Hi, I have problem with my s7 when I connect him to pc, pc doesn't see him but it is charging. What could be the problem? usb debugging on, fastboot doesn't see him too...
Hi first off try and differing cable. be 100% it a usb data cable as well.
when you plug the phone in do you get a pop up asking if your phone can connect to the PC. I take you do not. try swiping down from the top and see if you get any message asking you about it.
if you this should work.
The problem was motherboard I replaced it and everything is ok now. Thank you.
Related
Yes I know some will say install drivers or slide down the notifications.
But the problem is when I plug in, there isn't any notification for you to switch to disk drive mode.
Everything was working fine last week. There was no problems detecting my phone on my home and any PC at work. I have drivers install in my computer and can do adb commands
But now, when I plug in, it only shows the charging light.
I have done the following
On and off the USB debug option
Reboot phone
Try a 4 micro USB cable
Tried different USB slots on the computers
Use usbdeview and delete all HTC drivers and resinstall also not working
Remove my micro SD card and reinsert.
All doesn't work.
Strangely, one thing does. When I plug in the PC and I need to reboot, with my phone still plug in my PC. The notification will appear and I can do all things normally. But once I unplug and plug in again, same problem. Only can be solved with next reboot with phone plug in before hand. If windows is already loaded, it cannot be detected.
I though it was the rom. But I went to boot loader and same thing. It shows fastboot AC. If I do the reboot windows method, it will show fastboot USB .. will show fastboot AC if I replug in
I am starting to think my USB port on my phone is faulty.. any ideas?
Try plugging it and wait for a long time. Since I formated my computer it takes like 10-15min for my phone to show up after I plugged it. No idea what's causing it though.
Done that , charged it for 1hr plus, same
Best thing is try different cable, there is some issue with htc cable your pc sometime dont recognize phone, Other thing you can do it is keep ur phone connected to pc then boot your phone to Hboot or bootloader or fast boot, your pc will recognize your phone with generic driver.
jasminthoria said:
Best thing is try different cable, there is some issue with htc cable your pc sometime dont recognize phone, Other thing you can do it is keep ur phone connected to pc then boot your phone to Hboot or bootloader or fast boot, your pc will recognize your phone with generic driver.
Click to expand...
Click to collapse
hmm tried 4 cables.. same results..
Using the same cable, tried my mum's desireHD.. no problems detecting the USB each time..
Bootloader mode, it shows Fastboot AC
instead of Fastboot USB.. unless reboot my windows..
Oh i tired another micro SD card, same results.. :/
why mess with cables... AirDroid.
connect your phone to the pc via wifi.
direct link to the market: goo.gl/9YG73
but if you must connect via cable for something... have you checked the most obvious place? (sounds like you probably have but just in case...)
settings > connect to pc > default connection type
Mainspring said:
why mess with cables... AirDroid.
connect your phone to the pc via wifi.
direct link to the market: goo.gl/9YG73
but if you must connect via cable for something... have you checked the most obvious place? (sounds like you probably have but just in case...)
settings > connect to pc > default connection type
Click to expand...
Click to collapse
it cant even be detected, no notifications mate..
Flashed ROM......
Mine is doing the same thing. It didn't start until I flashed the new ROM. When in Windows, I just un-plug it, and re-plug it. Then it shows up immediately. But it always seems to show in flashboot.
UnixSlayer said:
Mine is doing the same thing. It didn't start until I flashed the new ROM. When in Windows, I just un-plug it, and re-plug it. Then it shows up immediately. But it always seems to show in flashboot.
Click to expand...
Click to collapse
hmm i even revert back to my original 1.35.707.1 RUU...
still not working.. i guess its time to claim warranty
try switching off firewall or/and antivirus i had same problem with eset 5 blocking phone so i put the stings to learning mode then plugged phone in and it created a new rule and shows up,then change setting back to what it was originally on
jonpickles70 said:
try switching off firewall or/and antivirus i had same problem with eset 5 blocking phone so i put the stings to learning mode then plugged phone in and it created a new rule and shows up,then change setting back to what it was originally on
Click to expand...
