good night, i instaled Error Executing updater binary in zip on OnePlus One, this video , but i have xperia z3 dual stock rom android 5 and not power on now, not blink led, not charge, not reset to try sony pc companion or fashtools.
https://www.youtube.com/watch?v=1J7nqguhTZ8
You tried to put it in flashmode? Press volume down while you plug the usb cable into your computer. Or fastboot mode, with the volume up pressed?
All that with Flastool opened.
i try , led not utrn on, not change, not blink , pc not recognize ,i try put in recover to try fix install zip
hello I'm desperate behind a solution, it will ...
I install the rom stock lollipop by ftf the xperia m2 aqua and after the cell procedure does not start nor identifies more flashmode, when I connect the pc shows that he was connected to mtp mode and the device does not care any more solution please, do not I have more to send him to the assistance, cry:crying:
note: bootloader locked
Power off the phone by: press with something sharp hole by simcard, or hold volume up (+) and power button together, you'll feel vibration, hold it little more until another vibration, now your phone is off.
Now prepare ftf in Flashtool (don't use latest one, use 9.18.6) when it prompt to connect the phone, press volume down and connect it. Wait till it finishes.
You can also use PC Companion repair option, it have SUS integrated in it.
Good Luck.
Sent from my D2303
Pressing ctrl + down and connect to pc makes led turn green,
Then suddenly turn red and goes to charge mode and turn phone on.
pls help me guys.
My device successfully goes into fastboot but not flashmode.
Pls help with it.
Used tools
1. Flash tool
2. Sony pc companion
I can't flash firmware, Pls help me
hello guys, i have a problem with my lenovo A850i.
after flashing, my phone cannot on, i check my battery and its still in good condition, i try to flashing one again using SP flash tool, and now my phone were not detect by pc, the led will light up when i remove the battery when it connect to usb, but when i put back the battery,the light will close. i connect to usb and try mane button combination , but still not work...
i have been stuck with this about 3 day, i hope someone can help me..
Sorry for my broken englosh...
What did you flash exactly? You sure you flashed something that's specifically made for your phone ?
Also what combination have you tried yet.
Download another stock rom for your phone load scatter text ,click download and connect your phone to PC via USB while holding the vol+button only
northwindtrades said:
What did you flash exactly? You sure you flashed something that's specifically made for your phone ?
Also what combination have you tried yet.
Download another stock rom for your phone load scatter text ,click download and connect your phone to PC via USB while holding the vol+button only
Click to expand...
Click to collapse
Yes sir, im very sure that i flash lenovo A850i firmware, do u have any other combination for me to try to make my phone connected to pc, i have try holding vol+ button while connect to pc via usb, but it not work, all i have now just a red led light that turn on without battery
jimbo94 said:
Yes sir, im very sure that i flash lenovo A850i firmware, do u have any other combination for me to try to make my phone connected to pc, i have try holding vol+ button while connect to pc via usb, but it not work, all i have now just a red led light that turn on without battery
Click to expand...
Click to collapse
Meta mode( usually vol+ button) is the most successful way of of recovering from a hardbrick for lenovo but after looking up your device you guys coonect meta mode dffrntly.now this is the most successful way of unbricking your phone
pick the official ROM for A850i came with A850_203 multilanguage firmware.
You'll need MTK 65XX metamode driver – USB VCOM Preloader driver, if you previously installed then there is no need.
SP Flash Tool to download the firmware to the phone.
(Make sure you have a working version as some so tool don't work as they're supposed to into ,I'm using version 5.1)
Run SP-Flash Tool, map the scatter loading MTK6582 for your firmware, normally inside the firmware folder. It will mapped the necessary file and partition for your device, After that click Download and leave it searching for device, it will start flash when found the device,
so next we need to activate back the dead phone of Meta mode USB Vcom MTK65xx , firstly remove the battery, simply press and hold VOLUME UP & DOWN + Power Button simultaneously while reinsert USB that connect the phone to PC.
The previous SP Flash that searching for device will start the download process just after the META mode activated, if you failed then try repeat the step :fingers-crossed:
And hit the thumps up button if this post has been helpfull good luck:good:
northwindtrades said:
Meta mode( usually vol+ button) is the most successful way of of recovering from a hardbrick for lenovo but after looking up your device you guys coonect meta mode dffrntly.now this is the most successful way of unbricking your phone
pick the official ROM for A850i came with A850_203 multilanguage firmware.
You'll need MTK 65XX metamode driver – USB VCOM Preloader driver, if you previously installed then there is no need.
SP Flash Tool to download the firmware to the phone.
(Make sure you have a working version as some so tool don't work as they're supposed to into ,I'm using version 5.1)
Run SP-Flash Tool, map the scatter loading MTK6582 for your firmware, normally inside the firmware folder. It will mapped the necessary file and partition for your device, After that click Download and leave it searching for device, it will start flash when found the device,
so next we need to activate back the dead phone of Meta mode USB Vcom MTK65xx , firstly remove the battery, simply press and hold VOLUME UP & DOWN + Power Button simultaneously while reinsert USB that connect the phone to PC.
The previous SP Flash that searching for device will start the download process just after the META mode activated, if you failed then try repeat the step :fingers-crossed:
And hit the thumps up button if this post has been helpfull good luck:good:
Click to expand...
Click to collapse
Okay, i will try it first
Hi Guys!
May I request a guide to turn on/off sony xzp using ADB commands. My volume rockers are broken, and Im afraid to flash custom rom in case I got softbrick.
Thanks,
MrGrey
Solved.
Here's how for future reference if someone encounters a similar issue.
1. Disconnect battery and reconnect it
2. Download and install Xperia Companion Tool from Sony (tested on Mac, but the Windows version should work as well)
3. Choose Repair Software/Xperia on the Companion tool
4. Connect phone to computer using a USB cable
5. Disconnect phone when the Xperia splashscreen appears.
Done.