Hello there,
I have problem with my screen alignment.. ASUS P535. It repeats again and again.. I updated my ROM and nothing happend. Then I've changed digitizer on my LCD. It worked, but for 1 time. When fresh copy of ROM started. Screen alignment was correct. When I've got loaded my WM device restarted and asked to align screen. And nothing happend. And it again repeats.. What should I do now? Maybe is there a way to upload screen align file direct to my ASUS P535? Or any other suggestions..
This happened to my bother-in-law on his omnia. he had it replaced 3 times. 3 devices, 3 bad screens after a few weeks each. The alignment was way off, and if he hard reset.. he got stuck on the alignment screen and could not go past it.
Tapping all 4 corners and then the center should all line up perfect or it will repeat until it's right. If the screen is messed up.. (Not registering the taps accurately) this would cause your problem.
I know you replaced your digitizer, but I think you have bad hardware.
did you notice the screen was not accurate before this happened?
Yes. It was not accurate. Half screen from top was accurate, but other half not.. I had to tap screen ~1cm lower to hit correct 'button'.
Ok.. If hardware is broken. So then which part? Or just I'll take my device to pro to fix it.. If it will be possible..
I also used Remote Screen Alignment software. It solved align problem, WM is working, but everywhere I tap, it taps bottom right corner.
Related
Hi everyone,
Last night my polaris started playing tricks on me. Basically the touch screen is not responsive but the hard buttons all work. For some reason though when I try to do a hard reset (GPS, Internet and reset) it doesn't perform a hardreset. Also I can't put it into boot loader mode
Any suggestions?
Can you try and flash a new ROM?
Yes i've flashed another cooked ROM and till nothing, even D/L official 6.1 ROM and still no touch screen.
I would immediately assume the touch screen is broken but the fact I can't use the hard reset combination (even though the individual buttons work) has got me confused
Hi!
I've the same issue.
This morning everything was fine but, now i can't use the touch screen.
It seems that the "cursors" is always in the upper right corner, but as i move it clicking in the other part of the screen it runs back in that corner.
I'm not able to hard reset, i've tried to do a clearstorage but i'm not able to enter the security code "1234" as i haven't the cotnroll of the screen
Have you solved this problem?
I will let you know shortly but cut a long story short it looks like i broke it
on closer inspection of can see a small dent/scratch on the screen so ordered a new touch screen off ebay. It arrived today so i'll be putting it in shortly so fingers crossed it was actually the problem. I figure the problem was the screen causing a permanent short and hence interupting my attempts at a hard reset
The screen cost about $35 AUD delivered and it took me about 30 minutes to pull the device apart, just have to see how long it takes to get it back together now
I'll post back soon
To me something similar has hapened.
Once i was changing the values of the pressure settings and the screen become unresponsive!
It was quite easy to fix it:
-just press the GPS button and the center button at the same time, then you will enter the menu were you can align the screen and, at the same time, the pressure registry values become as default.
Hope this helps with your problem, good luck with the screen replacement!
It's alive!!!!
Replaced the digitizer (touch screen) and all works again ...
Just to warn you though it isn't for the faint of heart, I thought i'd broke it a couple of times throughout the repair, next time i'll be getting a repair quote first
Congratulations!!
As my polaris is still under warranty i'll send my to the official assistance for the touch screen replacement!
Yesterday i've got my Cruise back from assistanza.. thay have replaced the whole mother board and now the touch screen is working
its a good idea to install my mobiler. this lets you control the device using a pc when the touch screen doesn't work. you can then back up your stuff before sending off for repair.
Hello!
A few days ago I started experiencing an annoying problem with my HTC Touch Pro which I have for almost a year.
Every once in a while, the touch screen goes out of alignment, and doesn't respond correctly to my taps.
I use the screen alignment app that in the start > settings > system tab, and then two things happen:
a. it usually takes at least 4 times until it aligns correctly, and sometimes I give up and have to soft-reset my device.
b. the screen goes out of alignment again, after some minutes or hours!
This is very frustrating...
Does anyone have a solution?
My eternal gratitude is promised!!
Shai Lachmanovich.
lachmanovich said:
Hello!
A few days ago I started experiencing an annoying problem with my HTC Touch Pro which I have for almost a year.
Every once in a while, the touch screen goes out of alignment, and doesn't respond correctly to my taps.
I use the screen alignment app that in the start > settings > system tab, and then two things happen:
a. it usually takes at least 4 times until it aligns correctly, and sometimes I give up and have to soft-reset my device.
b. the screen goes out of alignment again, after some minutes or hours!
This is very frustrating...
Does anyone have a solution?
My eternal gratitude is promised!!
Shai Lachmanovich.
Click to expand...
Click to collapse
Hi,
This looks like your touch.dll being damaged. Guess the only solution will be a hard reset (and lose all your settings and dat) If after that, your screen is still out of alignement, you're in for a hardware repair (warranty ?)
Dirk
Sometimes touch screens can 'stick' down, which can cause problems for the device driver, wild alignments being just one of them. I had an Xda II which was a pain for doing this. A short sharp whack, face down would cure it, but it steadily got worse, and the repeated percussive maintenance was eventually the death of the thing.
If it is still in warranty, and you can demonstrate it to to the supplier, then a warranty repair or replacement may be the best remedy.
Hello,
Today my touchscreen stop working, i think it is because of humidity, because it has some spots on the screen. I hard reset and now i can't pass the screen aligmente, any ideas how i can solve this?
Has anyone had humidity in teh screen and solve the problem? some kind of cleaning?
For humidity, I don't know what to do, sorry.
My raphhael's touchscreen stopped working some weeks ago. I don't know why, the scrree is perfect: symply it stops working.
Then I try changing its rom, thinking the problem was the old rom. So I hadd my pda stucked at calibration step!
