Unbricked my phone with DC Phoenix. But no matter what I flash I no longer have a setup wizard. Phone boots right to lock screen. Tried flashing multiple ROMS.
Related
I tried using the ShellTool to load a new rom. Now Im stuck in the tricolor load screen.
Its a G4 Phone
SPL Unlocked (2.21 Olip)
Tried loading the Balck Diamond 3.1 through ShellTool
Now Im the tool. Help please.
It seems that I should be able to load a ROM from this 3 colored boot loader screen. But every time I try the computer tells me no device detected. Just put me out of my misery, IS MY PHONE BRICKED?
Hi,
I was trying to install a rom for the first time to a tilt and after installing jumpspl and hdspl everything was working fine. Then by mistake I installed the radio 1.71.09.01 and then it get stuck after the ATT 3G animation.
There is no way to enter bootloader, I have read the wiki and try mtty but can't connect, or get trought. I can hard reset and enter but the bloatloader starts and after everything is installed the phone resets and get stuck again. I try resetting after the bloatware strats but then again get stuck.
mtty says: usb port can not open
bootloader not working, not withe the power+camera+reset or not with camera+reset.
Any help will be appriciated!!
Thanks
I have looked at multiple guides on this and other sites, googled and tried stuff and I cannot resolve this problem. Hopefully I am posting in the right place.
I took the jump and unlocked the bootloader on my Moto G first generation, XT1034 successfully. I flashed TWRP 2.8.60.xt1034.zip with adb and this was successful. Then I flashed Super SU 4.6 Update and that was successful. I got into trouble I guess when I tried to flash Cyanogenmod 12.1 nightly. I used TWRP to flash via install. The flash had an error, which unfortunately I didn't write down. I believe it was something to do with a partition. However, it looked like the flash failed. At this point and for hours I have been trying to fix the "Warning Bootloader Unlocked Loop I am stuck in.
I have been able to get into the phone and flash via adb commands. I've tried several commands suggest to fix this that I have found in forums. I have tried flashing several recoveries including an older TWRP per the method in this thread, a clockworkmod - and the original 2.8.6.0.xt1034. When I get into the phone bootloader which is available, I have not been able to access any options in recovery. Pushing the power button on recovery leads to a blank screen sometimes followed by a recovery starting or a Motorola Logo starting up and a couple times a recovery. TWRP has started a couple times, but never gets past the intro screen, where it locks up. clockworkmod (clockworkmod-6.0.4.7-falcon.img started once after flashing through adb and gave me flash options. I tried to sideload, didn't understand, went back and the recovery locked up. These recoveries no longer load at all.
Through all of this the "Warning Bootloader Unlocked" logo screen comes up after plugging into the computer (Windows 8.1).
Example, I open the phone bootloader by waiting for the phone screen to go from the "Warning Bootloader Unlocked" screen to blank - it cycles from logo to blank. If I'm quick the phone and hard boot the phone will boot into bootloader. I connect to the laptop through USB. When I toggle to recovery and hit the power button the screen goes blank, the Motorola Logo pops up, goes blank and then the "Warning Bootloader Unlocked" appears. The Laptop then seems to connect and disconnect as the Warning screen comes on and turns off.
The factory selection just goes to a blank screen.
I would really appreciate some advice on how to get the phone back to a state in which I can work with it and try again. It is very difficult wading through all of the information out there. I've learned a lot through this issue, but can't take it any further.
Thanks, Jeff
Solved - Stuck in "Warning Bootloader Is Unlocked" Loop
This resolution took many hours to figure out, but I finally got there with this guide - http://forum.xda-developers.com/showthread.php?t=2542219, this thread - http://forum.xda-developers.com/showthread.php?p=54855457#post54855457 and this thread - http://forum.xda-developers.com/gen...e-firmware-t3042687/post59139823#post59139823.
I tried RSD Lite on different computers and USB cables I could not get the device recognized. So I ended up with the MfastbootV2 method to reload stock firmware, which I found on the firmware thread above - this was big, as my phone is with Wind Mobile in Canada and the link is the right one. The only thing I picked up from a different website was to use a computer with USB 2 ports. This is what I did, but I don't know one way or the other if USB 2 was needed. .
Can't thank you hard working guys enough for the time you take to put these threads together. I'm back up and running. As a bonus, after a big clean up in the process, my phone is running fast again.
Thanks everyone.
I have this problem where phone randomly shuts down. It was fine until phone also stopped booting and getting stuck into fastboot mode. After this happened i had to visit repair shop. It works for few days and suddenly it again crashes and get stuck in fastboot mode.
I tried flashing with msm tool. it worked but after i updated to 9.0.5 and restarted it didn't boot again. Now flashing with msm tool isn't working as well but earlier it did.
So my two questions are:
1. why my phones keep crashing and stops booting?
2. Why msm tool is not working again when earlier it did?
Hello everyone,
I have a European H870 and unlocked the bootloader, used ADB/FASTBOOT to install TWRP but could never get to start in recovery because of a warning screen that shows up because it is unlocked.
Couldn't get into recovery from both ADB or by utilizing the keypress method. Vol-down+power --> logo --> release power for 1 sec then back on it. I even tried with other variants of that but could never get into recovery or DL mode. What's the point of unlocking the bootloader if you can't do anything afterwards because of a stoopid warning screen?
I never had that issue with my Samsung Mini S3. But with the LG's that I have, since the bootloaders were locked, the phones display this warning screen upon powering up. I can't be the only one with this issue unless I was doing it wrong. But I wasn't. So...anyway.
So with my G5 H850 I got around this problem by using FASTBOOT FLASH RECOVERY TWRP*.IMG and then FASTBOOT REBOOT before using ADB REBOOT RECOVERY during the boot process to get into recovery before the phone had fully booted.
So I tried the same with the G6 H870, of which I also cannot get into DL mode or recovery because of this screen. The only difference was that there is something different about how the H870 loads the system so that I could not run ADB commands until the phone was already 100% booted and thus rendering my recovery flash useless.
I ended up doing something that caused my phone to always boot into fastboot so I downloaded what I thought at the time was the correct boot.img and flashed it. And now I'm at the current situation where the phone boots past the warning screen and into the logo screen but then stops for a few minutes before rebooting. This process endlessly repeating. It is obvious to me that the boot.img was incorrect.
So what I have done so far is loading all Qualcomm drivers, LG drivers, QFIL and QPST (drivers being installed or uninstalled for each instance that requires them). The problem now is that the phone shows up on a COM port but is is unrecognized to all the different software and thus can I not communicate or flash anything to it.
A couple of unbricking procedures that I tried are:
https://forum.xda-developers.com/lg-g6/how-to/lg-g6-unbrick-method-t3935924
https://androidmtk.com/use-qpst-flash-tool
There were more but I cleared my browser's memory.
So, do I need to invest in an Octoplus device to get past this or is there another way?
Thank you.