Device Authentication Failed - 8125, K-JAM, P4300, MDA Vario ROM Development

Hey all, I got a new rom today but when I flash it to my phone I get a "device authentication failed" after the phone boots up. It says to contact mobile operator and give them the numbers and letters listed, around 30+ Is there a way around this? I'm completely locked out of the phone at this stage, Button presses get no response, power wont shut off with power button and there are no menu options.

Related

Cant BOOT my Phone!

My phone wont boot properly.. I am using Moto G with ATT Go phone Micro Sim card.
I also noticed that when I have my phone in Boot menu, it says LOCKED at the top even though i purchased this phone UNLOCKED From amazon. Does this mean they did not unlock my phone properly?
It gets stuck when i turn it on and will not boot properly.
Its stuck at the "WELCOME" screen
IT says "choose language to begin"
then it says "english"
there is a start button under that.. i cannot get it out of this screen no matter what i do.
So is it that the phone is still not unlocked or is it another issue??
it says press start button to begin but its not working, when i press it, all it does is it says "START BUTTON"
but the button press isnt actually doing anything or advancing my options/menu any further..
Also had the problem where my phone wouldnt power up, but let it sit for a day and held power down for 2min then it finally Powered up but still wont boot properly.
gymfreak81 said:
My phone wont boot properly.. I am using Moto G with ATT Go phone Micro Sim card.
I also noticed that when I have my phone in Boot menu, it says LOCKED at the top even though i purchased this phone UNLOCKED From amazon. Does this mean they did not unlock my phone properly?
It gets stuck when i turn it on and will not boot properly.
Its stuck at the "WELCOME" screen
IT says "choose language to begin"
then it says "english"
there is a start button under that.. i cannot get it out of this screen no matter what i do.
So is it that the phone is still not unlocked or is it another issue??
it says press start button to begin but its not working, when i press it, all it does is it says "START BUTTON"
but the button press isnt actually doing anything or advancing my options/menu any further..
Also had the problem where my phone wouldnt power up, but let it sit for a day and held power down for 2min then it finally Powered up but still wont boot properly.
Click to expand...
Click to collapse
The Locked on the boot screen is the state of the boot loader in your case Locked nothing to do with network lock.
In boot loader mode scroll down (volume down) to recovery select this (Volume up) when it reaches recovery hold volume up for 4 seconds and hit power until The menu appears
now navigate to Factory data reset (volume keys go up and down and power selects) select this then select reboot.

[Q] Silver lining with rooting Fujitsu Arrows A 301F

Hey guys, I wasted about 4 hours, wishing to find a method to root my phone. The Fujitsu Arrows A 301F, just like the other Japanese phone, is very tough to unlock. However, several minutes ago, I found out that I can enter the recovery mode. I get there by pressing the fingerprint button, the power button and the vol- button together. Inside, there are two options only, one is cancel and the other is system check. I also find out that if I press the fingerprint button and the power button together, the recovery like screen appear. But it is called SD Download. I don't know how to use it. I hope someone can use them to find ways to root it.
P.S. When I use commend prompt and type "adb reboot recovery", a recovery like screen load up but saying:
Paramatar is unkown mode! [4]
start recovery_result
Rebooting!
so sad
Up
my phone has blocked cu'z i foget my password to unlock the phone to enter home screen
Now i can't use my phone i try to find the way to enter recovery just like you do but there is no wipe data
some one can help me now i just only see the phone on the lock screen SO SAD
Hey guys, I wasted about 4 hours, wishing to find a method to root my phone update Android version. The Fujitsu Arrows A 301F, just like the other Japanese phone, is very tough to unlock. However, several minutes ago, I found out that I can enter the recovery mode. I get there by pressing the fingerprint button, the power button and the vol- button together. Inside, there are two options only, one is cancel and the other is system check. I also find out that if I press the fingerprint button and the power button together, the recovery like screen appear. But it is called SD Download. . I hope someone can use them to find ways to root it. And find new update version
Thanks

Unlock device - Call history screen?

Hi All.
Currently facing a problem which Moto can't seam to help with.
The device is stock out of the box and is approx 8 hours old.
Every time i press the power button then unlock the device, it brings up the speed dial screen. This is even if its on Facebook, Gmail, when i press the power off button, press it again, unlock the device it brings the speed dial screen up.
I'm sure i'm missing something simple, tried a cache reset but just keep getting a no command screen, and even hard reset the device.
Many thanks
Marsden1002 said:
Hi All.
Currently facing a problem which Moto can't seam to help with.
The device is stock out of the box and is approx 8 hours old.
Every time i press the power button then unlock the device, it brings up the speed dial screen. This is even if its on Facebook, Gmail, when i press the power off button, press it again, unlock the device it brings the speed dial screen up.
I'm sure i'm missing something simple, tried a cache reset but just keep getting a no command screen, and even hard reset the device.
Many thanks
Click to expand...
Click to collapse
Does a hard reset via holding the power button down and volume up etc and the problem is still here.
Every time i unlock the device the speed dial screen is opened

