Droid Razr Maxx HD (XT926) Stuck on Setup Wizard - RAZR HD Q&A, Help & Troubleshooting

Hi XDA,
I have a Droid Razr Maxx HD (XT926) with Android KitKat 4.4.2 (183.46.15)
I want to upgrade to Android Lollipop.
I use Droid Razr HD Utility 1.21. On menu choice, I select option 1 - Flash 4.1.2 Stock System, Kernel, and Radio (Data Wipe) [from AP Fastboot] and it FAILED when sending "system" with log "Preflash validation failed", on my phone has log "Partition (system) Security Version Downgraded, PIV block validation for system failed, Invalid PIV Image: system" and when sending "boot" with log "Preflash validation failed" and my phone has log "Partition (boot) Security Version Downgraded, Preflash validation failed for boot". After that, it erasing userdata, cache and sending modem, modemst1, modemst2 and auto reboot.
After reboot, my phone gets to this first time Setup Wizard, when I press Start it shows, "Please wait, this may take a few minutes" and it gets stuck there . I have tried putting it on full battery and charger and leaving it to do so overnight and in the morning it still shows that message :crying: . Can you please help me to get past this Setup Wizard so I can use my phone again?
Thanks for all!

First, you can't upgrade, downgrade, or otherwise replace your firmware under 183.46.15, unless you had unlocked your bootloader before upgrading to that version. If your bootloader is still locked, then you're stuck. There is no known method for unlocking the bootloader under 183.46.15. Attempts to do so generally end badly, as you have discovered. You can, however, get root access.
Second, the method I would try to repair your phone is to use RSD Lite and reflash the stock firmware to your phone, the same version you had before. Any other version will fail to install correctly.

Related

Phone Stuck in Fastboot after Factory Reset & OTA Update

Background:
I was having issues with my front/rear cameras failing to initialize sometimes, so I decided to do a factory reset of my phone. I was on 9.18, both rooted and unlocked (I unlocked prior to going to 9.18). I was able to use the RAZR Utility to downgrade to 4.1.2 and then root again. However, when I did the OTA update for my phone, the update failed and now my phone is stuck in "AP Fastboot Flash Mode (S)".
On the Fastboot screen it reads:
downgraded security version
update gpt_main version failed
failed to hab check for gpt_backup: 0x35
failed to load GPT
CID Read Failure
Invalid CID status 0x69
No SP partition found
Fastboot Reason: Invalid GPT
I have tried using RSD Lite to go to 9.30, but it keeps failing (I may be doing something wrong...). If anyone could provide any help, it would be greatly appreciated!
** Solved **
Used bweN diorD's modded utility to reformat the GPT partitions, all is well.
http://forum.xda-developers.com/showpost.php?p=49376894&postcount=6

Stuck in recovery <3e>

I tried flashing Kitkat from 4.3 using the Minimal ADB and Fastboot method and after rebooting, my phone didn't start and is stuck in recovery mode, not the CWM i had previously installed, just the default Android system Recovery, tried wiping everything but no success.
I have x1032 with 4.3 rooted and bootloader unlocked, also CWM installed now i don't know what to do, please help, how do i make my phone functional again?
thanks
edit: i can boot fastboot mode too but none of the options work, tried reflashing KitKat with the same method and this is what i've found
when i put ''mfastboot.exe flash partition gpt.bin ''
it says
''(bootloader) preflash validation failed
FAILED (remote failure)''
and the phone says ''version downgraded for primary_gpt''
then i get these error while putting the other commands
''hab check failed for boot''
''hab check failed for recovery''
''hab check failed for system''
''Invalid PIV signed system image''
Check the forum, it's all there.

[MOTO G] XT1032 black screen after booting up [can be closed]

Hello there,
after booting up the phone (Android 5.0.2), the screen turs black (with backlight), becomes warm over time and reboots, no input possible.
I've read almost any post about that problem but nothing helped. I dont know how that problem happened, nothing unusual happened.
At first, i tried booting into bootloader and used there
- Normal Bootup -> booting up with same problem
- factory -> booting up with same problem
- recovery -> "bootup failed"
- barcodes -> Showing barcodes with Informatios (IMEI, Model No. ...)
- QCOM -> booting up with same problem
- BP Tools -> booting up with same problem
So i successfully unlocked the phone (Code 3, warranty was already over) to install the stock recovery -> Success, booting in recovery displaying "no Command". (waiting and then press power and vol. up get me into recovery). Then, i tried to install custom recovery (TWRP and CWM), the log on Phone says "mismatched partition size" but no errors, CMD says OK [...] OK.
Booting in Recovery -> "No Command" no matter what recovery i had flashed.
Booting an recovery out of CMD with "fastboot boot recovery.img" works for twrp-2.8.7.0.-falcon_GPE.img.
Doing "Factory reset with swipe" gives:
Updating Partition details...
E: unable to stat '/data/data/com.google.android.gms/sharedprefs/checkin.xml' other errors concerning '/data/data/com.cleanmaster.mguard[...]'
E: unable to open '/cache/recovery/.version'
MTP Enabled
but it has done factory reset. Trying to mount and send a custom firmware to SD results in error, device not responding.
Formatting data has failed with same errors as above (E: unable to ... '/data/data/[...])
The folder cant removed due to:
E:rm -rf "/data/data/com.cleanmaster.mguard" process ended with ERROR=1
Next, i tried to flash the Stock firmware (im from Germany, it was an O2-Promo with Google play) "XT1032_FALCON-O2DE_5.0.2_LXB22.46-28.1_1_cid7_CFC_1FF.xml.zip" with fastboot and mfastboot.V2. No errors from CMD, log on Phone wrote sometimes in purple "Image Size too big", but no errors. Wipe user and wipe cache, then reboot, no success.
I've tried many other firmware versions (EU and DE only, Lollipop and KitKat) step by step for each instruction with fastboot, also no success.
It seems that the write operations take no effect, even erasing partitions like recovery only displays on CMD
erasing 'recovery'...
(bootloader) Erase allowed in unlocked state
OKAY [ 0.031s]
finished. total time: 0.031s
without any effect, stock ercovery remains there, but the phone is unlocked. Now i dont know how to move on anymore, after working on the phone for 7 Hours.
Can you, the experts on XDA, help me? If needed, i can post more informations...
EDIT: It seems to be a hardware error caused by internal SDcard. Ordered a new phone, thread can be closed.

XT925 Bricked won't flash

I had tried RSD and fastboot and it won't flash it's from Telcel Mexico I tried the Retail Brazil Full JB and Mexico JB and nothing I had also tried to unlock the bootloader but I get an error messages saying this device is not eligible to unlock bootloader some message like that
this is the error message I'm getting when I try with RSD
downgrade security version
update gpt.main version failed
preflash validation failed for gpt
and when I try with Fastboot I get send ok but faile at writing on every line
a message that says failure remote something like that
help please
XT925 Still won't flash
I was able to unlock bootloader but still giving me the same exact error messages when trying to flash
How did you unlock the bootloader?
I know about "fastboot oem get_unlock_data", but in my case this command returns that wasn't possible get any information.

XT1045 Cricket - Stuck in fastboot, everything fails

XT1045, so I can't unlock the bootloader. The phone does not accept any available XT1045 image, and rejects the boot and system partitions with "hab check failed for boot", "hab checked fialed for recovery" and "Invalid PIV signed system image". Is there any way to fix it? Any stock firmware available to flash? After failing the flash, the phone reboots into fastboot again, with reason "Fall-through from normal boot mode"

Categories

Resources