Bricked Phone
I unplugged my phone while it was flashing with the lg flash tool 2014 by accident wrong cable and its stuck at the lg logo and I cant get into download mode help please!!
Related
My LG G2 D800 was bricked.
bootloop at LG logo and can't get into download mode, it stuck in "small download mode". in small download mode, PC does recognize driver.
everyone help me to unbrick it?
thanks so much.
I have Lg e440 = LG L4 II
i was using it one day like a week a go then it booted into hard reset mode and started doing it and restarted and stuck at lg logo from that time
I used LG flash tool 2014 to flash kdz V10F_00 UAE and the tool force close after kdz extract that is in CSE flash mode = log attached
2nd = i used Normal flash mode the force close is gone but it stop at 5% when flashing the kdz and say connect the phone to pc and it is connected and it is there in device manager and every thing is ok and i have latest drivers
what i did = 1. used cdma and 3GQCT mode no change
2. i have all drivers installed right and the phone read right because i own LG G2 D802 and i use the flash tool a lot
3. connect and disconnected the phone a lot in 2nd try but no effect
3. i try to do hard reset but no effect it just restart and stuck at lg again
4. i cant find any other thread with same problem that i can find
I need help for my old LG E440
Thanks in advance
and sorry for my bad English
View attachment Log2.txt
No one can help ?
Hi, thank you for using XDA Assist. There is not much activity on XDA about your device. But see if someone in this thread can help, http://forum.xda-developers.com/showthread.php?t=2775750&page=14
help
I have Lg e440 = LG L4 II
i was using it one day like a week a go then it booted into hard reset mode and started doing it and restarted and stuck at lg logo from that time
I used LG flash tool 2014 to flash kdz V10F_00 UAE and the tool force close after kdz extract that is in CSE flash mode = log attached
2nd = i used Normal flash mode the force close is gone but it stop at 5% when flashing the kdz and say connect the phone to pc and it is connected and it is there in device manager and every thing is ok and i have latest drivers
what i did = 1. used cdma and 3GQCT mode no change
2. i have all drivers installed right and the phone read right because i own LG G2 D802 and i use the flash tool a lot
3. connect and disconnected the phone a lot in 2nd try but no effect
3. i try to do hard reset but no effect it just restart and stuck at lg again
4. i cant find any other thread with same problem that i can find
I need help for my old LG E440
Thanks in advance
and sorry for my bad English
http://dl-1.va.us.xda-developers.com/3/3/3/2/9/8/7/Log2.txt?key=wpadtwlOpunqazL_YrY-eg&ts=1432857652
yesterday i unbrick my qhusb 9006 g2 but when i try to flash it with lg flash tool i got error mesage
battery low level 0%
phone not charging when plug charger in stuck on bootloop
any help phone was dead since 2 months
the phone will charge on bootloop the same happen for me just let phone at charger for one hour even with bootloop it will charge just wait ....i was able to flash stock with 7¨G battery
Dear friends,
I am in deep trouble. Few days ago I have flashed CM rom on my LG G3 F400L. Now the problem is after waking up today I find my set totally dead. I can't enter into recovery mode with holding buttons. The phone stucked into LG logo. Tried many times to flash with LG flash tool. But it says download fail, device model is different.Check ur phone or dll. Tried generic dll but not working. Any help will be much appreciated. Thanks.
Hi I have a LG Sp200 (Sprint) that I cross-flashed a LG K8 (2018) KDZ using LGUP and everything was working fine until I attempted to root the phone by flashing a LG m250DS KDZ. Before flashing the final kdz that bricked my phone, I did make a backup by dumping my firmware using LGUP but I'm not sure how to flash them since my phone is completely dead (no download mode / recovery / boot) The only thing my phone does is show up as LGE mobile serial port, LGE mobile modem port, and MTK usb port. If anyone has any idea or advise on how to get this phone back up it would be greatly appreciated. Thanks
send dump fw
kings1988 said:
hi i have a lg sp200 (sprint) that i cross-flashed a lg k8 (2018) kdz using lgup and everything was working fine until i attempted to root the phone by flashing a lg m250ds kdz. Before flashing the final kdz that bricked my phone, i did make a backup by dumping my firmware using lgup but i'm not sure how to flash them since my phone is completely dead (no download mode / recovery / boot) the only thing my phone does is show up as lge mobile serial port, lge mobile modem port, and mtk usb port. If anyone has any idea or advise on how to get this phone back up it would be greatly appreciated. Thanks
Click to expand...
Click to collapse
could you send me copy of the dumped fw?
never another mediatec
anyone gotta fix...i flashed wrong as well on my sp200....ive spent hours trying to use the sp flash tool with no avail..i cant come up with a good scatter file and i keep getting brom error 006003 ....only recognized on pc for like 3 seconds then nothing..help
same situation here ..
no SP FLASH TOOL firmware , no scatter , no AUTH FILE
Sp200 not bricked?
Please some should kindly help me.. I flashed SP200 with K8 rom, wanting to unlock it, but now wen you on the Sp200 it will show K8+ logo n then move to black screen where"[LGE] [Recovery] [OP Image] op_status: 0 Supported API: 3" keep popping at the base of the screen.
I will love to hear from you soon..
Thanks