I was wondering if anyone has had any success installing TWRP on the Gome U9?
The bootloader is unlocked and everything appears to be ok when I run the code.
Code:
fastboot flash recovery recovery.img
target reported max download size of 134217728 bytes
sending 'recovery' (23300 KB)...
OKAY [ 7.223s]
writing 'recovery'...
OKAY [ 0.326s]
finished. total time: 7.555s
c:\adb>fastboot boot recovery.img
downloading 'boot.img'...
OKAY [ 7.207s]
booting...
OKAY [ 0.083s]
finished. total time: 7.298s
But when the phone boots, it just boots normally. If I power off the phone and boot into the options and select 'Recovery', it just shows the standard options. It never boots into TWRP.
first you need to unlock the bootloader, and then install twrp
arsen sx said:
first you need to unlock the bootloader, and then install twrp
Click to expand...
Click to collapse
The bootloader was unlocked. I figured out what was happening and now it's working. If you run 'fastboot reboot' after installing TWRP is falls back to the default recovery. The key is to boot into recovery again after installing TWRP via the Volume Up/Power buttons.
Any link to gome u9 twrp with scatter text
Bakit po nasira GOMEU9 ko
Mod translation: Why is my GOMEU9 broken?
Related
So H2OS boots up just fine. Fastboot mode works. When I boot into recovery mode the oneplus logo shows up, but it is as nothing happens afterwards. I left the device there for more than an hour and still nothing. Flashing from the OS twrp 2.8.7.0 or 3.0.0-2 has no change on this. Flashing from fastboot the same. When I try to boot from fastboot,I get the following error:
[email protected] ~/Downloads $ fastboot boot twrp-3.0.0-2-oneplus2.img
downloading 'boot.img'...
OKAY [ 0.807s]
booting...
FAILED (remote: dtb not found)
finished. total time: 0.873s
[email protected] ~/Downloads $ fastboot flash recovery recovery.img
target reported max download size of 536870912 bytes
sending 'recovery' (31700 KB)...
OKAY [ 0.815s]
writing 'recovery'...
OKAY [ 0.534s]
finished. total time: 1.349s
Any ideas?
I wiped everything in trwp when I was going to install Lineage, I did the misstake to restart the recovery and now Im stuck in the bootlaoder.
I need to install the stoc firmware via fastboot/bootlaoder but can't find any img file, only zip file of the Stock firmware.
Is is possible to install a zip file via fastboot?
Fastboot recognize the phone when typing the commando fastboot devices, so I see the serial nr.
If I try to install twrp img both on boot and flash recovery commando I get this:
PS C:\Android> fastboot boot twrp-3.2.1-0-enchilada.img
downloading 'boot.img'...
OKAY [ 0.577s]
booting...
FAILED (remote: Failed to load/authenticate boot image: Load Error)
finished. total time: 0.598s
PS C:\Android> fastboot flash recovery twrp-3.2.1-0-enchilada.img
target reported max download size of 536870912 bytes
sending 'recovery' (26748 KB)...
OKAY [ 0.574s]
writing 'recovery'...
FAILED (remote: (recovery_b) No such partition)
finished. total time: 0.579s
I have tried the MsmDownloadTool V4.0, but the deviced manager in windows doesn't find the Qualcom....
@Peterrrrr said:
I wiped everything in trwp when I was going to install Lineage, I did the misstake to restart the recovery and now Im stuck in the bootlaoder.
I need to install the stoc firmware via fastboot/bootlaoder but can't find any img file, only zip file of the Stock firmware.
Is is possible to install a zip file via fastboot?
Fastboot recognize the phone when typing the commando fastboot devices, so I see the serial nr.
If I try to install twrp img both on boot and flash recovery commando I get this:
PS C:\Android> fastboot boot twrp-3.2.1-0-enchilada.img
downloading 'boot.img'...
OKAY [ 0.577s]
booting...
FAILED (remote: Failed to load/authenticate boot image: Load Error)
finished. total time: 0.598s
PS C:\Android> fastboot flash recovery twrp-3.2.1-0-enchilada.img
target reported max download size of 536870912 bytes
sending 'recovery' (26748 KB)...
OKAY [ 0.574s]
writing 'recovery'...
FAILED (remote: (recovery_b) No such partition)
finished. total time: 0.579s
I have tried the MsmDownloadTool V4.0, but the deviced manager in windows doesn't find the Qualcom....