Click to collapse
and if that isn't working try it with HTC sync. which gives you the drivers of the device.
I got the same problem... any idea...
please help me..
Is there where USB cannot be recognized issue? If this is, I have a simple solution which took me forever to figure out.
I know this method sounds ridiculous, but give it a try. Unplug your charger connected to your computer/laptop and plug it in to a different outlet. Replug the USB with your phone connected, give it a sec, and it should work.
what operating system is your PC running? I was gonna say perhaps it might be a faulty USB port...
i have the same problem
What I do is go to devices and printers and then android phone then properties then hardware and disable the reenable the drivers. As soon as you reenable the drivers it should show up in disk mode. Hope this helps. This is the only phone I've had this problem with.
Hi all,
Suddenly my pc stopped recognizing my s8+, tried several pcs, macs, even my car doesn't recognize it. When I plug the USB Cable(OEM) nothing happened, the phone just charges, and I try to change the USB configuration but nothing happens, not even adb recognize it anymore. One morning it start working again, but next time I tried again, it stop working again.
What can I do?
is debugging enabled? (just starting with simple stuff first)
U have a bad port mine was like that it would work sometimes for 5 min and then unrecognized it shorted out or something
First try to change the cable. this will be the cheapest solution.
Yes it is, sorry I didn't specified it.
Already tried. Thank you.
What did you do? take it to warranty?
Hello,
I'm no longer able to connect my s6 edge SM-G925I to my PC through USB:the USB is only charging.
I tried severals usb but without success.
I also tried to replace my phone usb connector but always it is only charging
Any help please about how to fix this?
Thanks
I had this problem before, you should try to connect to another computer, laptop... Mine phone is only charging with my desktop, but on my laptop, it can show file manager where I can transfer files. Good luck
Hi,
Thank you for the forum (first post).
Trying to get the S6 recognised by pc:
When the phone is connected to the laptops usb port via micro usb and cable (usb debugging on, samsung usb drivers downloaded, mtp:usb on) the computer makes the 'plugged in' audio sound but there is no 'permission to transfer files via usb' type message.
It does charge.
Does this maybe mean the charging port is broken/damaged, or the usb is broken?
Only other detail is that I once got the computer to say in a pop up that it was labelled as a 'samsung s6' rather than unknown device, which it normally does. This any symptom maybe its just a software issue?
Trying to get my computer to connect to the phone and have tried most if not all software solutions so far (including factory reset) and now looking if its hardware. Any tips to get it connected welcome.
Thank you,
David
david7632 said:
Hi,
Thank you for the forum (first post).
Trying to get the S6 recognised by pc:
When the phone is connected to the laptops usb port via micro usb and cable (usb debugging on, samsung usb drivers downloaded, mtp:usb on) the computer makes the 'plugged in' audio sound but there is no 'permission to transfer files via usb' type message.
It does charge.
Does this maybe mean the charging port is broken/damaged, or the usb is broken?
Only other detail is that I once got the computer to say in a pop up that it was labelled as a 'samsung s6' rather than unknown device, which it normally does. This any symptom maybe its just a software issue?
Trying to get my computer to connect to the phone and have tried most if not all software solutions so far (including factory reset) and now looking if its hardware. Any tips to get it connected welcome.
Thank you,
David
Click to expand...
Click to collapse
have you gone thru the usual suspects? (diff cable, usb port, diff computer altogether, blah blah blah)
Same happens here, it was fine after flashed Rom now it wont recognize it for some reason
As the title states, my phone is no longer being recognized by my computer when I plug it in. I've tried multiple cables, multiple ports on the computer, both ports on the phone, factory resetting the phone, uninstalling and re-installing drivers on my computer, booting to Ubuntu so I wouldn't need to worry about drivers. Nothing has worked. I'm not even getting the USB prompt on my phone when I plug it in. It DOES charge but I'm not able to transfer files, adb or anything. ASUS wants me to send the phone in but I don't want to go who knows how long without my phone, plus I don't think it's right that I have to pay to ship it when it's their phone that is ****ting the bed. Could anyone PLEASE help me? Thanks.
