[Completed] I535 galaxy s3 stuck in download mode - XDA Assist

I have a galaxy s3 I535 4.3...
the device had been rooted with a custom rom instlled...
I attempted to install a new custom rom and now I can only get the device into download mode...
this may be referred to as a soft brick but I'm not sure...
either way I'm pretty sure I'll be required to use Odin...
I believe I may have to repartition the device and reinstall everything else...
my issue is mostly this, I'm not sure what files to use or where to get them from...
if anyone can provide me with links to these files and or a video I would greatly appreciate the help...
Odin mode (red)
Product name: SCH-I535 (white)
Custom Binary Download: Yes (1 counts) (white)
Current Binary: Samsung Official (white)
System Status: Custom (white)
Qualcom Secure Boot: Enable (grayed out)
Warranty Bit: 1 (red)
Bootloader Rp Swrev: 1 (grayed out)

Hi there
You'd be best served asking for help from the experts who own your device, here
> Samsung Galaxy S III I9300, I9305 > Galaxy S III Q&A, Help & Troubleshooting > [HELP THREAD] Galaxy S3 Ask any question.
Good luck

Related

[Completed] Samsung T-Mobile SGH-M919 Wont let me go back to stock firmare using odin

hi guys well ive tried every possible to flash back to stock but i cant... every time i trie to flash the md5. tar file this pops up on my download mode on the top left corner...everything is being done right... i get this on my samsung screen:
PRODUCT NAME: SGH-M919
CURRENT BINARY: CUSTOM
SYSTEM STATUS: CUSTOM
KNOX KERNEL LOCK: 0x0
KNOX WARRANTY VOID: 0x1
CSB-CONFIG-LSB:0x30
WRITE PROTECTION: ENABLE
EMMC BURST MODE ENABLED
START[224,1440]
SW REV CHECK FAIL:FUSED: 5 BINARY: 1
IT SOFT BRICKS SO I HAVE TO FLASH THE CURRENT CUSTOM FILES IM CURRENTLY IN AFTER DOING THE PROCESS AGAIN...
ANY SUGGESTIONS?
help would be greatly appreciated
Hi,
I suggest you ask for help here, it's an ask anything thread for your device...
> T-Mobile Samsung Galaxy S 4 > T-Mobile Samsung Galaxy S 4 Q&A, Help & Troubleshooting > [HELP THREAD] Samsung Galaxy S4 T Mobile Version | Ask ANY Question | Noob Friendly
Good luck!

[Completed] [Q] Galaxy s3 LTE recovery problem

Hello,
I have a Galaxy SE LTE aka GT-I9305 which had the 4.3 android.I recently download the 4.4.4 Germany stock rom from Sammobile and flash it in with odin 3.09.Though to several wifi problems i decided to turn back to stock rom 4.3
I downloaded again the 4.3 France Bouygues from Sammobile but when i tried to put it with odin i get the FAIL message.My phone now shows a triangle emergency message which says to me to restore it from KIES.Unfortunately KIES 3 shows me these 2 messages "Device is not supported" or " Device can not be upgraded".Please help me who to re-install stock rom with ODIN.Thanks a lot
Hi,
You'll be best served asking the experts who own your device for help, Here...
> Samsung Galaxy S III I9300, I9305 > Galaxy S III I9305 (4G LTE + 2GB RAM) Q&A, Help & Troubleshooting
Good luck!
Thank you. Thread closed.

[Completed] [Q] Samsung Galaxy S6 edge

Another variant....
Downloaded the Pingpong (TRIED ALL THEM), and installed it
Accept the prompt to install SuperSU
Download data, then get root
I get a message "Device not found" Your device data is still not supported. Stay tuned..
Hmmm
T-mobile Samsung Galaxy S6 edge, running G925TUVU2COF6, Jun 22 Android 5.1
Let me know if you need additional info, and I'll provide it.
Hi there,
Please follow this guide for rooting your device: How to Root Samsung Galaxy S6 & S6 Edge - Video Guide
For other questions please use this forum: Galaxy S6 Edge Q&A, Help & Troubleshooting
Good luck

[Completed] [Q] SAmsung S3 unrooting issue and flash reset not set to 0

Hi
I had my Samsung S3 phone accidentally reset by a child and in an attempt to try to recover data I rooted the phone.
Model Number: GT-I9300
Android version: 4.3
Baseband version: I9300DDUGNB1
Kernel version: 3.0.31-2363855
[email protected] #1
Fri Dec 27 20:00:26 KST 2013
Build number: JSS15J.19300XWUGML4
SE for Android status: Permissive
I dont remember what mistake I made while unrooting, I get to see the flash counter still reading as follows:
ODIN MODE
PRODUCT NAME: GT-I9300
CUSTOM BINARY DOWNLOAD: Yes (1 counts)
CURRENT BINARY: Samsung Official
SYSTEM STATUS: Custom
Phone was bought in India. I am in Australia now.I need to get it back to stock and also make sure it is able to work with
apps which are used locally in Australia. Please help me with directions. I already bought Triangle Away but
it says that it requires root which is not currently there. Do I need to download custom binary and root it again
and then do an unroot? But I am scared that somewhere I read that devices with 4.3 come with the security
software Knox which doesn;t allow the counter to be reset though you unroot the phone. Help please..
Hi,
You must ask in the dedicated forum for this device, but first you must see what exactly model of S3.
Here is general forum for Q&A dedicated to Galaxy S3 I9300/9305:
> Samsung Galaxy S III I9300, I9305 > Galaxy S III Q&A, Help & Troubleshooting
Or ask directly in this thread: [HELP THREAD] Galaxy S3 Ask any question.
Also please see this tutorial: [Tut] Unroot the Galaxy SIII (for stock updates/warranty)
Good luck

[Completed] [HELP] Galaxy Note 3 N900L Tripped Knox cant update software

Hello there! I would like to ask if there's a way to update my phone even tho my Knox is tripped already. I'm looking for a lollipop rom or any other custom rom better than kitkat THANK YOU in Advance
Phone Details:
Model No: SM-N900L (Korean VAriant)
Baseband: N900LKLUFNK1
Kernel Version : 3.4.0-3171410
Hi there,
All you need is in this thread:
Full guide on how to unroot and go back to official stock firmware for Galaxy Note 3 SM-N900/N9005/N900T/N900W8
Also you can review this thread: [Q] Unroot N900, but which firmware?
For more questions please ask in this forum: > Samsung Galaxy Note 3 > Galaxy Note 3 Q&A, Help & Troubleshooting
Good luck

Categories

Resources