Click to expand...
Click to collapse
I have never tried msmtool, but it sounds like a driver issue. Maybe take a closer look at their instructions
You can try these fastboot flashable stock roms.
You have few options to solve your issue. Now you are in slot B. You can change switch partition to A with fastboot. Try use: fastboot --set-active=a. It will switch to partition A and then try to boot/flash recovery. Also you have try to use fastboot roms with flashall.bat. There are few availaible in forum.
If you would like to use MSM you have to connect phone in proper mode to PC. Power off and hold Vol+ then connect. Also try to install latest Qualcomm drivers.
Msm tool
Download and use msm tool
hey xda masters
can you help me? my problem now is the first time using the android A / B partition, my wish is to only install twrp on my mobile, root the android and unlock the bootloader I have done, the android is in the unlock bootloader state all ways on google like
(fastboot boot twrp.img)
I have done but the results are not there
"downloading 'boot.img'
... OKAY [0.462s]
boot ...
FAILED (remote: unknown command)
finished.
total time: 0.482s "
I also enter the command
(fastboot flash recovery twrp.img)
and the results are like this
"target reported max download
size of 536870912 bytes
sending 'recovery' (20900 KB) ...
OKAY [0.471s]
writing 'recovery' ...
OKAY [0.198s] finished.
total time: 0.670s "
but when android restarts to recovery absolutely no twrp installed on android. can anyone help me to install twrp on my android without any problems, maybe the masters here can solve this problem thank you
Hi guys!
I don't seem to be able to flash TWRP 3.3.1 onto my pie phone. From Linux, I get the following:
Code:
:$ fastboot flash recovery ./recovery-TWRP-3.3.1-0602-REDMI6-CN-wzsx150.img
target reported max download size of 134217728 bytes
sending 'recovery' (65536 KB)...
OKAY [ 3.554s]
writing 'recovery'...
OKAY [ 0.942s]
finished. total time: 4.496s
The phone doesn't even blink. If I manually reboot it, nothing has happened. If I get to the recovery menu, I get the MI-Recovery 3.0.
What am I doing wrong? How should I be doing it?
Thanks!
To reboot to recovery : vol+ and power twice
I am stuck with the same problem. Is there any way to resize recovery partition? Or could someone send me stock recovery? Thx
EDIT: I managed to fix. Russian TWRP from 4PDA works.
timonoj said:
Hi guys!
I don't seem to be able to flash TWRP 3.3.1 onto my pie phone. From Linux, I get the following:
Code:
:$ fastboot flash recovery ./recovery-TWRP-3.3.1-0602-REDMI6-CN-wzsx150.img
target reported max download size of 134217728 bytes
sending 'recovery' (65536 KB)...
OKAY [ 3.554s]
writing 'recovery'...
OKAY [ 0.942s]
finished. total time: 4.496s
The phone doesn't even blink. If I manually reboot it, nothing has happened. If I get to the recovery menu, I get the MI-Recovery 3.0.
What am I doing wrong? How should I be doing it?
Thanks!
Click to expand...
Click to collapse
Kindly ensure that you are using the correct device image. If you flash the wrong image/other device image then it will always boot in mi recovery 3.0.
Here is the link : Xiaomi Redmi 6 (twrp.me)
trying to install twrp,the bootloader is already unlocked.
this is what happens:
fastboot flash recovery recovery.img
target reported max download size of 805263360 bytes
sending 'recovery' (34200 KB)...
OKAY [ 0.728s]
writing 'recovery'...
(bootloader) Invalid partition name recovery
FAILED (remote failure)
finished. total time: 0.841s
fastboot boot recovery twrp.img also give a error
what is the solution ?
neozbr said:
trying to install twrp,the bootloader is already unlocked.
this is what happens:
fastboot flash recovery recovery.img
target reported max download size of 805263360 bytes
sending 'recovery' (34200 KB)...
OKAY [ 0.728s]
writing 'recovery'...
(bootloader) Invalid partition name recovery
FAILED (remote failure)
finished. total time: 0.841s
fastboot boot recovery twrp.img also give a error
what is the solution ?
Click to expand...
Click to collapse
OK:
1. First you need to root the device. Follow this guide. You will use adb to patch the boot.img file of your current firmware.
2. After you have rooted, you can install the unofficial TWRP for Android 10 Moto G8 Plus from here. The zip file will install through magisk. Works fine; I tested it last night.