after i installed wm5 in my xda2,i tried to perform hard reset which is juz press the power button + the soft reset button.
after tat,it til not be hard reseted...y?
what is Enable KITL when i succesfully enter the menu to format??
try RESET BUTTON+CAM BUTTON+REC BUTTON...
after you see menu, chose
Enable KITL = NO
Clear Reg Hive = YES
Format Storage = YES
and press D-PAD
thx..i will try later...
Related
Hi All,
I upgrade my Himalaya to WM5 2.3a64.
Then I wanted to change to 2.3a32 but soprise, after the upgrade all the data on my PDA remain and it is not clean.
How can I upgrade to a clean install like a new PDA?
Even Downgrade to WM3 didn't wipe the data!
to hardreset your device.
Press ResetButton and hold down CameraButton + RecordButton.
Hold them pressed until the "Boot Options" menu appears on the screen.
Select the options as follows:
(for selecting use RecordButton, change values with CameraButton)
Enable KITL -> NO
Clean Registry Hive -> YES
Format Storage -> YES
When done, press DPad and wait until OS starts.
10'X
Hello,
I'm lost into key ordering to put the folio 100 into different modes/stats...
Do i write synthesis, Can someone confirm this ?
(I probably found an interseting toshiba doc for locked/bricked folio to force reboot folio 100...)
MODES :
* Normal mode
This il the default starting mode, when you power folio100 running the OS.
* Recovery mode
This is the mode where you can reset the folio 100 default settings, and you can upgrade the ROM with new one automatically
(http://aps2.toshiba-tro.de/kb0/OPT0C032V0000R01.htm)
* Bootloader mode
With this mode you can propably use nvflash to collect and push data over folio100
or exemple to dump all partitions datas, etc...
ACCESS :
Power + VolumeUp : Recovery Mode access
Power + VolumeUp >> VolumeDown : (Cancel) Start OS
Power + VolumeUp >> VolumeUp : Recovery Mode menu
Power + VolumeUp >> VolumeUp > VolumeUp : Factory Reset menu
Power + VolumeUp >> VolumeUp > VolumeDown : System Update menu
Power + VolumeUp >> VolumeUp > VolumeDown > VolumeUp : System Update confirmation
4 x Power + VolumeDown >> Bootloader mode
5 x Power + VolumeDown >> BE CAREFULL : This seem to Lock/brick definitivelly the Folio (Firmware seem to go into a deadloop....)
But I dont' know if it's the solution, but you can apparently force Folio100 to reboot probably out of the deadloop firmware with the "force reboot pinhole"
(http://aps2.toshiba-tro.de/kb0/OPT0C032F0000R01.htm). I dont try this, I don't know if it's work, i hope Dexter_nlb do this try with hes bricked Folio 100
(seen here http://forum.xda-developers.com/showthread.php?t=831086)
Thanks to confirm me
Molux
PS: sorry for my bad english
Autoresponding...
Hello,
Hum...(<-- embarrased) I just undertand that back black platic panel it's very very easy to remove (unlike iphone & co, for exemple) to access to battery, etc...
So i think most of you found the "reset pinhole" a long time ago...
Dexter send me a message to clearly say that "Reset pinhole" DONT leave the "deadloop".
Actually there is NO SOLUTION to leave this deadlocked stat
Molux
I made the whole process, but has more than 10 minutes in the second screen gtablet help please: S
1.) Error Message: E:Can't mount /dev/block/mmcblk3p2: :
Resolution: the SD card has become corrupt. Please follow these steps to correct the issue:
1.) Turn the tablet off if not off already.
2.) Press and HOLD the power power button and rapidly press the VOLUME UP button (whille holding the power button without letting go). The tablet should enter recovery mode.
3.) User the volume buttons to scroll to Advanced, then press HOME to select.
4.) User the volume buttons to scroll to Partition SD Card , then press HOME to select.
5.) User the volume buttons to scroll to 2048, then press HOME to select.
6.) User the volume buttons to scroll to 0, then press HOME to select.
7.) Press Home to Reboot Recovery
8.) Press Home to Reboot System Now
*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*
EDIT Solved, i use nvflash and restore system, thanks anyway*-*
*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*
Forgot password pattern without setting up of gmail id?
Please help it's only one day old mobile ? How to recover without gmail ?
vids107 said:
Forgot password pattern without setting up of gmail id?
Please help it's only one day old mobile ? How to recover without gmail ?
