[Completed] [Q] Asus Transformer Pad TF103C (K010) Bricked - XDA Assist

Hy There.
A bad story about my Transformerpad:
Rooted with RootZenPhone1.4.2r.apk works fine.
Then i have tied do install GLTools.apk It end with a blackscreen. I thougt okay, Reboot!!!
But no Reboot, there was just a bootloop.
I boot in Droidboot and tryed to install CWM-recovery with ADB to wipe.
Now the really bad news. I forget to unlock bootloader before und im not sure that i take the right recovery.
i took recovery_philz_t00f.img
Now my Transformer is bricked und i cant get in recovery. It stuck on normal boot and when i try to enter recovery with VolUp + Power just a red bar is flashing 3 times on the screen. I cant even use ADB anymore because i cant start Droidboot.
Any ideas how to Unbrick?

Hi,
Need to know your exact model to point you in the right direction for help.

Its an Asus Transformer Pad TF103C-1A028A
Its also named K010
Firmware was the newest und accu was fully charged.

Unfortunately there's no specific section for your device, so this is where to ask for help...
>*Android Development and Hacking*>*Android Q&A, Help Troubleshooting

Its a new device. But im sure it will be supported later because its cheap and fast.

Gray.Shadow said:
Its a new device. But im sure it will be supported later because its cheap and fast.
Click to expand...
Click to collapse
I'm down the same hole, here is my post in attempts to recover...
http://forum.xda-developers.com/android/help/build-img-update-zip-ota-package-t2887847

Related

[Completed] Android Tablet(noname) Bootloop, HELP

Hey Guys, I have a problem. I got an Chinese or something like that lol^^, Tablet and it stucks in a Bootloop or something like that, when I start it , it goes till the android logo and then it just stays there, I cant go into a recovery Mode I tryed a lot of combinations, Power and the sound+- buttons (it has no more buttons than this 3). Now my question is can I do Something ? Can I make a new fresh Android version on this Tablet using my PC ? Or is there another way to rescue the tablet, pls help me guys
XDA Visitor said:
Hey Guys, I have a problem. I got an Chinese or something like that lol^^, Tablet and it stucks in a Bootloop or something like that, when I start it , it goes till the android logo and then it just stays there, I cant go into a recovery Mode I tryed a lot of combinations, Power and the sound+- buttons (it has no more buttons than this 3). Now my question is can I do Something ? Can I make a new fresh Android version on this Tablet using my PC ? Or is there another way to rescue the tablet, pls help me guys
Click to expand...
Click to collapse
Hello, and welcome to XDA!
Now you have me curious as to the name of the tablet!
Without knowing the device name (because there is a myriad of things one can do, but only a small handful for any particular device), all I can do is point you to the direction of the [Ask Any Question][Newbie Friendly] thread of the > Android Development and Hacking > Android Q&A, Help & Troubleshooting forum.
Just so you know, in order to get any useful help, they will need to know as much info about the tablet as you can dig up (make and model number are good starters).
Hope this helps, and good luck!

[Completed] [Q] Asus Fonepad 7 FE170CG boot infinite loading (Need Help Data Recovery)

Hi,
I'm new here, for first thanks for read my help request,
I don't know if i'm doing the right thing writing here,I do not want to bother,
and sorry for my bad eng.
I tried to root my Phonepad using RootZenFone-1.4.6.4r, but when i try to reboot my phone fallen in a infinite loading Screen,
I waited 10 minutes than i forced power off with the power button, now when i try to power on it, it does the same thing
I'm very noob using fastboot,
there is a way to read partitions from fast boot?
if i do the system upgrade using the default bootloader (load from sd card in bootoption) i lose all my data?
I know that i can run a custom kernel image from fastboot, but i think that you know best pratcties to applied in these cases,
Thanks in advance,
SleepyDev
Hi,
Thanks for using XDA Assist you may try to post here has your device dont have a dedicated forum yet [GUIDE] How to Root ASUS Fonepad 7 FE375CG K019 (11.10.1.43) KitKat
Also you can post here http://forum.xda-developers.com/t/fonepade-7 too
Good Luck!
Thread Closed.

[Completed] Asus Zenfone 2- Hard Bricked After Installing Automatic Update

!!! hard bricked my asus zenfone 2 !!!
guys i have rooted my asus zenfone 2 and tried to install a custom recovery but unfortunately forgot to switch off the automatic system update and i have accidentally installed it . my phone got into bootloop .while trying to recover it using bootloader mode ,i got stuck in a screen displaying a usb symbol. i think my phone has been hard bricked .
how can i solve the hard brick in my phone and make it work as it worked earlier .
rajesh rajasekhar said:
guys i have rooted my asus zenfone 2 and tried to install a custom recovery but unfortunately forgot to switch off the automatic system update and i have accidentally installed it . my phone got into bootloop .while trying to recover it using bootloader mode ,i got stuck in a screen displaying a usb symbol. i think my phone has been hard bricked .
how can i solve the hard brick in my phone and make it work as it worked earlier .
Click to expand...
Click to collapse
Hello and thank you for using XDA Assist.
Sorry to hear about your trouble but fortunately there is an XDA area dedicated to the Asus Zenfone 2 at http://forum.xda-developers.com/zenfone2 which would be a good starting place. I suggest you post your question with all relevant details in the friendly Q&A forum there at http://forum.xda-developers.com/zenfone2/help where the experts familiar with your device will be best able to guide you.
Good luck!