[Q] Huawei Ascend G525 can't access bootloader

Hello,
So I've found this old Huawei in my drawer but since it has a pattern code and I can't remember it (and it isn't registered in my google account devices), I wanted to do a hard reset of the phone.
The problem is that I can't access it. It seems to have some kind of custom firmware of my operator (Swisscom, a Swiss operator) so it always boot immediately on the main screen. I've tried the "Power button + Up volume button" and "Power button + Down volume button" but none of them worked. I've had a look at the little manual of the phone (since I still have its box) but there are no pieces of information about bootloader.
So I've tried to get rid of the pattern with adb but I don't know if USB debugging is enabled (and I can't check it since I don't know the pattern lock). So I still tried but the device is shown as "offline" in adb (and I've tried to plug the phone in different USB plugs and with different USB cables : it is still shown as offline).
So here I am with that phone I can't do anything with.
Any ideas or should I simply get rid of it ?
Thanks in advance.
shura11 said:
Hello,
So I've found this old Huawei in my drawer but since it has a pattern code and I can't remember it (and it isn't registered in my google account devices), I wanted to do a hard reset of the phone.
The problem is that I can't access it. It seems to have some kind of custom firmware of my operator (Swisscom, a Swiss operator) so it always boot immediately on the main screen. I've tried the "Power button + Up volume button" and "Power button + Down volume button" but none of them worked. I've had a look at the little manual of the phone (since I still have its box) but there are no pieces of information about bootloader.
So I've tried to get rid of the pattern with adb but I don't know if USB debugging is enabled (and I can't check it since I don't know the pattern lock). So I still tried but the device is shown as "offline" in adb (and I've tried to plug the phone in different USB plugs and with different USB cables : it is still shown as offline).
So here I am with that phone I can't do anything with.
Any ideas or should I simply get rid of it ?
Thanks in advance.
Click to expand...
Click to collapse
Have you tried holding all three buttons down?
It doesn't work either. When I start pressing the Power button (even if I was holding the volume buttons before doing it), it boots the phone immediately (you see the logo of the mobile operator and then it shows you the main screen with the pattern lock).

[Completed] GT-N7000 stuck in both Welcome & Recovery mode!

Hi guys,
this is my first post on this comprehensive website which helped a lot in the past by reading slimmer issues and their fixes,
now I have hard one, my oldie Galaxy note, GT-N7000, stopped working with the following symptoms,
The phone suddenly stopped, black screen, I removed the battery for a minute, put it back, pressed power button the phone stuck on Welcome Samsung logo screen,
removed the batteries for a minute, pressed the 3 combination Home+Power+up the phone give the first screen of recovery Waring " A custom OS can ......, then two option Volume Up: continue and Volume down to cancel (restart phone), if I press volume down the phone black died! otherwise if I press volume up the phone go to " downloading don't turn off target" stuck forever, no other keys are responding, I had to remove the battery and start again.
when I connect to Kies, refuses the "emergency firmware recovery" as I don't have recovery code, as well as when I use "firmware upgrade and initialization" it prompt me that this device is not supported!
lastly when I am in downloading mode connecting to Kies, the application trying to connect keep circulating like trying to connect with no result.
I charged my both batteries to 100% , changed 3 PC's, used different usb cables, nothing worked.
If you have an idea to share, I would be much grateful
Regards,
GTi9220 said:
Hi guys,
this is my first post on this comprehensive website which helped a lot in the past by reading slimmer issues and their fixes,
now I have hard one, my oldie Galaxy note, GT-N7000, stopped working with the following symptoms,
The phone suddenly stopped, black screen, I removed the battery for a minute, put it back, pressed power button the phone stuck on Welcome Samsung logo screen,
removed the batteries for a minute, pressed the 3 combination Home+Power+up the phone give the first screen of recovery Waring " A custom OS can ......, then two option Volume Up: continue and Volume down to cancel (restart phone), if I press volume down the phone black died! otherwise if I press volume up the phone go to " downloading don't turn off target" stuck forever, no other keys are responding, I had to remove the battery and start again.
when I connect to Kies, refuses the "emergency firmware recovery" as I don't have recovery code, as well as when I use "firmware upgrade and initialization" it prompt me that this device is not supported!
lastly when I am in downloading mode connecting to Kies, the application trying to connect keep circulating like trying to connect with no result.
I charged my both batteries to 100% , changed 3 PC's, used different usb cables, nothing worked.
If you have an idea to share, I would be much grateful
Regards,
Click to expand...
Click to collapse
You have already asked your question in the corect forum here
http://forum.xda-developers.com/galaxy-note/help/gt-n7000-stuck-welcome-recovery-modes-t3461297
You do not need to ask in assist as well
Regards
Sawdoctor

Categories

Resources