[Q] Verizon Galaxy Note 10.1 Stuck in Half-Airplane Mode - Galaxy Note 10.1 Q&A, Help & Troubleshooting

I have been using tasker on my tablet for about 2 years now, and all of a sudden, for the last week or two, it has been acting differently. I have a tablet installed in the dash of my car and use tasker to turn off all radios (mobile network, wifi, bluetooth, etc..), turn off the screen, etc.. when the car turns off (no power), and then turn all of that stuff back on when the car starts (power). The problem is that all of a sudden, after a couple of on/offs of the car, if I use the airplane mode on/off, it gets stuck and I have to restart the device (basically, in the notification panel settings, the airplane mode is half lit up, like it is in the process of turning off/on). If I use the mobile network on/off, it will show that it is picking up the network, but I cannot connect to the internet (shows the bars are full, for instance, like it detects the network, but I can't access any data). Also, to go along with these two things, I used to, when leaving my car parked overnight, come back to maybe a couple percent loss of battery life... now, it is dropping significantly (probably 30+% or so each night).
Anyway, I have been searching around online for a while now and I cannot seem to find an answer anywhere. I installed a new SIM card from Verizon, have factory reset it, and nothing works. If I disable the cell data disconnect (either mobile network or airplane mode), when I come back, it shows the signal bars with a small "x" in it and no connection. Either way, only a restart fixes the connection.
Attached is a screenshot of my devices info if that helps as well as a picture of what the "half stuck" airplane mode looks like.
Any help/info is greatly appreciated... thank you!
- Adam

Related

Losing Wifi everytime!!!

What is with this? I 've gone through several HTC phones on the EVO and everytime I lose my wifi. Anyone can help?
When do you lose the Wi-Fi?
I use the wi-fi in my house and it will maintain a constant signal.
UNLESS
It goes to sleep mode, then it turns off the wi-fi as well.
Whenever I bring it out of sleep, it always has to re-connect.
I don't know if there is some registry setting you can set to keep wi-fi turned on.
I think the risk is that it will drain the battery much quicker though.
I'm using the MAPL build 2.60 beta for a Dash 3G and the battery life is incredible.
You can make it stay on by going to: Comm Manager>Settings>WLAN Settings>Power Mode and unchecking the "Auto turn off..." box. And yes, it does suck the battery like a vampire and makes the phone HOT! You can also adjust how long it will stay on for after LCD OFF.
Wifi question
Hi, before i drive myself mad, I am convinced that my phone uses gprs for data, not wifi. And my bills seem to agree with me.
When I use things like MyPhone, either connected to my PC or connected to my wifi at home, it seems to appear on my bill as a data charge, which would indicate that it is using the network??
Am I right, wrong or stupid? Any help greatly appreciated.

Atrix 2 known wifi problems?

I have an Atrix 2. It has been replaced twice by AT&T due to this problem. I have factory reset each phone and tried every battery mode, data saver, sleep policy and wifi channel.
The problem:
The wifi turns off by itself! not sleep, off! As in the checked box is unchecked. The phone does it during use and when not being used. The timing between instances is random. The wifi sometimes stays on for hours. Other times it wont last five minutes. I have 4 other wifi devices connected by wifi to my secured router.
Note: I travel across the country for work and the problem occurs at airports, hotels, mcdonalds, ect.
I have called Motorola and their only option is to send it to the with no replacement. I could use some help. I have been searching online and others with this problem dont persist, they simply state that unsecuring their router fixed the problem. That is not an option for me as the routers are not mine.
Any input will be greatly appreciated.
Hi, I recently noticed this problem started after I installed the ATT Smart Wi-FI app. Mine will connect then turn off, wait a second turn back on then I get the WIFI networks avail message and I check it and it's not connecting to the network til I tell it too then it will stay connected all day.
I"ve had my atrix 2 for about a little over a month. It's doing the same thing. Wifi will randomly shut off. I have to go into the settings to turn it back on. It will work fine for a little while then just shuts off again. Does anyone know if this seems to be hardware or software related. I've tried different apps and WiFi sleep settings to no avail. I really like the atrix but this is kind of annoying.
I have the same issue also, except I have top reboot my phone for wifi to work again.
Sent from my MB865 using XDA App
i have the same problem, it's not my wifi connection, but the actual wifi setting turns off whenever i turn off my screen and yes, i've set the wifi sleep policy to "never", so that's not the problem. i've also tried "never when plugged in" and "when screen turns off" and i still get the same problem. i was thinking about going to at&t and asking them about it but decided to come here first.
(a white iphone 4 is looking better and better ) can anyone help?
I had this problem but after I disabled the power saver option under battery and data (set it back to performance) it went away and Wi-Fi works perfect.
Tried different battery saver settings as well, nothing changed.
Sent from my MB865 using XDA App

Keep Wi-Fi connected when locked with Skype

As a power saving method, Windows Phone puts a connected Wi-Fi connection on standby when the phone is locked for more than a minute, so when you unlock your WP, it attempts to reconnect. The phone automatically reconnects and disconnects while its locked to check for notifications like email every 5-10 minutes or so. This reconnection for many is hit or miss, sometimes requiring you to go into settings to manually connect to Wi-Fi again. The only way to keep Wi-Fi connected is to connect the phone to a PC or wall outlet to charge.
Now, for some reason, a couple of weeks ago, the Wi-Fi on my Lumia 900 stayed connected even if the phone remained locked for hours and to my surprise, it had a minimal effect on battery life, I barely noticed any significant drain. It was wonderful!
Yesterday, it stopped this seemingly miraculous behavior and went back to its default power saving ways. I retraced ALL my steps and cant seem to recall doing anything specific to enable/disable this "feature".
So I was wondering if any of you experienced anything similar?
UPDATE: Its not a miracle, Skype was keeping the Wi-Fi on!
Come to think of it, I did make a Skype call just for the sake of trying out the front facing camera quality over the network.

