hello, i am new to x developers ...
i have been trying to hspl and rspl my htc 7 trophy to get android on it, and during that process sth went wrong (i am not that expert in this issue) sth went wrong and the process didn't complete, well the phone is still running and i can update it and use it in windows mobile 7 mango, but the problem is that in the boot-loader screen ( the tri-colored screen )i cant see any serial or usb written at the bottom, that means i cant install any new rom , can any one help me in fixing this issue, i have posted 2 images showing the the problem and the info about my phone .
plzzz helppp...
Related
hi there
i am using imate jamin da problem with my cell is
i upgraded my rom to qtek 2.20000 it was working absolutely fine with 8 icons in my comm manager then i upgraded to RUU-Prophet-G4-AKU2.2-2.20-2.47.21-Jester-b1 and it has severely damaged my cell as my phone my phone hangs white booting it shows me the colour screen with
IPL 1.00 and SPL 2.20.0001
on the Screen
OS and GSM is not displayed
I tried rom update several times but its not working
i tried to update my rom through boot loader mode but again failed
i even tried to format my phone but it gives FAT16 format failed
I even tried to upgrade to jesters RUU-Prophet-G4-AKU2.2-2.20-2.47.21-Jester-r1 but still its not working and givng same problem
now i dont understand what to do
guys please give me Advice and solution for this g3 g4 Problem
i even tried sending my phone to service center but stupid people dont know how to solve it and they returned me back
Thanks in Advance
You have bricked your phone... You just can't install a G4 rom on a G3 phone... Different chipsets are the cause of the problem... Sorry
you mean to say its over ?????????????
there should be any way
You'll have to wait to see if Jesterz manages to produce a goldcard...
BTW a goldcard it's basicly a mem card with a rom in it that autoinstalls itself thus no need for the usb connection... This fits your case cause you don't have an active usb conection because of the driver/chip conflict...
wrong software
I have the same problem i tried to flash my g3 with jesters RUU-Prophet-G4-AKU2.2-2.20-2.47.21-Jester-r1 by mistake and it was ok until the end of process when i finich it with congratulations and bla bla my device stills in the bootloader mode all the time. I can now connect and start to flash but when it comes to 80% of the process it stops with error 360 wrong command. Pleas is there any help for some kind of downgrade flash or so because it can only get boootloader but never start with software. When I try with jesters RUU-Prophet-g3-AKU2.2-2.20-2.47.21-Jester-r1 the whole process finish ok but the phone stills in bootloader. The same thing is also with RUU-Prophet-g4-AKU2.2-2.20-2.47.21-Jester-r1 I can not execute step2
that's why you should read the "sticky" first before you do it.
I have a Dopod 818Pro from a friend of mine but in Chinese ROM, so I have to read a whole nite the sticky and found out what is my Dopod version, finally I found it is G3, so I did all the steps, from unlocked the CID till upgrade to Jester latest ROM for G3 and skip the G4.
please help
Yes i realy know that it was my fault and my big mistake so i vould not do it again but now i need help because it stills in bootloader i i can even start flashing the device that gives me hope that some kind of recovery is maybe possible.
Yes i also commited this mistake its my fault but i really need help my device still enters into bootloader mode.
ur problem
there is nothing to do anymore u have to wait u CANT DO ANYTHING ITS OVER
how do you mean it is over. Do you think that could not repair it. Is it possible with sd card or jesters gold card and how. Help me please if somebody knows
there must b some way to overcome this problem
jesterz's gold card isn't working yet, and for now it's only for G3...
My hardware is G3 but flashed by mistake with G4 and now is in bootloader mode so i can start flashing but i do not know with what and how. Could you please explain me how and where can i find and use goldcard for g3 if possible Thanks
have u tried holding the camera button while softreset and then flash rom again
Yes sure i tried to flash rom from jesters for g3 which is for my device instead jesterz g4 what i used by mistake and it passed ok but when i restart it stills in bootloader mode only, so i could flash but do not know which firmware should i use
i've the same symptomes as mjankovic and aarif_ziaee, (bricked my phone)
but the only things i think i've forgot, is to cid unlock my device before doing the step 2
i have a question.
i have the rom PDAMobiz_Prophet_WM5AKU3.3_v3301
(witch is not an auto installable tile, it's a folder containing exe, dll, bat and nb file)
is it possible to install it by using teraterm pro or mtty? (connected and install bats and cabs by thoses software)
ps : i'm sorry for my bad english, i'm french not going to my languages faculty since i'have bricked my phone. need to fix it soon !
