QCN file for Lenovo K32C36 - Android General

Hello, can anybody provide the QCN file for lenovo K32C36?
I bought my Lenovok32c36 from China. As I was always getting an error message "process com.android. phone has stopped" and the only thing I could do was to restart the phone, I decided to switch to A6020a46 FW.
However I haven't backed-up my configuration data (IMEI code, etc) in form of a QCN file, so after flashing I lost my network settings i.e. no signal on none of the SIM cards.
I solved this by making QCN back-up from a working A6020a46 phone (from a friend of mine), then replaced his IMEIs by mine hoping that after restoring that QCN file on my device everything will work again.
And almost it did..but only almost..
It seems there is still some problem somewhere, because on one of the SIM cards the call will always be interrupted after ~ 30 seconds.
I suspect there must be some slight difference between the european version of the phone of my friend and my chinese one. E.g. he's got 2 IMEI codes on his device whereas I have got only one. And accordingly I do not know exactly how to replace his two different IMEIs in the QCN file by mine signle one. I tried already more variants: 1) I adapted slightly the last digit of my original IMEI code to get the 2nd one different, and this works partially but as I mentioned with interruption of the call on one SIM after ~ 30 seconds. 2) I tried to put my single IMEI into the QCN file twice (same IMEI) - with this only one SIM will connect to the network and the 2nd one gets no signal.
Any ideas?

Related

Resco tools and broken IMEI

Got my brand new HTC Touch Cruise the other week and it was working great. I then decided to try and Geotag my photos which apparently is as simple as changing a registery value. So off I go and download the trial of Resco Explorer 2007 and reg editor from their website and change HKLM\Software\HTC\Camera\P9 »Enable« to 1
Soft reset the phone and then the phone no longer connects to the network.
(The geotagging feature of the camera worked fine too.....)
I uninstalled the tools, did a hard reset and reloaded the original ROM to no avail - the phone still refuses to connect to the network (Telstra NextG - Australia) which it was working fine with before. I have also noticed that when there is no Sim in the phone the IMEI does not agree with the one on the back and when the Sim is in it says the IMEI is "Not Support"
Any help would be appreciated, I'm missing my new toy already!
Do a Hard reset and your problems should be gone. Easiest way is "Settings > System > Clear Storage > 1234". Remember to sync your contacts before you do it and good luck
I'd already tried a hard reset and loading the latest ROM (Which was the same as the one it shipped with) but that did not work.
Just tried doing it again the way you suggested and it's still broken.
Also on further inspection my IMEI when it doesn't have a SIM in to is almost the same as the one of the back but just has an extra 01 on the end. It still says "Not support" when I have the SIM in it though....
All sorted out.... It seems it was an issue with Telstra(They said they had a brief outage, and for some reason my SIM didn't reconnect to the network until they gave it a "Kick"), not the phone that just happened at the same time as I was editing the registery. Talk about bad luck......
TMBomber said:
All sorted out.... It seems it was an issue with Telstra(They said they had a brief outage, and for some reason my SIM didn't reconnect to the network until they gave it a "Kick"), not the phone that just happened at the same time as I was editing the registery. Talk about bad luck......
Click to expand...
Click to collapse
Yes so next time your Polaris not working so blame always your operator if the device dont connect, The imei cant NEVER chance with a registry chance what ever you do with the device the imei never changes, with that numbers you cant mess with
you said the imei changed when you have the sim card inside and evidently you couldn't connect to the network because of that... so deosn't that implys there's a 'possibility' that bypass the hardware imei by doing something to the sim? we might be on to something here guys..

