Hi, I'm experiencing problem with my phone. On the left top corner of front panel the display is uneven to the rest of the design. I mean, I can push the display inside a little in this corner. Also it's uneven to bezel. I sent phone for repair, I got display replacement but the issue is still there.
Is anyone experiencing or experienced something similar to my issue? I tried demo units in shops and most of them had the same problem with screen.
Related
I just went to Verizon and replaced my thunderbolt. However it seems the corner is broken, it doesnt seem to be attached to anything and there is some light leakage, Has anyone else had this problem?
What do you mean by broken corner? Just having light leakage? If that's the case, it's relatively common. You can either keep returning till you get a good one, or do like a few of us and buy some black caulk and seal it up that way. I did this and I don't have any issues with it and you can't even tell that I did anything to it...even if I tell you to look for it.
If I push harder then normal I can see some lcd squirm in the corner plus it seems to be slightly off, but I might just be insane. If I can find a way to show it in a pic I'll upload it
Might want to take it back.
Sounds like there may be a defect. I would suspect there is an issue. I have pressed and not seen the any interference with the LCD, or any movement.
I have these problems with the screen, it suddenly appeared a blurry area in the center, which was appreciated more in the low power mode, progressed with a black line and I dont know why because I never wet the clock.
this is how a defective LCD unit looks like. You have a bunch of dead pixels there. This is happening with some screens if you put pressure on them, sometime by shock and some other times they just die. You need to seek a replacement because that problem will not go away.
I had a phone with exactly the same problem and the only cure was to replace the screen. In this case, you need to replace the watch.
I seem to be experiencing glass separation on my S5. It is occurring on the left top border near the volume buttons and extending downward to just past the middle of the phone. It is still enough along the edge to where it hasn't made it to the screen yet. It appears to be getting close though. Has anyone else been experiencing this? Since it isn't affecting the display (yet), is this considered a warranty issue?
Yes, i noticed the same thing on my s5, except mine id happening just to the left of the speaker. I will be calling samsung today to see if it is ann issue covered by warranty.
Hi all
My moto Maxx has gone through a lot, but the strangest problem yet started yesterday.
As you can see on the attached video, half of the screen is constantly scrolling. This happens in fastboot and recovery mode as well, so I'm pretty sure it's a hardware problem.
The digitizer still works perfectly, and registers touch where the icon or button should be positioned on the screen. The moving screen also does show everything correctly, just in this crazy scrolling way.
I'm not very hopeful in fixing it, but was wondering if anyone has ever seen this, and if you guys think this is a broken display(and any way to test this?) or a broken GPU. If it is in fact the display, I might consider replacing it.
Some background on all the terrible things I did to this phone:
- Dropped it and cracked screen in September.
- Replaced the glass myself, slightly burned display when removing glass without any consequences (just a tiny mark on the top right, the side that actually still works).
- Dropped again, broke glass again, never bothered to fix it, some small pieces are missing so dust, sweat,.. could've gotten int.
Video:
Most likely the display being broken.
Even when my tempered glass protector is missing chunks the screen starts to funk up. Only worse being the real screen especially the digitizer.
You might be right pjd, or at least screen related.
I opened it up yesterday evening, and I think it might be the cable connecting the screen. Depending on how I positioned the screen and thus the angle at which the cable was bent, it was fixed, the same, or just completely black.
The only thing I have to try to find out now is if it's the kabel, or the connector on the motherboard. Any suggestions on how I could test that are welcome!
I've had my phone for a few days now and noticed a clicking sound every time that I remove it from my case. After some investigation it seems to be due to something internally with an adhesive surface that isn't staying stuck. If I press moderately hard on the center of the left edge I can reproduce the click, and it feels like it gets "unstuck" after a few seconds. Does anyone else have this issue?
Same issue here
So far it just seems to be a minor annoyance. I can forgive it because this display is so much better than the previous Galaxy S phones that I've had. Almost all of them had grey blotches on the screen when viewed in full sunlight. No such problem on this phone.