Please Help,
The problem with my QTEk 9000 or actually SPV M5000 which I spouse is the same, is that, the PDA works fine for a month or two, but all the sudden de screen goes very dark, and there is nothing I can do to bring the light up, Is not just the backlight turning off as it should do to save battery no it's not that, the display goes very dark, but if I connect it to the cradle, than the display becomes right while it is connected, but the soon I disconnect it from de cradle, it goes back to is darkness in such a way that I can hardly see what is on display.
The only solution is making a full reset, and everything becomes all right again, for the next month or two, the battery is new, and I don’t know what to do anymore, if anybody could help me I would appreciate it.
Thank you for the possible help.
Roney
Roney, can you explain exactly what happens? Is it not just the backlight turning off as it should do to save battery?
Related
I had about two hours left on my XDAII battery when I switched the device off. When I then tried to switch in on, probably two or three hours later, it would not switch on. The green light was blinking as it normally does when the phone is on. I plugged in the cable to charge it, but the light did not change into a steady green (or is it yellow?) as it does when you're charging. I didn't want to hard reset it because I would lose some data, so I took out the SIM card and put it back in, as this normally soft resets the device. Instead however, it hard reset it, and I found the main battery to be empty. This still shouldn't have hard reset it, should it, since my back-up battery was full?
This has happened twice now. I'm starting to suspect that something is draining the battery even when the screen is switched off. Has anyone else experienced the same?
This may be obvious and you already know but it's worth considering.
When you switch off are you sure that you are turning the XDA II off or are you just turning off the backlight?
A quick press of the off button turns off. An extended press just switches off the backlight and the XDA stays on, draining the battery.
I've made this mistake too, especially in low light conditions. Hope this has helped.
Yes, that must be it! I had no idea that the off-button behaves like this! I don't think it did on the XDAI. Thanks a lot for this information, I will now be very careful with how I press the button, and check the screen in good light just to be sure.
How can I tell if my xda1 battery is faulty? Cooked various roms, but xda buttons only work from cradle. Out of cradle xda crashes after less than 1 minute. If still on can do hard reboot, but won't turn back on from battery switch.
Battery power bar in tools says 100%, but who knows.
I don't think o2 will be very helpful if I ask them.
any ideas guys?
Silent D
Why not try leaving the device on, out of the cradle. See how long the Batty lasts. If you get the low batty warning within a few hours or even minutes then you could assume the batty is suspect.
Will it work in the cradle without the power charge lead plugged in.?
I dont think it is faulty, as all was well until you flashed the Rom.
Ps. are you a member of A.R.S.E.? Association of Registered Software Engineers.
I May be able to help
:twisted: Hi Guys im one of those poor soles who work for o2 for my sins when you say it crashes can you elaborate for me??
Eg just go off or freeze on you??
john :twisted:
when it crashes it goes off completley, no lit LEDs. nothing at all. It won't restart unless I insert into cradle, once in its fine, all external buttons work too,which they don't when off cradle.
Hi All,
After installing Prophet_G3_G4_RadioRom_v2.69.21.exe onto my QTEK S200 it's completely dead. I cannot start it up anymore, even with the battery connected to power. The orange charging light doesn't even go on. I don't get anything here, no QTEK screen, no boot, no nothing even after pressing the button for several seconds.
Anybody knows what happened? Is my battery dead? When I connect the QTEK to the power supply without the battery inserted, the light flashes red for a short second and then... nothing... The battery was almost fully charged when I started the upgrade. IPL was at 2.20.
euh... help!!!
I guess you are having hardware problems, otherwise you would see a error screen... like the stuck qtek splash screen or the bootloader
coolb4all said:
Hi All,
After installing Prophet_G3_G4_RadioRom_v2.69.21.exe onto my QTEK S200 it's completely dead. I cannot start it up anymore, even with the battery connected to power. The orange charging light doesn't even go on. I don't get anything here, no QTEK screen, no boot, no nothing even after pressing the button for several seconds.
Anybody knows what happened? Is my battery dead? When I connect the QTEK to the power supply without the battery inserted, the light flashes red for a short second and then... nothing... The battery was almost fully charged when I started the upgrade. IPL was at 2.20.
euh... help!!!
Click to expand...
Click to collapse
Can you read spanish?
http://www.todopdas.es/forumdisplay.php?f=23
quiet, thast has solution
I have the same problem
any solution for this problem? the device is completely dead!!
remove you battery and charge it at an external power suply (universal charger for example) and then put it back and see if there is any result.
I have a mda and the bluetooth light (the physical blue one) is stuck on, ive taken out the battery, done a soft reset. Turned on/off bluetooth. Even on standby the light is on, what should I do.
i think it is a software related so i suggest to flash another rom
I was thinking that but it wasnt like that for months, so there has to be a setting somewhere or something i can do....i hope
okay strange....randomly the light went off and its back to normal, only blinks when bluetooth is on....strange wm errors never seize to amaze me.
hello everybody.i have a problem with my spv c600.i bought it few days ago.i had installed some apps on it and next morning my phone was off,althought the battery was full.i made hard reset for three times and the phone started.but this is happening every morning from then.and now i can`t make hard reset.after it asks me to press 0 key shows orange screen and after that turns off.sometimes shows the windows mobile screen but only that and turns off.i don`t understand what is the problem...is it software or hardware problem?
can someone tell me what can i do?i want my phone back...i like it to much
sorry for my bad english
i`m not sure if i posted to the correct section but no one can`t help me?
Try to enter Bootloader (hold camera button and shortly hold Power).
After Bootloader started, you need reflash official ROM.
it enters in bootloader but it stays only 3 seconds and after that turns off.i`m going crazy....i don`t know what to do...is it the battery the problem?but last time when it worked the battery was full
other ideas?
try other battery, or try turn on without battery only power cable plugin.
the same thing without baterry.it stays 3-4 second and after that turns off.which is the problem?
and i don`t understand what is with the led colour.when i put the phone to charger the light is red...i try to make hard reset but the phone turns off and and one cuple of times...the led color becomes orange and green sometimes...
so?what is going on?
can someone help me please?
I think that it is hardware problem. Before am I bought my HTC Tornado, I had Sony Ericsson P900 and after 2 years using suddenly he after power on he stopped at the introductory animation. So I gave it to the service and told me that is it a problem with the motherboard. Your SPV C600 looks that is on it similar.
and what happend with your tornado?
With my Tornado nothing. The hardware problem was in my Sony Ericsson P900. In service told me that is it a problem with the motherboard and that the correction would cost cca 850$ . So I declined correction and bought HTC Tornado, which still works .
oh..thanks anyway.i think i will go to service with my spv...
wow it didn`t started for 2 days and now is working like is new.i don`t understand...where is the problem?
it worked only 2 hours and after that it was dead again
what can i do to fix this problem.it`s ok to change the rom?
fixed.i sold the phone