[Q] No network connection

I've been trying to fix my sisters SGS2 Skyrocket all day today to no avail. Ive searched high and low for a solution to my problem.
Basically my problem is that my sisters cell phone will not connect to the ATT mobile network.
Current phone status:
Current version is 4.1.2 Completely Stock
baseband version (I727UCMC1)
Network: Unknown
Signal Strength -95dBm 9 asu
Mobile Network Type: Unknown:0
Service State: Out of Service
Mobile Network State: Disconnected
My Phone Number: x-xxx-xxx-xxxx (the correct number)
IMEI: 3572xxxxxxxxxxx (the correct imei)
IMEISV: 10
When I try to make phone calls it states "Emergency Calls Only"
I can sometimes recieve SMS messages around 45 minutes after they have been sent (which is pretty weird that I get them at all)
It is not a SIM card error, I even went today and got a new SIM card from ATT just to be sure.
I tried calling ATT they did some stuff to it, not sure what. At one point after a fresh restart I was able to make a phone call
and it went threw, hanged up waited a few seconds and tried again and it would say "Dialing" but would not reach an outside line, and the call would end before ever connecting. the ATT tech person said they would put my phone on some kind of list for their tech pros to look at and would get back to me within 5 days. I do not have much faith in that.
I have tried changing the APN settings, tried factory resetting, tried installing CWM recovery and flashing a new modem.
When WIFI is off, the only icons I see are the signal bars with 1 or 2 bars in it, No data connection. Earlier when they were messing with it
4gLTE popped up, and appeared to have a connection but the browser did not work, and I could not make a phone call/send texts.
If anyone has any new suggestions that I can try, im all ears! Thanks for reading!
I'm going to try this:
25d) My phones not behaving normally and I tried methods above still not resolved.
Ok try this:
remove sim(eliminates sim card issues)
remove external sdcard
backup internal sdcard then format(fat32) it
then perform a full wipe: read q.26
copy ucmc1 radio onto sdcard and flash it twice w/out cable plugged in
then use odin to flash jb stock firmware x2.
if still having issues after doing this then its some kind of hw failure, what hw failure idk, could be most likely emmc (memory) failure
This also ended in failure.
Ryan92394 said:
I'm going to try this:
25d) My phones not behaving normally and I tried methods above still not resolved.
Ok try this:
remove sim(eliminates sim card issues)
remove external sdcard
backup internal sdcard then format(fat32) it
then perform a full wipe: read q.26
copy ucmc1 radio onto sdcard and flash it twice w/out cable plugged in
then use odin to flash jb stock firmware x2.
if still having issues after doing this then its some kind of hw failure, what hw failure idk, could be most likely emmc (memory) failure
This also ended in failure.
Click to expand...
Click to collapse
most likely but not definitive - either sim card tray or antennae problem, search with those key words for possible fixes

Samsung G900-F Big problem!Please help

Hello all!
I am in possesion of a Galaxy S5,that has a very special problem.
It got to me restarting periodicly (15sec to 3 minutes) an a forbidden sign instead of signal icons.I tried houndreds of firmwares,most of them failed at writing in odin.When I type *#06# in order to get the imei it shows null/null,and also it has no baseband(signs of missing efs partition).Here it comes interesting: after some charging cycles,it suddently works,shows the signal icon and missing sim message..if i restart in order to put a sim in,the problem gets back.It worked for a day in a particulary case with a sim card in,but he restarted when i put in the mobile data settings,and then it get back to the null imei/unknown baseband.
Please give me some answers or solutions...Im desperate
Best regards to all of you
MadelOFF

S6 edge :not registered on network

Hello,
I had a boot problem with my G925I phone
After several tries using many firmware, I succeded flashing it using G925IDVU3EPC8_G925IODD3EPC2_INU (using odin)
The problem now is that I'm not able to make call, I'm getting not registered on network
I have verifyed that the sim card is well inserted (i can see my contacts list) and when trying to manualy serach for network, i can see my network
please help me
Where are the experts.
I'm blocked
Maybe the IMEI gone. That's the hard part.
Sent from my SM-N920C
Check your imei,too see if it is still original,if it is 36000.....1 you in trouble
There is two ways to fix this but there is only one way working good
1 send it to Samsung (this way works good)
2 repair it with octopus box (this will get phone to work but you will loose signal during taking on phone or without .
and flashing stocks will get you in bootloops basically your phone is piece of junk)

Samsung Galaxy Note 2 - Lost IMEI and EFS

Hi,
My Samsung Galaxy Note 2 is rooted for couple of years. Currently running AICP ROM, Version 12.1-NIGHTLY. TWRP is installed and functional.
Couple of weeks back the phone stopped connecting to cellular networks. The SIM Card is not defective - it is working on another phone. (Even on this phone, the operator is recognised, but the signal strength is always zero.)
Otherwise the phone (?) is working fine. I can connect to WiFi and all other Apps works fine.
On checking for IMEI, it is showing fake IMEI - 004999010540000. This is not what is printed in the battery compartment. The EFS Partition is empty.
Samsung Service centre has suggested replacement of the motherboard. The cost is prohibitive factor.
I had a nandroid backup of the original ROM, however, the microSD Card has become corrupt and the backup is lost. (Original EFS Partition is no more available.)
I tried to connect the phone to ODIN/Samsung Kies, however, the phone is not connecting to these softwares. (I can browse the phone through file explorers on my computer and also copy-paste files.)
Is there some way in which I can restore the phone to working state? Or, I need to change the motherboard - as Samsung Service has indicated?
Thanks.
Vikas Garud

Categories

Resources