Hi,
My mobile which was working fine till last night. Today morning without no reason its not switching on.
Make and model : Lenovo A7700 (2016)
OS : Android 6
There is no issue with battery or display or any part, it's was just on the table whole day idle. No physical damages.
All of sudden it's not switching on. When connected to charge even the logo needs to come if battery Is drained but its acting like a brick. If the display is the problem then atleast while connecting to charge the vibration needs to come. So there is no problem with display or battery.
Tried all the possible ways to turn on, nothing helped. When connected to PC it says last device you tried to connect was malfunctioned.
What happened actually all of sudden in one night.
I have done nothing recently with my phone nothing absolutely. It was just on the table. Last night I charged my phone and after Charing completed unplugged and kept as it was.
Please anyone help me so many documents are there in the internal storage which atleast I need to transfer to another phone.
Please kindly anyone help me with this ASAP.
Thank you in advance.
P.S : My mobile is not rooted or side loaded with anything. It's just as it is from the start. As mentioned earlier nothing absolutely nothing I done with mobile. My mobile had scheduled switch on and off feature so it will switch off on night 1o clock and turns on morning 6 o clock that was enabled many years ago and till yesterday no problem. But it today it switched off at 1 o clock AM with full charge and when I tried to turn on manually it's is not working.
Please Help me anyone to atleast recover data from internal storage.
Related
I've been running a ROM I built from the consolidated kitchen this weekend without any problems. Today I updated the radio to 2.69.11 from the cingular 2.25.11. After the flash the phone froze on the windows mobile screen. After some time I tried to reset the phone and it froze again, a few more tries and it finally boots up. I didn't pull the memory card when I flashed and thought that might have been the problem so I flashed again even though the phone was showing 2.69.11. I don't remember everything after that but it wouldn't boot up and I have tried flashing the original Cingluar ROM & T-mobil 2.26 without any luck.
The phone is stuck in bootloader now and is getting a error code 302 I think it's because the phone doesn't stay on when the USB cable is attached. It gets to about 15% and the phone resets and the error 302 pops up. When connected and not trying to update the phone turns on and off in the bootloader screen. I have pulled the battery, rebooted the laptop, tried using mtty,and pulled the sim. I thought the original problem might have been because I flashed at 52% battery. I put a older battery in after that appeared to have a good charge. Right now I put the phone on charge with the newer battery to see if this helps. I am not sure if it is charging because the orange light is not on, I can't get the phone to stay turned off when plugged into the charger and the bootloader screen is on.
And yes I have been searching for hours for a solution to this problem.
Also looking for a post I read about doing a master reset, I have tried holding the 2 soft keys when turning on, didn't help.
I think this says it all I have tried everything, does anyone anything else to try?
Thanks
UPDATE: went out for a few beers and some food. Not sure it the battery charged (bootloader screen on the whole time it was plugged into the charger)
Tried flashing again with cingular ROM, got about 20% and phone shut off and turned on again in bootloader. Flash gave 302 error again. Tried again and phone reset (on and off) every 5 seconds when connected to laptop with USB.
I'm hopping someone out there has a answer for this problem.
Back from the dead HALLAULA!!!!
This morning I spent more hours searching still didn't out find anything.
I tried mtty again and noticed that I never got to the screen that shows USB>
to enter the command "set 14 0"
I came up with a thought and this is what I did. Created a new ROM, OS only. Thinking it will load faster than any other ROM. It reached 100% in 3 minuets the whole I'm coaching come on baby don't restart and than going (don't know how to explain the feeling) waiting the next 2 minuets to get to finished. But it got there booted fine. I don't know why it stayed on this time and didn't restart, maybe having the battery out all night had something to do with it. After I flashed the Cingular ROM than the original I created and lastly Radio 2.69.11
I hope this helps someone in the future,
i need your help
hi man I had a prophet s200 and give me the same error 302 but, with the diference in my case got 98% adn then stuck in boot screem, please help me if you can...and sorry for my english
Guys,
It may help checking out this thread!
http://forum.xda-developers.com/showthread.php?t=294107
Can you help me out?
How did you create a new ROM - OS only? I'm having the same problem..can you walk me through this?
Thanks
How did you create another ROM (Operating System only)? I'm having the same problem and I have tried for the past 2 weeks - but no luck. Can you walk me through it?
Thanks
I used the consolidated kitchen (sticky at the top of this forum)
Uncheck everything on Build OS.
My problems started from a version of battery status that caused the original problem and not having enough of a charge on my battery.
Make sure you are CID unlocked (if you have a G3) and your battery is charged.
Umm, you can't uncheck everything in build OS or you will have problems, especially if you don't check a tuchflo or non touch flo dll or choose a commanager and probably a few others things. I don't have build OS up in front of me to check. The whole point to this msg is that you can check everything in build OS (besides the ones that say choose only 1) and it will build an OS only rom for you. That's the whole point behind build OS.
You are correct, I was kind of going from memory since I had built the striped down ROM awhile ago.
Hi xda members.
First of all I wanna say two things:
1). My english is not very strong, so excuse me for it.
2). I'm not dev or something like that. I'm totally noob, so I would ask many question if I don't get to understand. Sorry for that too.
