I recently dropped my TF300 (in the process of jerry-rigging a carrying case for it, might I add) and it happened to shatter the glass and tear some of the ribbon for the digitizer, rendering it completely useless. The LCD beneath is fine, in fact I have already separated the LCD from the digitizer itself.
My question is:
Can I buy a replacement digitizer for the TF200 and install it to my TF300?
They seem to be the same ribbons and i'm sure the dimensions are the same.
The problem is the digitizer for the TF300 is around $150 and just $50 for the TF200.
Dude word of advice only buy the tf300 glass. But replacing it will be a pain but good luck to you
Sent from my HTC Ruby using xda app-developers app
Almost sure,,
Hello hello,
i recently smashed up the same digitizer of my tf300t. There are no videos about opening the thing, so i proceeded and could unplugged the digitizer without any complication. So, after long searching i found ur question and realize that the connector is just the same. I'm almost sure that tf200 should work properly with tf300.
best regards,
Abrhm
Not the same
I'm sure you have probably figured this out by now, since it's been months, but the TF200 and the TF300 digitizers are indeed DIFFERENT.. And the TF300 can be procured pretty easily these days for about $70.00..
So, this is for the benefit of anyone else who happens to stumble across this post.
Also, heed, there has been a significantly high rate of folks, myself included, who have changed the digitizer out only to find that the touch-screen still doesn't work due to some other issue..
hi,and thanks for having me on the forum. I have cracked my digitizer for a while now and recently decieded to change it. I heated up the screen as shown on simaler model but went wrong and lifted part the lcd with it damaging it. I had orded the lcd and has recently arrived. I cannot find anything regarding the fitting of lcd. Does anyone know if the lcd is meant be fitted from back phone or front? thanks
Hey all,
Client brought in a TF300T with a cracked digitizer, good LCD, but no touch response. Changed digitizer, everything works but touch. Original digitizer has no "G0_" number on it, but replacement is a G01.
Because the digitizer wasn't working in the first place, would this be a bad digitizer PCB? I've been searching forums for the past hour but haven't found any fixes for this particular scenario. Attached are images of the digitizers.
Thanks!
I've replaced the digitizer of this tablet and after a while it's showing up a horizontal line across the screen. How can I solve this? The lcd was in good condition I've tested digitizer numerous times before I re-assembled the tablet.
I have an old TF 101 with a Smashed screen. Both the LCD and digitizer are done for. I still have some data I'd like to get off, without having to buy a new screen kit. Can anyone suggest how to gain access? I am guessing through the HDMI output, but what about screen control, if the digitizer is broken?