Hi
I had my Samsung S3 phone accidentally reset by a child and in an attempt to try to recover data I rooted the phone.
Model Number: GT-I9300
Android version: 4.3
Baseband version: I9300DDUGNB1
Kernel version: 3.0.31-2363855
[email protected] #1
Fri Dec 27 20:00:26 KST 2013
Build number: JSS15J.19300XWUGML4
SE for Android status: Permissive
I dont remember what mistake I made while unrooting, I get to see the flash counter still reading as follows:
ODIN MODE
PRODUCT NAME: GT-I9300
CUSTOM BINARY DOWNLOAD: Yes (1 counts)
CURRENT BINARY: Samsung Official
SYSTEM STATUS: Custom
Phone was bought in India. I am in Australia now.I need to get it back to stock and also make sure it is able to work with
apps which are used locally in Australia. Please help me with directions. I already bought Triangle Away but
it says that it requires root which is not currently there. Do I need to download custom binary and root it again
and then do an unroot? But I am scared that somewhere I read that devices with 4.3 come with the security
software Knox which doesn;t allow the counter to be reset though you unroot the phone. Help please..
Hi,
You must ask in the dedicated forum for this device, but first you must see what exactly model of S3.
Here is general forum for Q&A dedicated to Galaxy S3 I9300/9305:
> Samsung Galaxy S III I9300, I9305 > Galaxy S III Q&A, Help & Troubleshooting
Or ask directly in this thread: [HELP THREAD] Galaxy S3 Ask any question.
Also please see this tutorial: [Tut] Unroot the Galaxy SIII (for stock updates/warranty)
Good luck
Related
hi guys well ive tried every possible to flash back to stock but i cant... every time i trie to flash the md5. tar file this pops up on my download mode on the top left corner...everything is being done right... i get this on my samsung screen:
PRODUCT NAME: SGH-M919
CURRENT BINARY: CUSTOM
SYSTEM STATUS: CUSTOM
KNOX KERNEL LOCK: 0x0
KNOX WARRANTY VOID: 0x1
CSB-CONFIG-LSB:0x30
WRITE PROTECTION: ENABLE
EMMC BURST MODE ENABLED
START[224,1440]
SW REV CHECK FAIL:FUSED: 5 BINARY: 1
IT SOFT BRICKS SO I HAVE TO FLASH THE CURRENT CUSTOM FILES IM CURRENTLY IN AFTER DOING THE PROCESS AGAIN...
ANY SUGGESTIONS?
help would be greatly appreciated
Hi,
I suggest you ask for help here, it's an ask anything thread for your device...
> T-Mobile Samsung Galaxy S 4 > T-Mobile Samsung Galaxy S 4 Q&A, Help & Troubleshooting > [HELP THREAD] Samsung Galaxy S4 T Mobile Version | Ask ANY Question | Noob Friendly
Good luck!
Hi,
I've rooted my Android device some time ago. And now I can't receive the Official Software Updates. I've found a App called "Triangle Away" to Flash the Status back to Official. But it says to make sure that you are running "Stock (Samsung) Kernel" or It'll brick the Device. So just want to make sure if I'm running on what it requires and without Bricking the device.
Device Info,
Name: Samsung S4
Model: GT-I9505
Android Version: 4.4.2
Status: Custom (Official before root)
AP: I9505XXUGNJ1
CP: I9505XXUGNJ1
CSC: I9505TNZGNJ1
If any more info is needed please ask.
Hi there,
Rooting your device only give acces to the root of your device, didn't change you kernel. But by rooting you will not receive any official updates.
For more answers please ask directly here:
[HELP THREAD] Galaxy S4 | Ask any question | Noob friendly.
Good luck
I have a galaxy s3 I535 4.3...
the device had been rooted with a custom rom instlled...
I attempted to install a new custom rom and now I can only get the device into download mode...
this may be referred to as a soft brick but I'm not sure...
either way I'm pretty sure I'll be required to use Odin...
I believe I may have to repartition the device and reinstall everything else...
my issue is mostly this, I'm not sure what files to use or where to get them from...
if anyone can provide me with links to these files and or a video I would greatly appreciate the help...
Odin mode (red)
Product name: SCH-I535 (white)
Custom Binary Download: Yes (1 counts) (white)
Current Binary: Samsung Official (white)
System Status: Custom (white)
Qualcom Secure Boot: Enable (grayed out)
Warranty Bit: 1 (red)
Bootloader Rp Swrev: 1 (grayed out)
Hi there
You'd be best served asking for help from the experts who own your device, here
> Samsung Galaxy S III I9300, I9305 > Galaxy S III Q&A, Help & Troubleshooting > [HELP THREAD] Galaxy S3 Ask any question.
Good luck
Hello there! I would like to ask if there's a way to update my phone even tho my Knox is tripped already. I'm looking for a lollipop rom or any other custom rom better than kitkat THANK YOU in Advance
Phone Details:
Model No: SM-N900L (Korean VAriant)
Baseband: N900LKLUFNK1
Kernel Version : 3.4.0-3171410
Hi there,
All you need is in this thread:
Full guide on how to unroot and go back to official stock firmware for Galaxy Note 3 SM-N900/N9005/N900T/N900W8
Also you can review this thread: [Q] Unroot N900, but which firmware?
For more questions please ask in this forum: > Samsung Galaxy Note 3 > Galaxy Note 3 Q&A, Help & Troubleshooting
Good luck
Hi i'm kinda new in rooting procedures.
i was currently running a rooted 4.4.2 on my Note 3 N9005XXUENA2 bought 2nd hand
XEO as active CSC code. found in Phone INFO samsung app.
PDA version : N9005XXUENA6
CSC Version: N9005OXXENA5
Baseband Version: N9005XXUENA2
I was kinda wondering do i have to unroot this and update to lollipop before rooting it again?
or kindly jump straight to rooted Lollipop instead.
kindly please guide me or teach me the procedure. Thanks a bunch
Hi,
Try posting your question here:
Galaxy Note 3 Q&A, Help & Troubleshooting
The experts there may be able to help.
Good luck!