Maximus from the 915 said:
As the title states, my phone is no longer being recognized by my computer when I plug it in. I've tried multiple cables, multiple ports on the computer, both ports on the phone, factory resetting the phone, uninstalling and re-installing drivers on my computer, booting to Ubuntu so I wouldn't need to worry about drivers. Nothing has worked. I'm not even getting the USB prompt on my phone when I plug it in. It DOES charge but I'm not able to transfer files, adb or anything. ASUS wants me to send the phone in but I don't want to go who knows how long without my phone, plus I don't think it's right that I have to pay to ship it when it's their phone that is ****ting the bed. Could anyone PLEASE help me? Thanks.
Click to expand...
Click to collapse
If your phone won't connect to the computer using the USB cable, then the FIRST thing most people do you've done, which is switch cables and rebooting the phone (factory reset is extreme but you did that also).
The second thing most people do is install the manufacturer's drivers, which you also did.
The third thing you can do though, is connect the phone to the computer WITHOUT the USB cable (i.e., over Wi-Fi) because that will work even if your phone port is broken and even if the USB cables are bad and even if the drivers aren't on the computer.
Below are screenshots of just some of the ways to connect the phone to the computer over Wi-Fi without any cables, and if you want, you can follow one of my tutorials on the subject.
Hope this helps.
GalaxyA325G said:
If your phone won't connect to the computer using the USB cable, then the FIRST thing most people do you've done, which is switch cables and rebooting the phone (factory reset is extreme but you did that also).
The second thing most people do is install the manufacturer's drivers, which you also did.
The third thing you can do though, is connect the phone to the computer WITHOUT the USB cable (i.e., over Wi-Fi) because that will work even if your phone port is broken and even if the USB cables are bad and even if the drivers aren't on the computer.
Below are screenshots of just some of the ways to connect the phone to the computer over Wi-Fi without any cables, and if you want, you can follow one of my tutorials on the subject.
Hope this helps.
Click to expand...
Click to collapse
Would I still be able to adb using the wifi method? My main issue is trying to remove the old Google Pay app. Which I'm unable to unless it's through adb.
Just an update. I was, in fact, able to run adb commands while connected using wi-fi. Thank you @GalaxyA325G for your input.
GalaxyA325G said:
If your phone won't connect to the computer using the USB cable, then the FIRST thing most people do you've done, which is switch cables and rebooting the phone (factory reset is extreme but you did that also).
The second thing most people do is install the manufacturer's drivers, which you also did.
The third thing you can do though, is connect the phone to the computer WITHOUT the USB cable (i.e., over Wi-Fi) because that will work even if your phone port is broken and even if the USB cables are bad and even if the drivers aren't on the computer.
Below are screenshots of just some of the ways to connect the phone to the computer over Wi-Fi without any cables, and if you want, you can follow one of my tutorials on the subject.
Hope this helps.
Click to expand...
Click to collapse
i click on tutorials but it link to nothing. im having issues with my Rog 5 with signal getting drop since my last update. my pc doesnt respond to usb and my phone doesn't show any sign of connections to pc at all while being plug.
ZeroKo0 said:
i click on tutorials but it link to nothing. im having issues with my Rog 5 with signal getting drop since my last update. my pc doesnt respond to usb and my phone doesn't show any sign of connections to pc at all while being plug.
Click to expand...
Click to collapse
Not sure what to tell you about your signal dropping, but
is the video I used to finally use adb via WiFi.
Have you tried clearing the adb authorizations (in developer options) with the phone disconnected and then connecting? Sometimes a change can trigger the phone to stop recognizing the computer as allowed without treating it as a new connection.
twistedumbrella said:
Have you tried clearing the adb authorizations (in developer options) with the phone disconnected and then connecting? Sometimes a change can trigger the phone to stop recognizing the computer as allowed without treating it as a new connection.
Click to expand...
Click to collapse
Yeah, I had tried that already as well.
Maximus from the 915 said:
Yeah, I had tried that already as well.
Click to expand...
Click to collapse
Sounds like you're stuck with WiFi or the repair then.