[Q] Lumia 1020 connectivity issues (bt/wifi/plane mode)

Hello there.
I am facing a problem which i think is caused from the bt.
Everything works fine (no battery drain, no heat, not lagging, no crashing apps, perfect voice quality etc) EXCEPT when i connect my bt headset(-s).
At first it works fine, make my calls, download emails browse everything. At some point (it could be 5 minutes it could be 5hrs) i am facing disconnections with the connected bt device. The phone may or may not show it is disconnected, it may or may not enable voice through bt (but i cannot hear anything). During the call i can toggle bluetooth and speak through the phone.
Here is the chain of events.
After this it drops the connection with the wifi and the menu stays at Searching mode (i left it in search mode for >5hrs with no luck discovering any wifi). If i disalble wireless or bt or enable/disable airplane mode the menu stays grey forever and with the dots in the upper screen keep coming and coming. Long story short i cannot toggle on/off any connectivity feature (only cellular data works under any circumstances), i have to either turn off and on the phone or soft reset it. I did two hard resets (one of them was clean state) but this behavior hasn't changed.
Also if i have only bt on and connected and i leave it overnight in the morning it shows about 10 - 15% battery and quiet hours are not auto disabled (also tried to turn Cortana Off) BUT if i plug it for FIVE minutes it goes back to 90-95%. and have normal battery consumption during the day.
The only thing i havent tried (and if i do i will do it only for testing reasons) is roll back back to WP8.0.
Am i facing a warranty issue or is it a glitch of the software (i am running Cyan)?
Lef84 said:
Hello there.
I am facing a problem which i think is caused from the bt.
Everything works fine (no battery drain, no heat, not lagging, no crashing apps, perfect voice quality etc) EXCEPT when i connect my bt headset(-s).
At first it works fine, make my calls, download emails browse everything. At some point (it could be 5 minutes it could be 5hrs) i am facing disconnections with the connected bt device. The phone may or may not show it is disconnected, it may or may not enable voice through bt (but i cannot hear anything). During the call i can toggle bluetooth and speak through the phone.
Here is the chain of events.
After this it drops the connection with the wifi and the menu stays at Searching mode (i left it in search mode for >5hrs with no luck discovering any wifi). If i disalble wireless or bt or enable/disable airplane mode the menu stays grey forever and with the dots in the upper screen keep coming and coming. Long story short i cannot toggle on/off any connectivity feature (only cellular data works under any circumstances), i have to either turn off and on the phone or soft reset it. I did two hard resets (one of them was clean state) but this behavior hasn't changed.
Also if i have only bt on and connected and i leave it overnight in the morning it shows about 10 - 15% battery and quiet hours are not auto disabled (also tried to turn Cortana Off) BUT if i plug it for FIVE minutes it goes back to 90-95%. and have normal battery consumption during the day.
The only thing i havent tried (and if i do i will do it only for testing reasons) is roll back back to WP8.0.
Am i facing a warranty issue or is it a glitch of the software (i am running Cyan)?
Click to expand...
Click to collapse
I got the exact same problem with my own L1020, have been fighting with support to have it fixed, they changed about everything (except the mainboard...) and the problem is still there.
I started to be really angry and got a free Lumia 930 in "replacement"... as I still got the L1020, I tried to put it under W10 preview, and it looks like the problem is really a software issue... with some builds, Bluetooth was working fine, with some the same problem appeared again...
I don't know if you found a solution in the meantime... if you did, I'd like to know what it was, because I like the 1020 better than the 930 (size and camera mostly) and I'd love to have it working with my MS Band

WIFI got crazy

Hi all,
For the past few days, my Galaxy s6 WIFI got crazy.
When I switch it on, it scan for networks, find some and the network it knows and connect to it.
but than, it keep scanning all the time.
meaning, all other networks are gone and I can see only the network that it connected to, after 2-3 sec it start to scan again while still connected.
showing 2-3 networks around, and than stop scanning and all of the networks are gone again (except the one it connected to), and after 2-3 sec, all over again.
In addition, if I try to switch it off, it looks like I can't - it keeps start and stop scanning all the time in a loop. like on and off, on and off - and in addition its killing my battery.
The only thing I managed to do is, when I clicked to switch it off, a sec before it got crazy there was a line there so I clicked on it and turned off the option of
letting apps to search for WIFI automatically.
This solve the switch off and on issue - so when I switch to off, its stays off.
I don't know how to get back to this screen (of letting or not to apps to search for WIFI) tough.
The first problem that it keeps scanning when on even if connected to a network - still can't find a solution for it.
I found someone with the same issue on a local forum, he did a factory reset and couldn't located the problem.
Can someone advise?
Thanks.

Categories

Resources