[Completed] Zenfone 6 black screen after wrong flashing

Good morning to all of the bosses here and to everybody...I am also new in adventuring in custom rom flashing. Oh God, I just afford a zenfone 6 and quickly I decided to mod it with custom roms. I tempted to update it manually to lollipop and it was successful. Then I decided to downgrade to kitkat in order to unlock the bootloader. I was served on internet with 2 ota files(6.2.2.2 and 6.3.3.3). I flashed the file 1 with success but as for the file 2, my phone didn't finished the process and switched off itself. I turned it on and it directly went on recovery trying to finish the downgrade. When the phone tried to reboot it stucked on asus logo. I went on recovery and made a hard reset, but it kept stuck on the asus logo at boot. Now came the bad luck; I found tutorial on internet on how to unbrick zenfones. I precise that almost all the tutorials spoke about the case zenfone 5 and 6 are stuck on usb logo, but mine manifested itself in a cycle of 5 to 7 reboots before showing the usb logo and then turns off itself definitively about one minute after that usb logo, and I have to turn it on again for a new cycle again. So that bad luck is that I saw that tutorial to unbrick zenfone with a method using usb intelsoc and other tools I forgot the names. I installed these stuffs with success and my device could be detected ready for flashing. The files that had to be flashed are fastboot.bin, ifwi.bin, dnx.bin, osr dnx.bin...I flashed them successfully, but unlesse I get my phone on its usual asus droidboot screen, it ended up by a frozen intel inside logo. I tried to put it into droidboot or recovrey, but to no vail. The reboot cycle was still there. Then I saw a tutorial on zenfone 5 stuck at intel inside logo where it was said to add a file called ...fuse.bin. I tried to find one for zenfone 6, but I didn't find it...so...so...so I used that fuse.bin intended for zenfone 5 and flashed my zenfone with it. The flash wax successful but when the phone rebooted...BLACK SCREEN!!! With some vertical white stripes appeared. No image, but cycle of reboot continue without the usb logo this time. The phone is still detectable and I even tried to reflash the previous file without that bad fuse.bin, successful but screen is still black...oh God help me, oh my new phone, everybody here help me recover my phone please!!! The version of my phone is TW version...thanks in advance!
Hello and thank you for using XDA Assist,
your device don't have a device specific forum here on XDA. Please create a thread here:
Android Q&A, Help & Troubleshooting
The experts there should be able to help you. Good luck!
Kind regards
Trafalgar Square
XDA Assist

[Completed] How to fix blocked boot recovery samsung?

Hello guys,
A few months ago, I rooted my phone using kingroot. After a few weeks, i tried to install TWRP custom recover to unlock bootloader. I accidently downloaded a wrong version of it and flashed it using flashify app, after which i booted into recovery to check the new recover mode. But, something awkward happened. THE BOOT MODE DIDN'T OPEN AND THE SCREEN GOT STUCK AT "Booting into recovery". I read on the internet and realised that my device has got soft-bricked. Also, phone wasn't rebooting. So, i found a solution atleast start my phone. I took out my battery, pressed the buttons for download mode and then placed the battery back in and pressed the buttons for download mode and somewhow rebooted my phone (i read about this technique in xda forums). Now, although my phone works but i cannot access the recovery mode as it has got soft-bricked. Thus, i cannot perform a hard reset as it gets caught in that "recovery booting stuck cycle". So, can anyone tell me how to fix this? PLS QUICKLY. aLSO, i don't know much about ADB, so pls explain that too as my friend suggested me to use ADB to fix softbrick but im not sure!!
androcrazy24 said:
Hello guys,
A few months ago, I rooted my phone using kingroot. After a few weeks, i tried to install TWRP custom recover to unlock bootloader. I accidently downloaded a wrong version of it and flashed it using flashify app, after which i booted into recovery to check the new recover mode. But, something awkward happened. THE BOOT MODE DIDN'T OPEN AND THE SCREEN GOT STUCK AT "Booting into recovery". I read on the internet and realised that my device has got soft-bricked. Also, phone wasn't rebooting. So, i found a solution atleast start my phone. I took out my battery, pressed the buttons for download mode and then placed the battery back in and pressed the buttons for download mode and somewhow rebooted my phone (i read about this technique in xda forums). Now, although my phone works but i cannot access the recovery mode as it has got soft-bricked. Thus, i cannot perform a hard reset as it gets caught in that "recovery booting stuck cycle". So, can anyone tell me how to fix this? PLS QUICKLY. aLSO, i don't know much about ADB, so pls explain that too as my friend suggested me to use ADB to fix softbrick but im not sure!!
Click to expand...
Click to collapse
Hi androcrazy24
Thanks for using XDA Assist.
Could you please state the Manufacturer & Model of your device so we would better approach your issue guiding you to the appropriate experts? Your last post from November 2015 is referring to the S III. It is still that?
I will be waiting for your reply within the next 2 days.
Nice regards.
.
my phone is samsung galaxy s4 mini DUOS GT-I9192, OBVIOUSLY BY SAMSUNG..........
Kdio said:
Hi androcrazy24
Thanks for using XDA Assist.
Could you please state the Manufacturer & Model of your device so we would better approach your issue guiding you to the appropriate experts? Your last post from November 2015 is referring to the S III. It is still that?
I will be waiting for your reply within the next 2 days.
Nice regards.
.
Click to expand...
Click to collapse
"mY phone is samsung galaxy s4 mini duos GT-19192 RUNNING ANDROID 4.4.2
androcrazy24 said:
"mY phone is samsung galaxy s4 mini duos GT-19192 RUNNING ANDROID 4.4.2
Click to expand...
Click to collapse
Hi androcrazy24
Thank you for your answer
Our experts at the below forum should be able to help you. Please be welcome to ask in there.
Galaxy S 4 Mini Q&A, Help & Troubleshooting
Nice regards and good luck.
.

Categories

Resources