Hi,
I've got a problem with the ringer volume on my 750. Although everything is set at 100% volume, the phone only seems to ring at about half volume. I have disabled VC and checked all settings etc. Strange thing is, if I hit the volume button on the side when the phone starts ringing, the volume jumps to full. Any ideas how I can get the volume back? I am considering a hard re-set. What is the best way to do this and does Active Sync restore all contacts, tasks, etc. adequately?
Same issue here. I have no solution but it is driving me nuts!
same here
having the same issue since upgrading to WM6, it is my only true headache.
jrmccracken said:
having the same issue since upgrading to WM6, it is my only true headache.
Click to expand...
Click to collapse
me too, any fix?
what wm6 rom are you using? voda or att? what apps do you have installed?
--
does this happen with 0 apps installed?
i have wm5 and i some wierd volume things happened.
sometime when i put volume to minimum it always when ring back to half of maximum and sometimes opposite...
Related
Is there a setting to silence the phone on an incoming call when the phone is locked? Pressing the volume up or down WON'T work with me.
Thanks in advance.
i just tried on my phone several times from different numbers and it works fine for me.. both buttons too
Were you using any program such as manic AutoKeylock? or you just held the end call button to lock it?
Maybe I need to reset it but I didn't install any programs.
just end button i did not think i needed a program to autolock my phone
silence
Hi,
when somebody calls me i would like to silence the ringtone and not hangup. (on sonyericsson you press the side key for volume)
pressing volume up or down doesn't work for me either. is there a place in settings where you have to enable this feature? (i sure couldn't find it )
I would like to confirm that a hard reset fixed the problem! Pressing volume down while phone is locked SHOULD silence the phone by default.
Could be some software glitch that messed it up in the first place.
Figured out the problem. It seems to me that when there is an active connection, i.e EDGE is connected and it is showing in the near the cell signal, you WON'T be able to silence it by pressing a volume down.
If you go to connection manager and disconnect Edge by pressing 6, then lock it and let somebody call you, you WILL be able to silence it!
I have tried the above three times to confirm it. Seems pretty messed up if you ask me!
If you know how to solve the problem, please let me know.
Anybody figured out the problem (Read above)? I will paypal you $20 if you can get this to work!
Really, why did they mess it up like that when my previous phone, SDA, worked!
Hi--
I had Inesoft Phone 4.5 on my kaiser, and all of a sudden my volume control (the knob on the side) stopped working. I uninstalled it, but still have the same problem. On every call, incoming and outgoing, the volume goes all the way UP...kinda like I'm perpetually on speakerphone. Anyone have any ideas on how to fix this? It's about to drive me NUTS! Thanks!
trippwojohn
weird.. never heard of this problem.
try installing a different volume control.. and either keep it if it works or uninstall it to see if anything's change
I have a problem... Speaker phone is shouting in to my ear and I am unable to tune the volume down: it will not react to volume buttons during a call and I could not find any other way to adjust it.
People are "shouting in to my ear and I start talking loud as well... Very frustrating.
Any suggestions?
- Try restarting the phone
Tried that at least once in past 6 months of usage.
- Reflash stock
It is stock.
Anyone else have ideas? How does (and should for me) volume control work on your phones?
- Re-flash stock, because maybe you change something or installed a mod that interfere with the speaker.
I'm so frustrated. I lower the ringtone volume on my phone to a normal, human level. I don't mess with it. Then inevitably my phone rings and the volume is somehow back to super ridiculously freaking loud. What is changing my volumes? I've tried different things to see if I can trigger the change but it seems to happen by itself with no apparent trigger. Am I the only one with this issue? I'm pretty close to building Tasker profiles to put a bandaid on it, but it would be great to know the root cause.
Maybe you have this enabled in dialer settings?
Thanks for your reply. I was really hoping that would be it but strangely I don't even have that setting. I'm on MHA-L29C567B138
UPDATE: This setting cannot be found in the normal phone settings. Searching for "pocket" there returns no results. It's only accessible through the phone dialer, and the 3-dot menu that appears there. When I finally found it, I found it was set to "ON" so I turned it off. We'll see what happens.
gm007 said:
Maybe you have this enabled in dialer settings?
