Hello Guys,
I am completly new here. Sorry if i do something wrong with my Thread here...
Today I tried to intsall Lineage OS 14.1 on my Wileyfox Swift (Crackling).
- Unlocked Bootloader, worked I think so.
- Installed TWRP, works
- Installed the ROM zip, seems to work
- Installed GApps, seemes to work
BUT: After restarting the system, I only can restart into fastboot/bootloader. I can go into Recovery mode. But I cannot start the system.
Tried to wipe again and to it all again several times - always the same issue.
Tried it now with Lineage 15.0 - the same.
I do not know, why does my phone always start into the bootloader and don't start the system???
THANKS FOR HELP!
Try installing LOS 14.1 again, then do a restart and let the system boot first, after successful boot, go back to TWRP and install GApps.
Related
Ok... slightly frustrated here.
Basic issue: Have flashed CM13 (Nightly 5.17.16) along with the latest Gapps. Upon reboot my phone will go to the Cyanagenmod splash screen, appear to load for several seconds, and then restart. It keeps doing this for at least 10 minutes until I turn it off. I have re-flashed a couple times after reloading the backup but no change.
Process I used: First of all my phone already has Android 6.0.1 firmware installed (not sure if that's an issue). I have TWRP setup as recovery and rooted with su 2.52 (and yes I verified the root prior to flashing). To flash I boot into recovery (obviously), factory reset, install cm13, clear dalvik, and repeat process with gapps. I've done this before with older CM's successfully but for some reason I can't get past the CM splash screen.
Any assistance is appreciated. If I have made a completely stupid error in my process or this exact issue is covered in another thread don't hesitate to point that out!!
Thank you in advance.
i was getting the same thing on my 1st flash into 13 from moar rom 7.0 but did some reseach and fixed it by wiping the dalvik and cache before the flash and then installed cm13 and then the gapps 6.0 stock all in twrp and fyi you dont need super su just unlock the developer mode and go to the bottom and turn on root access it made me crash my system after i installed new supersu hope these helps
you dont want to be on a MM baseband. Flash a LP tar.md5 in odin and reinstall CM13
Hello all,
After I wiped my system, I tried to install the latest Magisk (From the official MagiskManager website) and then, after I wiped again, and tried to reboot, my phone just showed a black screen it wouldn't even show the unlocked bootloader warning or the boot logo and when I charge it, the LED flashes constantly (I'm not sure what that means) therefore I have to boot back into the recovery or the bootloader as there is no system. I looked at the system files and there was nothing there although the Lineage OS flashed successfully.
Can anyone help me?
I'm not sure whether my phone is bricked or something as every other time I did it (2 times) there were no problems.
Version of Lineage OS I tried to install (lineage-14.1-20180108-nightly-athene-signed.zip)
Device: Motorola Moto G4 2016 (Athene)
Custom Recovery: TWRP 3.0.2.0
Magsik Version: Magisk-v15.3.zip
Thanks in advance!
You never wipe system unless you are flashing a rom. You pretty much removed the OS and then tried. To boot it.
zelendel said:
You never wipe system unless you are flashing a rom. You pretty much removed the OS and then tried. To boot it.
Click to expand...
Click to collapse
Yeah after I flashed Resurrection Remix, everything went back to normal, but thanks anyways.
About a month ago I installed PixysOS v2.4 for my device along with Magisk v18.1. Everything was working fine until today phone suddenly froze. I tried to boot to fastboot mode and restart device but to my unfortunate luck it would just stuck atWarning Bootloader Unlocked Screen and won't proceed further. I tried rebooting via TWRP by selecting recovery mode but no matter which option I select it would stuck at TWRP then.
Then I thought to uninstall magisk as it may have caused some error so I again booted into TWRP and flashed the latest Magisk Uninstaller but it would not go further after detecting my device system. I tried this 3-4 times then I thought to completely wipe out the system and install PixysOS again.
Now when I tried to wipe System,Dalvik,Cache and Data it is stuck at Wiping Dalvik Cache DIrectories...
I can still start TWRP by pressing Vol down+Start button but its kind of useless as it would not wipe anything!
Here is my device info:-
Device name :- Motorola Moto G Turbo Edition (MotoG3-TE)(MERLIN)
Os running :- PixysOs v2.4 based on Android Pie.