Then I found a file with calibration data for using remote calibration mode.
...just use search on xda-forum!!!
Using this data your pda will pass calibration step... but consider touchscreen will not resuscitate;-)
Oh my pda! After three weeks (it stayed turned off), I turned it on for moving some files and (surprize) touchscreen start working flawlessy
I really didn't understood what happened...
Check there links:
http://forum.xda-developers.com/showthread.php?t=747541&highlight=calibration+data
http://forum.xda-developers.com/showthread.php?t=745435&highlight=calibration+data
I've attached a zip file. Decompress it on your micro-sd and reboot Raphael.
Good luck;-)
Hey doping11,
I got the same problem with my touch pro.
After a evening walking outdoors i can home and
saw a little humidity at the side of my screen.
I hoped it gone away as it had come but no it stayed.
A week later, just this fryday i had a little spot appearing in my screen and
not a day later my touchscreen didn't work anymore.
The spot seems to create a pressure pont at that part of the touchscreen
so no other part is responding anymore and to make it worse....
The spot seems to get bigger and bigger and bigger.
It's now a spot of 2,5 cm length and about 1cm width.
I tryed multiple opties, letting it dry above a heater,
putting the phone on the other site, pushing the spot ect.
Nothing seems to word...
Does anybody has an idea how to fix that ??
the screen is dead., need a new lcd screen and digitizer., cheeper to by anther phone ,used one that works
Hey guys and gals,
I have nexus 5 that is just about a year and a half old. Every now and then, when I wake up the phone from sleep, the touch screen becomes unresponsive and I see white horizontal lines running across the top. I have tried restarting the phone, resetting the phone to factory. The problem still persists. The only way I get the lines to stop from showing up and get the touch screen responsive again is pushing down on the screen hard at random location.
I have attached a video of the problem I'm getting. https://youtu.be/CzgZ1bcN1Lk
I'm suspecting its a screen issue and I need to replace the LCD panel, Digitizer, etc
Any help would be greatly appreciated.
Thanks!
You need to replace the digitizer (if I'm not wrong), I've encountered this issue before on my older phone.
Hey there,
so far, i am pretty happy with my S7. But there is one thing that is kind of worrying to me. On the lower end of the screen there seems to be a much less touch-sensitive area forming a horizontal stripe going form almost full left to full right. Its less noticable when i remove the screen protector (0.3mm 9h glas) but still there, and with the screen protector applied i consistently fail to hit the lowest row of keys on any keyboard app.
Question is, can this be a software-related issue and be fixed with an update, or is this a case of faulty hardware and should therefore be RMAed? Or is there something else i can do?
Things i tried: Factory reset, TSP-update via code *#2663# (which said "pass" but didnt change anything like version numbers), cleaning the screen, removing protector (which mitigated the problem, but its still there)
Its me again, with updates.
I have returned my S7 and got a new one. Funny thing is - its a completely different unit (different IMEI and S/N, seal wasnt broken upon arrival) and yet it shows exactly the same problems.
Can some of you please test the following: Using the stock Samsung keyboard, try to tap the spacebar right on the lower border. If i tap below the spacebar, it gets pressed. if i tap above the lower border of the spacebar, it gets pressed as well. But tapping right on the border will allow me to touch the screen surface without any signal registered. The keyboard is just for the height reference - from almost far left to almost far right this height is almost dead for finger touches - using a pen diminishes the problem.
Can some of you please try the same? Please check the height upon which your touches in that height get registered. Since i have gotten two phones with the same problems i suspect its a software problem and thus should apply to more people than just me. I have the SM-G930F Exynos.
TheBandicoot said:
Its me again, with updates.
I have returned my S7 and got a new one. Funny thing is - its a completely different unit (different IMEI and S/N, seal wasnt broken upon arrival) and yet it shows exactly the same problems.
Can some of you please test the following: Using the stock Samsung keyboard, try to tap the spacebar right on the lower border. If i tap below the spacebar, it gets pressed. if i tap above the lower border of the spacebar, it gets pressed as well. But tapping right on the border will allow me to touch the screen surface without any signal registered. The keyboard is just for the height reference - from almost far left to almost far right this height is almost dead for finger touches - using a pen diminishes the problem.
Can some of you please try the same? Please check the height upon which your touches in that height get registered. Since i have gotten two phones with the same problems i suspect its a software problem and thus should apply to more people than just me. I have the SM-G930F Exynos.
Click to expand...
Click to collapse
I have the same problem in the video posted at the bottom of this thread
http://forum.xda-developers.com/galaxy-s7/help/s7-flat-unresponsive-touchscreen-t3343175
I have also noticed this problem. It all started out when I noticed I was making a lot more errors when texting. I'm coming from an S5 so the screen size wasn't the issue.
I then started tapping towards the bottom...space bar... period etc and sometimes it would miss. I could tap for like 20 times, and maybe there are 5 consecutive times that it didn't register.
May forum staff merge the 2 threads please?
It would also be great to have an official news in homepage with an official statement from Samsung about this issue
Inviato dal mio SM-G920F utilizzando Tapatalk
FINALLY Found a solution !!!
For those of you having this problem that sometimes the S7 or the S7 edge doesnot register touch somewhere near the bottom right area of the screen:
I (and i suppose most of you) had tried all the solutions like wiping cache, factory reset, soft reset, *#2663# and what not. None of them worked.
Now, the solution is, when this problem occurs, turn off the screen and press the Phone hard on the right hand side of the phone. Like the right half of the phone has got paralised, press it hard, squeeze it. Like, place it on the table or a soft surface and press with the thumb. 3 or 4 presses hard enough on the right hand side from the top to the bottom. And Voila, the problem is gone.... Enjoy your phone. The problem does come back randomly and do the same thing. It works instantly.....