Click to expand...
Click to collapse
Thanks! It got to the point where I just left the thing on vibrate! I've turned this setting off, I'm going to give it a spin tomorrow and hopefully it's successful! Man this things LOUD!??
So after finding and disabling pocket mode, I set my ring volume low. I booted to recovery to clear the cache partition for good measure. Restarted. Volume still low. Charged my phone, had it next to me while sleeping, had it in my pocket, brought it to my desk, and checked the volume. Still low. Fixed? So I thought... Then 2 minutes later it rang LOUD and scared the crap out of me. I literally just checked the volume and it was low, but when the call came in it set itself all the way up. WT actual F?
So then I ran some more tests.
1. I set the ring volume to the lowest before the bottom volume, and turned off he phone screen. Then I called myself from my land line. The call came in with the volume up at about 80%.
I hung up, turned it back down.
2. this time I didn't turn the screen off. Just left it sitting there immediately after lowering the volume. Called the phone and it rang again at about 80% volume.
I FIXED IT!
Turns out when I got the phone and google moved my apps over from my old phone I moved over "Profile Widget", which I used to use in combination with Tasker on my old rooted Note 3 to manage my volumes. I never opened Profile Widget or had it on my desktop, but it was installed because it came along for the ride when google restored my apps from my account. I uninstalled Profile Widget entirely, and now my ringtone volume is respected.
I hope this helps someone else. If it's not "Profile Widget", try opening the "phone manager" app, click on "permissions" , click on "phone", and see what is listed and enabled there. That's how I tracked down what it could be on my device.
I found the solution,the ringtone volume keeps resetting itself to load because the pocketmode is switched on, so basically the concept of pocket mode is the volume goes up anytime the phone is in your pocket or is covered by something so that you don't miss you call.
To turn it off, open the dialer, go to settings, find pocket mode and toggle it off.
To find the dialer just search it in the search bar, the click on the three dots at the bottom of the screen to access the settings.
Thank You.
what is the minimum of the sound ..i cannot put less then 25% in volume setings..but this is same to loud for me
pocekt mode is off ...
Ringtone Volume
Hi there, i wanna know how to increase my ringtone
Volume it is lowest than normal phones .
Please help me ....
My device model micromax bolt q338 and it is rooted . Help me plz
Randomly, my phone started doing weird things when my headset is plugged in. It has never done this before. I have a feeling that this started when I Assigned Buttons that was meant for 3-buttoned headset on to mine with one button.
Every time I set it to control music playback, it randomly plays different music from my music app. And when I set it to control volume level, the volume goes crazy. But I tried headphones with no buttons at all and it doesn't do crazy things.
I have MIUI 11.0.5 and I've tried searching for this problem but I couldn't find a solution. Is there, like, a way to reset the settings for the assigned buttons?
Also, let me ask this, why doesn't my settings doesn't have options for one buttoned headset?
New User... Maybe said:
Randomly, my phone started doing weird things when my headset is plugged in. It has never done this before. I have a feeling that this started when I Assigned Buttons that was meant for 3-buttoned headset on to mine with one button.
Every time I set it to control music playback, it randomly plays different music from my music app. And when I set it to control volume level, the volume goes crazy. But I tried headphones with no buttons at all and it doesn't do crazy things.
I have MIUI 11.0.5 and I've tried searching for this problem but I couldn't find a solution. Is there, like, a way to reset the settings for the assigned buttons?
Also, let me ask this, why doesn't my settings doesn't have options for one buttoned headset?
Click to expand...
Click to collapse
I had the same issue. Turned out it was the issue with the headphone buttons. I just claimed money for the headphones and got refunded in full. If your headphones have warranty, claim it. If not, then there is just one thing you can do, put feviquick on the heaphone button so it can't be pressed at all.
P.S: It might even make the headphones unusable. Proceed with caution.