i have a tablet Lenovo ideaTab a1000l-f
512 mb ram
i damaged system files experimental
then the tablet goes to bootloop
i must flash the rom
i read all the ininstructions at xda
i download all the files
the main problem is that
when i connect tablet to the pc there is no reaction at the device management
i can go in recovery mod --> factory reset but bootloops again because i damaged system files
i can go in factory mode --> ?? i can do nothing ??
so how can i solve the main problem
the cable is tested with other devices and the cable is ok
and i am using windows 7 64bit
Related
Hi..
I was trying to upgrade my samsung galaxy s plus (GT-19001) device to Android 4.0.4.
i just installed CWM-based recovery v5.5.0.4 on my device by rebooting and selecting (install zip from sd card).
------using mentioned combination of keys -------
Then i placed the files in my phone's internal SD Card.
files are mentioned below:
1-> cm-9-20121011-ivendor-ariesve-rc5.zip
2-> gapps-ics-20120429-signed.zip
3-> recovery-clockwork-6.0.1.2-ariesve.zip
then install 1 by choosing from internal SD card and then 2nd file.
my device prompted completion success messages but it took very short time.
----------------------------------------------------------------------------------------------------------------------
now what happened after doing this. my device is displaying same booting screen of CWM-based recovery v5.5.0.4 on each re-boot.
i treid many times by unplug the battrey but unfortunately unsuccessfull.
After that i did Wipe data/factory reset and wipe cache partition.
----------------------------------------------------------------------------------------------------------------------
I tried it through window's based utility Odin v4.43 but it could detect my device usb driver even after success of USB driver installation.
it didn't display Added in message box.
now what should i do ?
i already installed samsung Kies but still undetected but still undetected my Phone device and says "Your phone device is not supported by Kies2.0"..
I tried some old version of Odin 3v1.8 , it detected the port and displayed Added but failed to write ROM on my device.
-----------------------------------------------------------------------------------------------------------------------
My desktop machine's OS : windows 8 64 bit enterprise edition.
----------------------------------------------------------------------------------------------------------------------------------------------------------
I am unable to install new ofor revert back my OS because when i Hold Vol Down + Home + Power, This is not putting me in Download Mode instead Ramdump Mode.
I need your guidence to resolve the issue. Thanks in advance.
Please ask for further details if required.
empnetsol said:
Hi..
I was trying to upgrade my samsung galaxy s plus (GT-19001) device to Android 4.0.4.
i just installed CWM-based recovery v5.5.0.4 on my device by rebooting and selecting (install zip from sd card).
------using mentioned combination of keys -------
Then i placed the files in my phone's internal SD Card.
files are mentioned below:
1-> cm-9-20121011-ivendor-ariesve-rc5.zip
2-> gapps-ics-20120429-signed.zip
3-> recovery-clockwork-6.0.1.2-ariesve.zip
then install 1 by choosing from internal SD card and then 2nd file.
my device prompted completion success messages but it took very short time.
----------------------------------------------------------------------------------------------------------------------
now what happened after doing this. my device is displaying same booting screen of CWM-based recovery v5.5.0.4 on each re-boot.
i treid many times by unplug the battrey but unfortunately unsuccessfull.
After that i did Wipe data/factory reset and wipe cache partition.
----------------------------------------------------------------------------------------------------------------------
I tried it through window's based utility Odin v4.43 but it could detect my device usb driver even after success of USB driver installation.
it didn't display Added in message box.
now what should i do ?
i already installed samsung Kies but still undetected but still undetected my Phone device and says "Your phone device is not supported by Kies2.0"..
I tried some old version of Odin 3v1.8 , it detected the port and displayed Added but failed to write ROM on my device.
-----------------------------------------------------------------------------------------------------------------------
My desktop machine's OS : windows 8 64 bit enterprise edition.
----------------------------------------------------------------------------------------------------------------------------------------------------------
I am unable to install new ofor revert back my OS because when i Hold Vol Down + Home + Power, This is not putting me in Download Mode instead Ramdump Mode.
I need your guidence to resolve the issue. Thanks in advance.
Please ask for further details if required.
Click to expand...
Click to collapse
hai man it's really easy tosolve your problem. just take supported Team win recovery for galaxy s plus and place it on your eksternal sd card. then flash it by your cwm recovery. and then just reboot. you gonna get your phone come back.. voila. hope this will help you.
Re: [Q] <samsung galaxy s plus> cwm-based recovery v5.5.0.4 appears on each boot
Hey can you give me the link to download the cwm of galaxy s+ please
Sent From My Evo Galaxy Mini
JellyBean 4.2.2
Hello, I'm using v970 4.1.1 v1.1 MOD by Bruno Martins.
I try to flash it to reorganize partitions (merge cache and phone storage to 2,5 GB and set "external memory" to trully microSD card). Somethings goes wrong :/
After plug in to USB (no battery), it looks like Mediatek Preloader for...2 seconds, after that "device is unplugged". I cant flash phone properly in 2 seconds :/
Any ideas? I'm really tired for installing new drivers, looking for help on polish android support (forum.android.com.pl). Any suggestions welcome
Greetings!
