hello guys,
i have 2 Problems with my galaxy R.
My mobilephone doesn't load the battery when i plug in the charger. If i shut down the phone and connect the charger, the phone goes on and the empty battery symbol is drawn an the screen and the refresh logo of the battery is shown. But after 1-2 second's the screen is black and the phone turn off, this repeats the whole time.
When i turn on the phone, it starts without problems, when i plug in the charger it does nothing. I tryed to plug in the charger during the night, and the pho73ne loadet from 59% to 73%.
I have the Galaxy R with 3 Branding (Firmware, which was installed, when i get my galaxy R), but i have rooted the phone and have clockworkMod 4.xxx.
Now, i wanted to flash the firmware again (for warranty, to delete root and clockworkmod), but i cannot connect my phone to the pc. When i plug in the usc cable, my notebook don't recognize my phone and the phone does nothing.
My question now is, how can i remove root and clockworkmod, so that i can give the phone to the shop for warranty?
I hope you have ideas for me, and sorry for my bad english, i'm from Austria
now i made a video...
see here:
http://www.youtube.com/watch?v=PaOwBfx-J_g
try connecting ur phone in apx mode and check that is it a hardware issur or software, to connect in apx mode reinstall ur battery and press VOL DOWN + HOME + POWER keys and plug in usb cable while these keys are pressed, ur pc should detect a hardware named APX
rostiges_Handy said:
My question now is, how can i remove root and clockworkmod, so that i can give the phone to the shop for warranty?
Click to expand...
Click to collapse
(1) To unroot flash unroot.zip via CWM
(2) To remove CWM recovery, flash stock_recovery.zip via CWM
xlm13x said:
try connecting ur phone in apx mode and check that is it a hardware issur or software, to connect in apx mode reinstall ur battery and press VOL DOWN + HOME + POWER keys and plug in usb cable while these keys are pressed, ur pc should detect a hardware named APX
Click to expand...
Click to collapse
Hey, thank you for your help.
I tried this, but the phone only shows "Warning. A Custom OS can cause critical problems in phone and installed applications. If you want............. Volume up: Continue, Volume down: Cancel (restart phone)
The PC's doesn't do anything while connected via usb cable with the phone
(1) To unroot flash unroot.zip via CWM
(2) To remove CWM recovery, flash stock_recovery.zip via CWM
Click to expand...
Click to collapse
Thank you too :good: your are a great help for me , but are this files the right ones for the XWLA4 Firmware (2.3.6, 3 Austria) ?
these files will work with all the ROMs
Sent from my GT-I9103 using XDA
Hey buddy! This is what exactly happened with me! This is a physical damage. So there's nothing you can do by flashing other ROMs or stock ROMs or so....
Check out my thread here:-
http://forum.xda-developers.com/showthread.php?t=1663812
I've explained everything about my case and how I was able to revert back to my country's stock ROM, unroot the phone and revert back to stock recovery.
Then I gave my phone for repair to SSC and they told me that it's a physical damage. They changed the whole charging port of my phone. Took 3-4 days though. Depends on availability of that part.
And since my phone was in warranty and SSC guys are dumb, I got it done for FREE!!
---------- Post added at 09:46 AM ---------- Previous post was at 09:37 AM ----------
And please make the video "private" or "unlisted" on YouTube.
We seriously don't want to give any bad impressions to those who are thinking of buying SGR.
pankaj88 said:
(1) To unroot flash unroot.zip via CWM
(2) To remove CWM recovery, flash stock_recovery.zip via CWM
Click to expand...
Click to collapse
Hey bro, shall we add these files to a stickied thread so that all those in trouble can easily access it? I'm sure it'll be really helpful for many ppl.. Great work!
Proud to own a Galaxy R
vbz89 said:
Hey bro, shall we add these files to a stickied thread so that all those in trouble can easily access it? I'm sure it'll be really helpful for many ppl.. Great work!
Proud to own a Galaxy R
Click to expand...
Click to collapse
ASK the Moderator
we will tell cooleagle to add these two file to put it in Guide, so that every one can access this when ever required ...
hi guys,
since yesterday I get my phone back. It was repaired within the warranty.
Thank you again ankaj88 you helped me a lot
Now my phone works as it should
my galaxy r problem
now I wear neo3.0 firmware. so i want to flash rom to gb 2.3.6 update ics reason want but can not. usb not detect directly. ing any charge. want to follow the phone flash wear CWE install aborde
aliutak said:
now I wear neo3.0 firmware. so i want to flash rom to gb 2.3.6 update ics reason want but can not. usb not detect directly. ing any charge. want to follow the phone flash wear CWE install aborde
Click to expand...
Click to collapse
Hi buddy, I appreciate that you haven't started a new thread. Could you tell me which language you know ? I am asking because then I could understand your issue clearly.
If you would have searched a bit you would have surely got the answer in the FAQ's post (in the newbie guide thread), check this out:
Q. My device is not being detected on being connected to my PC but I can charge it via the wall / normal charger ! What to do?
