Hello guys,
I am in a really difficult situation here and i really need your help,
I am the owner of a Lenovo Vibe shot Z90a40. This phone had initially a chinese rom so i flashed a s240 ROW rom without any problems and it was just fine. Yesterday i found that there was an android 6 update (OTA) so i choosed YES (bad choice). The rom was downloaded, installed and when the phone rebooted it turned of by itself.
I powered it on again, stays in initial screen for 1 sec then vibrates for 2-3 secs and it shutdowns again.
So i tried to flash the previous rom again FAIL
the internal storage says write protected so flash (with Miflash generate a write protect error), i cannot access adb because the phone doesn't boot, cant use the sdfuse method (update from internal storage) because i cannot write anything to internal memmory and when i try to update through sd at about 50% says update fail.
I have tried every rom availiable no luck. I can see the internal partitions on my pc but can't access them.
Basically the problem is the write protection on internal storage.
I would really apreciate any advice,
Thanks in advance
Jimakosk said:
Hello guys,
I am in a really difficult situation here and i really need your help,
I am the owner of a Lenovo Vibe shot Z90a40. This phone had initially a chinese rom so i flashed a s240 ROW rom without any problems and it was just fine. Yesterday i found that there was an android 6 update (OTA) so i choosed YES (bad choice). The rom was downloaded, installed and when the phone rebooted it turned of by itself.
I powered it on again, stays in initial screen for 1 sec then vibrates for 2-3 secs and it shutdowns again.
So i tried to flash the previous rom again FAIL
the internal storage says write protected so flash (with Miflash generate a write protect error), i cannot access adb because the phone doesn't boot, cant use the sdfuse method (update from internal storage) because i cannot write anything to internal memmory and when i try to update through sd at about 50% says update fail.
I have tried every rom availiable no luck. I can see the internal partitions on my pc but can't access them.
Basically the problem is the write protection on internal storage.
I would really apreciate any advice,
Thanks in advance
Click to expand...
Click to collapse
Hi,
I couldn't find much information about your device here except this thread
Lenovo Z90-7 (VIBE SHOT) - International (ROW) ROM, multilanguage, GAPPS
Try posting your query there. Experts there may be able to assist you.
Good luck
Art Vanderlay
XDA Assist
Related
I tried to install cwm at my friends zte to change the rom because he wanted playstore an i think i bricked it using some scripts i found that were made for the v9180 model .The phone now has black screen when i power it and nothing happens. I cant enter bootloader or fastboot so i think i have hardbricked it. Only when i put the battery while i have it connected to mypc it shows 12 partitions and windows asks to format them to open except two of them that have files. the one partition has a folder called image with 55 mb size and the other is the internal storage. if someone can help me i would be grateful because i already spend 12 hours searching to restore this awful device because i never say no when someone asks me to help him. Any help would be appreciated.
notisz said:
I tried to install cwm at my friends zte to change the rom because he wanted playstore an i think i bricked it using some scripts i found that were made for the v9180 model .The phone now has black screen when i power it and nothing happens. I cant enter bootloader or fastboot so i think i have hardbricked it. Only when i put the battery while i have it connected to mypc it shows 12 partitions and windows asks to format them to open except two of them that have files. the one partition has a folder called image with 55 mb size and the other is the internal storage. if someone can help me i would be grateful because i already spend 12 hours searching to restore this awful device because i never say no when someone asks me to help him. Any help would be appreciated.
Click to expand...
Click to collapse
Same prolm is here no where is unbrick feeling bad
So I own a micromax a106 which used to run on a kitkat 4.4.2 (i had root acces and custom memory allocation no roms though) just this morning I recieved the update from Micromax after installing the update my phone booted fine and was running on lollipop, but I noticed that my internal storage had been reduced from 7.42 Gb to 5.41 mb out of which only 2.21 mb was available for use. So i thought about reallocating the patition I opened SPtools I backed up my phone loaded my custom EBR files, downloaded and inserted my phone after removal of battery. But it didnt detect so I thought i'd switch it on and shut it again. I tried to turn it on but it was stuck on the logo screen. I went to recovery cleared all cache and did a factory reset but now the damn phone doesnt even switch on, i cant access recovery nor turn it on even. if i connect it to my pc it makes the detetion sound then it makes the 'usb removed sound' and it goes on like a loop. please help me
I had done memory repartition and root access when i was on kitkat but now it;s messed up on lollipop. Please help me to get it running.