OK, now I'm going to the point:
My Sony Xperia S is dead. I don't know if it's bricked (soft or hard) or is battery dead or something like that. I just know the symptoms and that's what I'm going to tell you:
I got the update (for that date): 6.2.A.0.200 (stock), and everything was OK; three days after (for some reason) I restored to factory settings and wipe all data (battery was over 90%). The phone restarted and worked fine. After that I used for listening some music and the phone got under 20% battery. At that exact moment I turned off, well, I did hard reset (power+volume up till three vibrations) and that's it... never come back.
I've tried everything I've read around the Internet: Try to turn it on, try hard reset (power+vol up till three vibrations), tried charging it a half hour, tried charging it like for 14 hours (or even more!), tried leaving it unplugged to let the battery die like for two days and plug again (nothing happened), tried removing battery (yes, I dismounted the back and remove battery for few minutes), tried to repair it with PC Companion (Companion didn't recognize it), tried Sony Update Service (didn't work either), even I tried to flash it or recover it with flashtool but the phone doesn't connect, or when it does, flashtool says "Device connected with USB debugging off" (tried connecting while holding vol down, but nothing; tried holding vol up too, nothing..).
My phone details is can give:
Sony Xperia SL (LT26ii)
Jelly Bean (6.2.A.0.200) (stock)
Locked bootloader
Development options (USB debugging) OFF!
Battery stats before is came dead: like 18%
Battery stats now: no idea (I charged it for like hours and then let it unplugged for two days...)
I've already read many threads but didn't find a solution.
What could I do?
How could I enable USB Debugging with my phone dead?
How could I get the flashtool to work with it?
What in the hell could I do?
Please!! I really need your help!
I work all day, so I won't be able to respond your questions (if any) immediately, but I will respond at nights (I'm from Colombia).
Thanks for your help.
Hey, moderator. Could you please close this thread, since I don't own the device anymore and it's not an useful thread at all?
Thanks.
Hi,
I have a iphone 3gs which i purchased from eBay long back and.. Long story short, now I have multiple problems :
1> The phone doesnt show/have the IMEI # and neither does any other details like firmware etc.
2> The phone randomly gets restarted continuously almost every 1min.
I tried replacing the battery thinking the issue with restart would be with the battery but still it doesnt stop. Due to this issue I am unable to install the IOS software as it gets restart frequently and the installation stops in the middle. I am now thinking it might be problem with the 30pin charger cable (viz., not genuine) that i am using but not sure. Can anyone help me on how to fix this issue of restart and to get back the IMEI# on the phone again. Any help or suggestion would be really great.
I have a totally stock phone, i.e. no root no flashing. From about a week ago my phone had a weird problem of automatically rebooting, also getting popups like google play services has stopped. Same messages came yesterday so i switched off my phone and when i tried to turn it on, it just wont turn on. It is not charging too and i'm sure it is not taking any power to charge or at least give a sign of life. Then i tried connecting it to computer, and in Devices and printer section computer shows unspecified device. It shows it for few seconds then wont and after few seconds it shows it again, and this process keeps repeating.
So if any one knows what can i do to solve this problem, please help!
Any help would be appreciated!
I've had the phone for over 6 months, it'd belonged to my sister before and everything was fine. I got a new phone recently and stopped using J. Just turned it off and put aside. I turned it back on today, it was working fine, until I wanted to do a wipe, nothing happened afterwards. I've had 360 security installed, thought it may be causing problems, so I uninstalled it. Then the phone was supposed to reset and so it did, but it didn't start again. Until this moment it hasn't shown even one sign of life, no random vibrations, no diodes flashing. I read about taking out the battery, powering it for hours, turning on with power+vol, power-vol, whatever. Nothing worked. When I connect it to the PC, it recognizes that something is being connected, tries to install a driver but immediately I get a message that it's failed. Any idea how I may solve this?
pucykoks said:
I've had the phone for over 6 months, it'd belonged to my sister before and everything was fine. I got a new phone recently and stopped using J. Just turned it off and put aside. I turned it back on today, it was working fine, until I wanted to do a wipe, nothing happened afterwards. I've had 360 security installed, thought it may be causing problems, so I uninstalled it. Then the phone was supposed to reset and so it did, but it didn't start again. Until this moment it hasn't shown even one sign of life, no random vibrations, no diodes flashing. I read about taking out the battery, powering it for hours, turning on with power+vol, power-vol, whatever. Nothing worked. When I connect it to the PC, it recognizes that something is being connected, tries to install a driver but immediately I get a message that it's failed. Any idea how I may solve this?
Click to expand...
Click to collapse
have you try fastboot/flashmode...
what driver shown on your device manager?
pucykoks said:
I've had the phone for over 6 months, it'd belonged to my sister before and everything was fine. I got a new phone recently and stopped using J. Just turned it off and put aside. I turned it back on today, it was working fine, until I wanted to do a wipe, nothing happened afterwards. I've had 360 security installed, thought it may be causing problems, so I uninstalled it. Then the phone was supposed to reset and so it did, but it didn't start again. Until this moment it hasn't shown even one sign of life, no random vibrations, no diodes flashing. I read about taking out the battery, powering it for hours, turning on with power+vol, power-vol, whatever. Nothing worked. When I connect it to the PC, it recognizes that something is being connected, tries to install a driver but immediately I get a message that it's failed. Any idea how I may solve this?
Click to expand...
Click to collapse
if so, u may contact ur product manufacturer or where did u buy ur xperia j.,.