TWRP version :- 3.2.3-0
Magisk Version :- 18.1
Magisk Modules :- Youtube Vanced and Viper4Android.
Can anyone guide me how do I fix my phone?
Edit :- So I just realized that I have a Nandroid Backup already on my SD card. I tried restoring it through TWRP and now it seems something 'Internal' is wrong with my phone.
Howling Wolf1210 said:
About a month ago I installed PixysOS v2.4 for my device along with Magisk v18.1. Everything was working fine until today phone suddenly froze. I tried to boot to fastboot mode and restart device but to my unfortunate luck it would just stuck atWarning Bootloader Unlocked Screen and won't proceed further. I tried rebooting via TWRP by selecting recovery mode but no matter which option I select it would stuck at TWRP then.
Then I thought to uninstall magisk as it may have caused some error so I again booted into TWRP and flashed the latest Magisk Uninstaller but it would not go further after detecting my device system. I tried this 3-4 times then I thought to completely wipe out the system and install PixysOS again.
Now when I tried to wipe System,Dalvik,Cache and Data it is stuck at Wiping Dalvik Cache DIrectories...
I can still start TWRP by pressing Vol down+Start button but its kind of useless as it would not wipe anything!
Here is my device info:-
Device name :- Motorola Moto G Turbo Edition (MotoG3-TE)(MERLIN)
Os running :- PixysOs v2.4 based on Android Pie.
TWRP version :- 3.2.3-0
Magisk Version :- 18.1
Magisk Modules :- Youtube Vanced and Viper4Android.
Can anyone guide me how do I fix my phone?
Edit :- So I just realized that I have a Nandroid Backup already on my SD card. I tried restoring it through TWRP and now it seems something 'Internal' is wrong with my phone.
Click to expand...
Click to collapse
Tried wiping everything? Tried some other ROM other than Pixys?
baalajimaestro said:
Tried wiping everything? Tried some other ROM other than Pixys?
Click to expand...
Click to collapse
Tried Pixel Experience and LineageOS but it just won't flash!
By wiping everything you mean all of the options I see in wipe tab?
Need some help, I keep getting a infinite boot animation. I tried to install LineageOS (thread) on my G920F three times and let them all boot for about an hour without success.
This is the order of how I flashed it:
1. Wipe Davik, System, Data and Cache
2. Flash the LineageOS zip
3. Flash the Zerofltexx kernel img
4. First try flashed OpenGAPPS, second try flashed MindTheGAPPS and third try didn't flash GAPPS at all
5. Reboot and wait, after an hour still booting
Any idea's of what I'm doing wrong?
Fixed my issue!
Hi!
I had the same issue as you, followed the guides and installed TWRP through ODIN and flashed the OS through TWRP to boot it.
When I booted the device it just got stuck indefinitely on the loading animation (the Lineageos loading logo in my case).
Since you and some others had the same issue as me I assumed it was something to do with a new version of some software.
I resolved the issue by installing an older version of TWRP through ODIN,
I installed the TWRP version 3.2.3.
And then I flashed the same ROM with the GAPPS again.
After the ROM and GAPPS I also flashed MAGISK aswell from the magiskmanager website.
Download the MAGISK Zip.
After I flashed the ROM, GAPPS and MAGISK through the TWRP 3.2.3 it booted as intended.
Hope this works for you aswell!
how long did it take to boot
First Boot needs longer...up to 15 minutes is possible.
solonf
speedson
i have same probleme wtih my samsungs6 g920f i wiil try it ...hope it work ....
Remove the TWRP from the phone via the advance key in TWRP. I had tried several ROMs and Gapps only to get stuck on the boot screen then back to the TWRP screen. Removing the app made my new rom boot in less than 10 seconds.
If you can give us exactly the steps you follow
Lineageos 17 boot animation stuck
krimnian said:
If you can give us exactly the steps you follow
Click to expand...
Click to collapse
Steps (I have followed the instructions to the letter)
Wiped all partitions (advanced wipe)
formatted DATA partition
rebooted back into recovery
installed Lineage 17 and Gapps
Rebooted to system and left it all day, still stuck on boot animation
Tried again without gapps same results
Tried other roms they work, AOSP showing no encryption which works fine
What am I doing wrong? Do I have to flash different kernel? TWRP 3.3.1 installed.