Hi, thank you fro using XDA Assist. Re-partitioning your phone can be tricky and can lead to bricks. You may have a bricked phone. But see if you can get help here, http://forum.xda-developers.com/showthread.php?t=2792954
I am using micromax a37 bolt and it has only 107MB internal so I rooted it and used Link2sd app for putting every app into sd card and I did it but after doing that I ran into some problem with all apps suddenly stopped and I will end up factory resetting every time. This time I used mounts2sd and I created the startup script and init.d. When I rebooted for mounting the sd card second partition, it booted for more than 10 minutes so I factory resetted it. But after resetting also when I tried to boot, it boots for a long time. So I thought of flashing the stock ROM and I used it with sp flash tool but I get an error S_FT_ENABLE_DRAM_FAIL (4032). Now the phone does not show up anything when I pressed the power button or any combination but when I connect it to my computer it is detected and the sp tool gives same error. During the flash I first tried with a37 stock ROM but second time I wrongly downloaded a37b stock ROM from another site but I got the same error in both cases. I tried different sp flash tool versions. Here is the google drive link to logs folder
https://drive.google.com/file/d/0B0VHdfl5tDqZaC03ZEhTVWQ0RUk/view?usp=sharing
I am making this thread so that any one who are in a similar problem can get solution from someone who gets it. Thank you
Hi,
I can't find anything relevant on XDA for your device and issue, but you can ask for help here,
http://forum.xda-developers.com/android/help
Good luck!
Hello
I have an android device brand imobile model iq 6.6 when i purchased it and used it for about an hour it started misbehaving by opening apps automatically like browser, wifi,data. i tried to root this device to remove such annoying built in apps and after removing two to three apps i was using fb and device suddenly switched off i tried to turn on but it couldn't turn on it stucks on boot logo and restarts again and again.
I downloaded official rom both in sd update and through cable but i m not succeeded to install. When i try to install through sd card update it starts installation but after some times it gives som error and installation is aborted.
I also tried to install through smart phone upgrade tool but no success when i press volume up and down buttons and connect it to pc it restarts again and again so the process couldn't be started. I also tried sp flash tool but there is no scatter file inside downloaded rom so that process is also fail and thus im not able to recover my phone please help me.
Thanks developers.
Hi there and welcome to XDA.
I didn't find any info related to your problem, sorry. Try searching about that on Google.
You'll have to create an account to post in the main forums if you have any other questions.
Good luck
Hello,
I hope it is the right place to ask for help .... The automatic system update failed and now the tablet is stuck at Android System Recovery Screen. Wipe Data / factory reset does not bring the system back, so I guess I need to upload rom / update from sd card - I got option "apply update from sd card".
So, please, help me to recover from this situation as my tablet is stuck .... I do not have or could not find the right files to use with "apply update from sd card."
Or, any links to the tutorial for updating / uploading rom for this model will help ...
Thank You very much in advance.
Kindest Regards
Lukasz
I solved the problem by uploading the rom again.
1) SPF Tool + MTEK drivers for win
2) Official ROM
Just two things:
a) if SPF throws error you need to choose upgrade firmare not download
b) you need to take off the back cover and unattach the battery otherwise it will not work
Have a nice day
Lukasz
Hi !
Thanks for confirming that you solved your problem !
I will now move your thread to the dedicated section .
Cheers
Hi everyone. Just did the solution like what Luqpa_W said but my tablet is still bootlooping on lenovo screen. There is no problem during flashing and everything seems fine during flashing. I do not really understand what is the problem with my tablet. If someone knows how to deal with it, please let me know.
_____
EDITED: My tablet just got booted! After several times of reboot, it seems working. Thanks!