Hi,
I need and advice how remove the LCD port connector from the main board to replace it in my Magician,
Thanks a lot!
Related
HI everybody!
I have a big problem.
I have a Touchpro and the touchscreen-foil not works because its damaged, the wire is broken, but LCD works correctly.
Where can I buy a new foil, and where can I find a repairguide?
Its urgently required for my work.
Thx
Hello,
I have an Imate Ultimate 8150 which was dropped and the screen never came on after that. I opened the phone and found out that the LCD connector was torn in the middle. Can anyone help me with this one?
Where can i find the small cable that connects the LCD to the logic board. the LCD model is TD026TTEA1. I am also attaching picture for reference. I Need this little broken cable, Can anyone tell me where can i find it.
Thanks
LCD Strip
Hello Dear I am also facing the same problem I have this FPC Strip but its burnt also attaching the pictures .My phone is working without LCD Connection if anyone can help to find out this strip or someone having 8150 dead phone plz contact.
hi, i have tmobile mda vario 1, and my qwerty keyboard is not working because of scratched connectors in the end of flexibile flat cable. i cannot buy a new keyboard, and i want to solder this. is it possible?? i would be very appreciated if someone helped me. greets! oh, and the width of connector is 1 cm
Does anyone know where I can buy a new main board for my T-Mobile G2X (LG P999DW) and yes, the board is the issue - one of the tiny little ICs that is next to the LCD ribbon cable broke off and the screen no longer works, except the backlight. So I need to replace my main board but cannot locate one, any ideas?
Ok well here is my issue. While replacing the LCD assembly on my one plus one I managed to rip off the metal connectors(I believe they are called pogo sticks) on the logic board that make contact with the antenna's on the back cover. I ripped the ones that control the WiFi/Bluetooth and also the GPS one. I was trying to figure out how to fix this since when trying to soder them back on there was nothing they could be soldered to. I'm basically left with the empty spots on the PCB board where they are supposed to go. While looking at the logic board I saw that there are a couple of pigtail looking connectors on it that don't have anything particularly connected to them. I was wondering if I could use those to repair my connection issues. Or of any of you have any advice to give thank you for all your help ^_^