Im using G920L it booting to long then just go to twrp anyhelp?
Helpful
crmcc said:
Remove the TWRP from the phone via the advance key in TWRP. I had tried several ROMs and Gapps only to get stuck on the boot screen then back to the TWRP screen. Removing the app made my new rom boot in less than 10 seconds.
Click to expand...
Click to collapse
this was extremely helpful as soon as i unchecked installing with twrp it worked immediately.
crmcc said:
Remove the TWRP from the phone via the advance key in TWRP. I had tried several ROMs and Gapps only to get stuck on the boot screen then back to the TWRP screen. Removing the app made my new rom boot in less than 10 seconds.
Click to expand...
Click to collapse
Can you explain the process a little?I have flashed lineage os 18.1 in moto g5 plus , but it's stuck on lineage booting animation.
rog__ said:
Can you explain the process a little?I have flashed lineage os 18.1 in moto g5 plus , but it's stuck on lineage booting animation.
Click to expand...
Click to collapse
For reference, formatting data after install seems to often be the solution when flashing a new OS to a Moto G5 Plus.
gamemaster2030 said:
Need some help, I keep getting a infinite boot animation. I tried to install LineageOS (thread) on my G920F three times and let them all boot for about an hour without success.
This is the order of how I flashed it:
1. Wipe Davik, System, Data and Cache
2. Flash the LineageOS zip
3. Flash the Zerofltexx kernel img
4. First try flashed OpenGAPPS, second try flashed MindTheGAPPS and third try didn't flash GAPPS at all
5. Reboot and wait, after an hour still booting
Any idea's of what I'm doing wrong?
Click to expand...
Click to collapse
These steps solved my issue. thanks
Hi everyone,
I'd really like some help here.
I have an OP6, 8gb/256GB.
My OP6 suddenly started crashing and rebooting randomly after the update to 10.3.1. It seemed fine before. I did a full factory reset and the problem was not resolved.
It is especially bad when i turn on the lockscreen. So i turned it off and did not turn it on again.
The apps that would crash were random including oneplus launcher, google playstore, and other google apps. the issue remains when I do the factory reset and do not install apps. It is a bit more stable when I do not login to a google account. Even the basic set up leads to multiple crashes and reboots.
The problem continues after i have tried all the steps below.
1) msm downloader to downgrade to OOS9. Worked better, with less frequent reboots, but problem continued.
2) I did a remote session with Oneplus, they installed OOS9. After the install, it restarted, got to the start screen and then rebooted. I was able to complete basic set up. but Problem continued with other apps even though I installed them one after the other and did not enter my google account credentials.
3) did another factory reset and upgraded to 10.3.2. appeared stable but restart was also off as it would reboot every 2 steps in the process. Problem continued
4) I unlocked bootloader, rooted the phone and tried a few roms. With OOS 9 fFastboot, all roms failed to start and put the phone in crashdump mode. I installed the roms using instructions on each rom page. basically, flash the oos, twice, flash twrp, go to recovery, flash rom, flash twrp, go to recovery, flash gapps, flash twrp and then reboot system. When installation failed or rom did not work properly, i would reinstall the fastboot file and then start over.
5) I installed the fastboot 10.3.2 on both slots (tested by booting it from a and then from b). I used twrp 3...18. and flashed pixel rom, bliss rom, lineage os, illusion rom. Lineage and bliss were most stable with little rebooting but the problem still occurs.
6) As of now, I upgraded to the 10.3.2 OOS using the fastboot file. I flashed it twice for good measure. I was able to install my apps and stuff using google setup. But phone is flickering randomly and problem has not been resolved.
I'd appreciate any help to get this good looking phone back to work!
Ur problem is you don't want to format data when switching ROMs (at least not all ROMs) it's safer to just wipe data instead.
Flash OOS
Flash TWRP
Reboot recovery
Flash OOS
Flash TWRP
Reboot system
Complete initial setup
Reboot to recovery
Wipe (not format) data
Flash custom ROM (start here for dirty flashing ROM update)
Flash TWRP
Reboot recovery
Flash custom ROM
Flash TWRP
Reboot recovery
Flash Magisk
Reboot system