Click to expand...
Click to collapse
1. You first have to power off
your Android smartphone. In
order to do that, press the
power button and select
“power off”.
2. Wait a few seconds and then
press the volume up and
volume down buttons along
with the power button at the
same time for about 3, or 4
seconds.
3. Release the buttons; the
Moto G boot menu must be
now displayed on your
phone.
4. Use the Volume Down button
in order to scroll down and
also up as the Volume Up
button can be used only for
selecting an option.
5. Scroll down until you reach
“recovery” and the press the
Volume Up button once.
6. The android logo will now be
displayed on your phone.
7. Hold down Volume Up and
Volume Down buttons for
about 5 seconds and press
power button once.
8. The recovery mode menu
should now be displayed.
9. That was all; you can now
choose wipe data/factory rest to hard reset your
Moto G
and then choose reboot system now
thats it ur mob will become like new mobile
Is there a way to access the data on the device without getting past the lock screen? Since it isn't encrypted I'm wondering how easy it would be to get a backup of your data and apps before you do the reset.
DarkDarth said:
Is there a way to access the data on the device without getting past the lock screen? Since it isn't encrypted I'm wondering how easy it would be to get a backup of your data and apps before you do the reset.
Click to expand...
Click to collapse
read well and try it
Steps On Bypassing or Unlocking
Pattern Lock or Password on Android
Devices Without Losing Data
Now, before you take any action on
your device, make sure you know it well
Requirement For a Successfully
Operation
1. Aroma File Manager 1.80 which
you can download from https://code.google.com/p/rom-cmexmini/downloads/detail?name=aromafm-1.80.zip&can=2&q=
2. Your Locked android device
either locked by pattern lock or
password
3. A Memory card( the memory
card of the android device)
You will be surprised that we don’t
need a computer, that the awesome
thing about this method of unlocking
password and pattern locks.
To the main business proper, how to
unlock the pattern lock or password,
please follow the steps
Step 1
Once you have download the Aroma
file manager , move it to the memory
card and insert the memory card to
the android device
Step 2
Open your stock recovery and
different device has there own way of
entering stock recovery, so I advise
you Google it out along with your
android device name. Once you have
it, enter into stock recovery which is
a black interface
Step 3
once you are there, use your volume
+ and volume – to scroll up and
down and use the middle button to
select
Step 4
Now Mount and storage>> Mount
Everything>> Mount System>> Mount
data>>Mount afs>>Mount
Preload>>Mount SDcard>> Mount
ExternalSD>> go back>> Install zip
from SDcard>>Choose zip from
external SDcard
Step 5
The find the Aroma File manager you
download into the sdcard and select
and select “Yes Install Aroma file
manager” then it will load and the
file manager will open in the recovery
mode
Step 6
In the aroma file manager, go to
Settings and Go to bottom n select
“Automount all device on start ”
which is the second to last option
and then exit from aroma file manger.
Step 7
perform step 5 again and the Aroma
file manager will update and open
again
Step 8
go to the Data Folder>>>then System
folder and find the gesture.key if it is
password lock that locked your
phone or password.key if it was a
password lock and press the file for
long and the option to delete the file
will pop up and delete it
Step 9
Exit the aroma file manager and
restart to the normal interface and
when the device has finished restart
you will still find the pattern lock or
password there but you are to use
any pattern lock or password and it
will accept and your device is
unlocked but note the pattern you
use and password.
anandrd said:
1. You first have to power off
your Android smartphone. In
order to do that, press the
power button and select
“power off”.
2. Wait a few seconds and then
press the volume up and
volume down buttons along
with the power button at the
same time for about 3, or 4
seconds.
3. Release the buttons; the
Moto G boot menu must be
now displayed on your
phone.
4. Use the Volume Down button
in order to scroll down and
also up as the Volume Up
button can be used only for
selecting an option.
5. Scroll down until you reach
“recovery” and the press the
Volume Up button once.
When I select 'recovery' and press vol up, nothing happens, no android logo, the screen just goes black and the phone is still powered off. I'm trying to factory reset to get rid of a screenlock pin that I forgot. I have tried pressing 'factory' and it doesn't get rid of the screenlock pin... The phone seems to reboot, but the stupid pin screen is still there. Anything else I can try?
6. The android logo will now be
displayed on your phone.
7. Hold down Volume Up and
Volume Down buttons for
about 5 seconds and press
power button once.
