cache, reboot phone, wipe data etc.
As for TWRP, are you flashing the correct one, dream2lte??, download the latest one, the dream2lte.img .tar file, from the TWRP official website - - https://dl.twrp.me/dream2lte/twrp-3.3.1-0-dream2lte.img.tar.html.
I had this issue trying to flash TWRP with standard odin, i had to use a modded version of odin to flash it, even prince cosmy version didnt work for me.
I have attatched the ODIN i use, its a 7zip file.
Thank you, after trying a few more things the twrp file you gave me worked. I now have a fully rooted s8!!!! Your a legend.
Dear all,
Yesterday I want to install a new customer rom, this is first time to install rom. Firstly, I unlocked the bl and kg oem, then the first issue is I can’t flash the twrp successfully, then it become brick now. (The Odin3 showed and stuck in VBMETA). Then I want to try use odin3 to flash the original latest official 5 package to recovery but still failed. (The odin3 stuck in set partition). I checked and searched the issue resolved ways,I tried many times and used original usb, it also showed ！!!!)The photo I uploaded, please help me how to recovery to normal.