Hey guys,Yesterday i wanted to update my rom.I have windows mobile 6.1.Apperently with the new rom it makes it faster.I unlocked my device and tried loading the softawre on.Everytime i try loading it ,the computer says it lost the connection with the pc.Today i tried using my phone and when i switch my phone on ,the phone does not respond and the screen has three colour(blue,red etc).How do i get into my phone or reset it so that i can use my existing rom and windows?e-mail me anytime
You're stuck in Bootloader
Hi
Your phone is stuck in Bootloader Mode. You may find that by removing the battery and re-inserting it you will get to a position of loading Windows Mobile. The Bootloader is the software on the phone that is used to install a new operating system. If you search for "Stuck" and "Bootloader" on the forum or the section of your device you will probably come up with some threads about this problem.
The worst case scenario is that the "flash" of the new operating system has gone wrong so the Windows Mobile operating system can not load. If this is the case, the phone will automatically revert to the Bootloader as it can't "see" any system installed. Think of a PC reverting to the BIOS and giving you the message "Operating System Not Found" if you remove or disconnect the hard drive.
If you can't boot simply be doing a soft reset using the stylus in the hole you need to successfully flash a new Operating System or ROM. Check out the Encyclopedia at the bottom of the main forum page if you don't understand any of the words I've used here. If you can be more specific about your device and the ROM you tried to flash others may be able to help.
Cheers
andrew-in-woking
Help
Hi,how do i flash when i dont have excess to windows itself?The colourful screen comes on immidiately when i start my phone!!
XZ5J4H said:
Hi,how do i flash when i dont have excess to windows itself?The colourful screen comes on immidiately when i start my phone!!
Click to expand...
Click to collapse
Welcome to the forum
Please READ the Wiki: http://wiki.xda-developers.com/index.php?pagename=HTC_Vox
Over there you´ll dind a way to flash your device
Good luck,
Stuck windows
Hi,I managed to load mono lisa windows 6.1 on my phone.I did this by justing loading utility update file.Followed all the intructions.After the rebooted it just goto stuck.I tried taking the batery out and inserting it back in the phone after 10 seconds.The problem is when i start my phone it gets stuck and the everything in unresponsive.Help me please!!1
Hard Reset or Reflash
Hi
After flashing a ROM you always need to perform a manual Hard Reset. Read the Wiki page on your device for info on how to do this. If that doesn't help then you may have a bad flash. If this is the case then flash the ROM again but as soon as it's done perform a manual hard reset.
If you still can't get it working flash an official operators or HTC ROM to your device.
G'luck!
andrew-in-woking
Rom Wanted
Hi Guys,what is the latest and best rom for a htc s710 today?I want to upgrade.Please help!!Want something that also makes my phone faster.Currently have the VOXrOMwM6.1 cLEAN_V1.3
XZ5J4H said:
Hi Guys,what is the latest and best rom for a htc s710 today?I want to upgrade.Please help!!Want something that also makes my phone faster.Currently have the VOXrOMwM6.1 cLEAN_V1.3
Click to expand...
Click to collapse
Enter to Vox forum and READ a little about all ROM´s there.
The best way is to test severals till you get the one fits your personal needs
Good luck,
Hey guys ,
This is my first thread !
I found my dad's old HTC Touch Viva and thought about flashing something new.....(it runs win 6.1 !!)
So the HardSPL thread said the device must be connected in windows mobile device centre , but it just doesnt detect the phone .
So this means I cant unlock it.
Even though I ran it without syncing it , opal hard spl says that it cannot open the update utility [error:208 file open]
Can anyone help me ?
i have done some stupid thing to my htc arrive. which is running on windows 7.0 os with spl 2.x i tried to install windows 7.8 without downgrading to hspl. rom updater started at 1% my pc got restarted and shown your pc is recovered from serious error. but nothing was happened to my phone. after next day morning touch screen was not responding. showing microp wrong platform(0×0) touch none. now i downgraded to hspl using dft tool and installed all available roms for htc arrive but touch was not working. i already have full backup of original rom and i have updated that one also still no luck. i tried y cable method 3 times but nothing happened.it says installing touch driver ok but not working.i have opened my htc arrive and pulled out the sd card and reinserted still problem was alive. i don't have warrenty for my mobile. is there any solution available to solve my problem? sorry for my bad english
Hello,
I have a problem with HTC ONE MINI PO58200
The phone was lying long.
When it boots, it displays Bootloader. No recovery option does not work (restarted)
What can I do?
Please help.
Regards.
Same here, tried unlock bootloader thru THCdev, fastboot says successful ,OK, but phone does not get the next screen, for unlocking. Tried 100 times.
I have RUU and ZIP, but when device reboot after 20 seconds RUU crashes. In log file says:
The input file() DOES NOT exist
Any other suggestions here ?
There are so many HTC with such problem, pls guys anyone help ?? Thanks !
same probleme
I have the same probleme.
itries many methode on internet it doesnt works.
i think you need the original firmeware. mine is from Uk. so there is on htcdev.com kernel files but how to upload it on the phone ?