Wat version of windows you're using?
Help! My Samsung GalaxyTab 2 P5100 is stuck in boot loop and i can only turn it off when i connect it to the wall or to the computer. i never flashed or installed a "rom" or anything :angel: ,i just left the tab on plugged to the wall that night and the internal memory was full but i delete one file of 800Mb for the tab to stop warning me that the memory was full.
I want to atleast save my files videos photos to the computer, they are all in the internal memory because i never needed an SD card. :crying:
I tried to fully charge the tab but doesn't work and when i plug the tab via usb to the computer, windows asks for this driver omap4430,
i found out about the android system recovery 3e and there's an option to Hard reset the tab "wipe data/factory reset" but i don't want to do that without saving my files first, how can i do that?
Ok, i forgot i made a backup of my files three months ago so tried to do an hard reset with the Android system recovery <3e> and it fixed the tab. :victory: i run the recovery mode by pressing and holding the Volume Up and Power button at the same time for about 30 seconds until the (Android System Recovery) menu appeared. Then i selected with the volume up/down the Wipe data/Factory Reset option and pressed the power button. after that i selected Wipe cache partition and then selected reboot now. It's as good as new but all data (videos, pictures, everything) were erased.
thanhdoku said:
Help! My Samsung GalaxyTab 2 P5100 is stuck in boot loop and i can only turn it off when i connect it to the wall or to the computer. i never flashed or installed a "rom" or anything :angel: ,i just left the tab on plugged to the wall that night and the internal memory was full but i delete one file of 800Mb for the tab to stop warning me that the memory was full.
I want to atleast save my files videos photos to the computer, they are all in the internal memory because i never needed an SD card. :crying:
I tried to fully charge the tab but doesn't work and when i plug the tab via usb to the computer, windows asks for this driver omap4430,
i found out about the android system recovery 3e and there's an option to Hard reset the tab "wipe data/factory reset" but i don't want to do that without saving my files first, how can i do that?
Click to expand...
Click to collapse
I am having the same problem, but I did root mine and was about to install a rom. From what I have read, you may have to use odin and look a stock rom to be able to use it again. I'm a new guy so don't quote me, but there are post about this already.
How can I use my OnePlus One as USB mass storage device? I dislike MTP.
I do like this-
1. Switch off the phone.
2. Connect to PC
3. Enter recovery mode
Now drivers will load automatically and you can exchange data in Mass Storage Mode.
Sent from my A0001 using XDA Free mobile app
id2xda said:
I do like this-
1. Switch off the phone.
2. Connect to PC
3. Enter recovery mode
Now drivers will load automatically and you can exchange data in Mass Storage Mode.
Sent from my A0001 using XDA Free mobile app
Click to expand...
Click to collapse
Really? It will be detected as a USB drive??? Is this with a particular recovery or will TWRP do it? I'd like to add a partition to my phone that will contain a bootable Linux distribution so that I can use my phone as a rescue disk. Would this be possible?
uudruid74 said:
Really? It will be detected as a USB drive??? Is this with a particular recovery or will TWRP do it? I'd like to add a partition to my phone that will contain a bootable Linux distribution so that I can use my phone as a rescue disk. Would this be possible?
Click to expand...
Click to collapse
Hi. I am using latest TWRP recovery and Oneplus is responding well invariably.
I have not tried adding partitions and also dont know much about it.
Goodluck if u r planning to try it.
id2xda said:
Hi. I am using latest TWRP recovery and Oneplus is responding well invariably.
I have not tried adding partitions and also dont know much about it.
Goodluck if u r planning to try it.
Click to expand...
Click to collapse
Will look into this. Thanks!
I just looked into it and got nothing. It talks over usb, but no USB Mass Storage support (reading Linux dmesg to test). I looked over TWRP, and it looks like the disabled USB Mass Storage when Android shifted away from having a separate FAT filesystem you could mount under Windows. Your SD Card is now a directory under /data and most kernels don't have the ability to even export USB Mass Storage anymore because, as ext4, Windows will tell you that the drive is unformatted and ask you to format it for you!! And that would mean losing the entire /data partition. Basically USB Mass Storage is gone. I'm thinking with a custom kernel and maybe compiling TWRP myself, I might be able to get it back, but its going to be far from trivial. I think the end result (a recovery system that I can boot a PC from in an emergency with plenty of tools) will make a great addition to my phone.
TWRP is supposed to support MTP now, but its not working for me. I end up using USB OTG for "bare clean wipe" flashes.
Any news? Unfortunately, since it was upgraded to lollipop I can not connect the OnePlus one to my car radio as a removable disk. It remains uncomfortable leaving your phone in recovery to use UMS
IHi, i've removed my system Os and all i'm left with is TWRP and no backup which i messed up, and the system is not able to recognize the device with adb, samsung or any other driver I tried installing, not able to understand how to fix this
please help !
Hi,
You can mount your internal storage in twrp in the mounts menu. Your PC should then detect the phone as a mass storage device without additional drivers required.
After that, you should be able to flash a rom.
-gsstudios