8. The recovery mode menu
should now be displayed.
9. That was all; you can now
choose wipe data/factory rest to hard reset your
Moto G
and then choose reboot system now
thats it ur mob will become like new mobile
Click to expand...
Click to collapse
When I select 'recovery' and press vol up, nothing happens, no android logo, the screen just goes black and the phone is still powered off. I'm trying to factory reset to get rid of a screenlock pin that I forgot. I have tried pressing 'factory' and it doesn't get rid of the screenlock pin... The phone seems to reboot, but the stupid pin screen is still there. Anything else I can try?
---------- Post added at 11:47 PM ---------- Previous post was at 10:51 PM ----------
I finally was able to get rid of the screen lock pin by using this info:
External Reset
If you are unable to access the phone's menu to perform the standard reset you can attempt an external factory reset.
Notes:
When using this feature; everything is deleted from the device.
Reset will require a minimum battery level of 25%. If you are unable to perform a reset, please charge for 20-30 minutes and try reset again.
1. With the phone powered off, press the VOL DOWN KEY for 2-3 seconds then POWER key then release.
2. The device will display different BOOT OPTIONS
3. Use the VOL DOWN Key to SCROLL to Recovery and VOL UP Key to select
Tip: If the device reboots, you may have waited to long to make a selection, you will need to begin the process again.
4. The device will display the Motorola logo and then the Android in distress ( logo with Exclamation mark)
5. Press and hold the VOL UP key for 10-15 seconds. While still holding the VOL UP key tap and release the POWER key
Tip: You can try this step, holding the phone in landscape. If you are stuck on step 6, try a force reboot by pressing the Power key and Vol Down key, and start the process again.
6. The device will display additional menu options (Text will appear in BLUE)
7. Use the VOL DOWN Key to scroll to Wipe data / factory reset and the POWER Key to select this option
8. Use the VOL DOWN key again to select YES - delete all user data and press the POWER key to CONFIRM
9. Once the Formatting is complete, press the POWER key to confirm a REBOOT
10. The device will reboot and start the normal power up sequence
Moto g4 plus not accepting Gmail address used to sync device
I managed to factory reset my Moto g4 plus phone...but after rebooting the phone and trying to set up the phone again, it did not accept the Gmail address which I had used to sync the device earlier...is there any way to bypass this requirement so that I can start using the phone again ?
WARNING: This method will erase your internal data and your current ROM since you are installing a custom ROMM so this method should be fine : )
A. Go to recovery mode, shown below for various devices
Firstly shutdown/boot your android device then perform the below combination until boot logo shows up
IF YOU JUST NEED TO EXIT THIS MODE ASAP KEEP PRESSING POWER KEY TILL THE LOGO APPEARS
NOTE: Also in this mode touch screen may not work, it's the default, Volume buttons are used to navigate and power button to select, you may need to select the recovery mode.
-> Samsung | at the same time press and hold these buttons: Home, Volume up, Power
-> Redmi | at the same time press and hold these buttons: Power and Volume Up
-> Realme | at the same time press and hold these buttons: Power and Volume Up
-> Micromax | at the same time press and hold these buttons: Power and Volume Up
-> Motorola | at the same time press and hold these buttons: Power and Volume down
-> One Plus | at the same time press and hold these buttons: Power and Volume down
-> Vivo | at the same time press and hold these buttons: Power and Volume down
-> Oppo | at the same time press and hold these buttons: Power and Volume down
-> Pixel | at the same time press and hold these buttons: Power and Volume down then release vol down when the logo appears then at the same time click vol up once and now release both the buttons
B. Goto wipe-> Advanced wipe
a. Select dalvik+data+internal storage+cache+system( you are deleting your current rom )
b. Then swipe to wipe
c. If you get the error message then
i. Go back to Advanced Wipe & select data+system
ii. select repair file system, if error still occurs then goto iii
iii. Change File System-> exFAT-> swipe to select then repeat steps i & ii-> Change
File System-> EXT4-> swipe to select
d. After the above goto home in TWRP-> Reboot-> Recovery
C. If It's still alive then goto Wipe-> Format Data, this will just reset the phone. Then Wipe Dalvik cache before flashing.
D. Keep the custom ROM & Magisk(or any other of ur choice) in an ext SD card, after the above steps just flash Magisk to root your phone before flashing the ROM.
CREDITS: Youtube-> TechBoy Mrrajsingh111