First of all check if you have the latest Samsung Kies software installed as it also installs the latest Samsung USB drivers along with it which are required to connect your device to the PC. If they are installed & still your PC doesn't detect the device then you probably have corrupted drivers. To resolve this follow these steps: Uninstall Samsung Kies / Samsung USB drivers currently installed => Restart your PC => Reinstall Samsung Kies / Samsung USB drivers.
Q. I can't charge my device & my device is not being detected after connecting to my PC & Odin is not detecting my device ! What to do?
(The solution is valid only if you are experiencing all of the above conditions simultaneously)
Checkout this thread which could help you: => [Partial Fix] Galaxy R not getting detected on PC nor charging via a charger.
Hope this helps.
Hey, guys!
So here's my problem... After a few days with custom rom [5.0 Lollipop AOSP RC2 (V5)], I decided to go change back to stock firmware 6.2.b.1.96_Generic_1266_3189. Flashed it with flashtool. After it was done flashing(usb cable still connected), my phone was still in flash mode. So I decided to flash it again. But when I was about to flash it, the green led was gone and my phone turned on, so I disconnected the usb cable. I decided to factory reset my phone so I could get rid of the leftover files. After rebooting, I had to charge it because my phone was about 5%. I connected the charger but there was no orange led light. It wasn't charging. Connected it to pc but it wasn't detected(with usb debugging on). With only 1% percent left, I was desperate to find what the problem was...
My phone was completely undetectable. Sony PC Companion and Flashtool.
Tried a lot different usb cables but it was still undetectable. Tried with both usb debugging on & off.
Can't flash anything 'cause obviously I can't connect it via fastboot and flashmode if it was undetectable.
Tried dozen of hard reset but nothing. Connected the charger and waited for 3 hours or so but still nothing happened. Didn't charge it overnight and charged it afterwards but still no response. Can't remove battery because it's built-in. The only charging that worked was through docking. Though I'm quite not sure where it started to be undetectable. Rebooting after flashing or rebooting after the factory reset...
I've read through a dozen of forums and threads but there wasn't anything similar with mine. I can't find any solution.
Any help would really be APPRECIATED. :good::good::good:
And, THANK YOU in advance!
Hi
Thanks for writing to us at XDA Assist. I can see you've posted the same question here:
[HELP THREAD][XPERIA S, ACRO S & ION]Ask any question. NOOB friendly
Please refer to the XDA Forum Rules for information regarding the creation of duplicate posts/threads. That other thread is the best place for your question so I'll let you continue there and close this thread.
Good luck!
Thread closed, thanks.
I need help debricking my S5 900I
The device wont respond, unless connected to my PC in which it seems to constantly connect and disconnect with it coming up as QHSUSB_BULK in device manager.
It will not boot at all, holding down power button has a small vibrate but only when plugged into my pc, then goes into what i call a silent re-booting, where only the pc USB connect and USB disconnect sounds happened every 10 or so seconds,
It will not boot into download mode nor recovery mode. I have heard that i can get it to boot to download mode with a microsd and a debrick image, but i cannot find a debrick image for the sm-900I.
If someone could give me a list of instructions and a link to a debrick image, i would be extremely grateful
Thanks, matt
matthew4544 said:
I need help debricking my S5 900I. The device wont respond, unless connected to my PC in which it seems to constantly connect and disconnect with it coming up as QHSUSB_BULK in device manager...
Click to expand...
Click to collapse
I don't have this variant but, one or both of the following, device specific, threads should be helpful for what you are looking for and don't be afraid to ask for some member guidance within one of them too.
https://forum.xda-developers.com/showthread.php?t=3688999
https://forum.xda-developers.com/showthread.php?t=3694835
If all else fails, and you don't receive any responses from the above threads, your next best bet is to post this question within the following Q&A thread that's specific to the klte variants.
https://forum.xda-developers.com/showthread.php?t=2700073
Good Luck!
~~~~~~~~~~~~~~~
I DO NOT provide support via PM unless asked/requested by myself. PLEASE keep it in the threads where everyone can share.
< mod edit: thread closed since it's a duplicate. Please go here: https://forum.xda-developers.com/general/help/usb-recharge-t3805968 >
Hello, I apologize if I was wrong to write... My English is not the best .
My smartphone is Huawei G620s, since some time besides recharging the battery, it does not allow me to exchange files with the computer (connecting it by cable) .
Sometimes when I connect it to an electrical outlet, it does not charge me unless I restart it.
I've an Lineage ROM and TWRP Recovery.
Please, could you help me?
Hi
Can anybody assist me with Jtagging my rog 5?
I had issues flashing software after a soft brick, now EDL doesn't even show, it's completely hard bricked. I see the software connector present where is it wasn't present in my previous Rog phone 2. However I can't find any resources online to assist me, hence I'm reaching out here. What I'm looking for is a connector, that I can connect on to the software port and do a factory software push
Any help would be greatly appreciated.
Any help on this matter, please?
Aussieboi9 said:
Any help on this matter, please?
Click to expand...
Click to collapse
Buddy i really want to help you with this are you able deassemble the device
Also try to follow these steps hold volume up connect usb and see if edl comes in the computer if not then hold volume down and try if it still didn't work try both up and down volume and connect usb cable
rais.asif786 said:
Buddy i really want to help you with this are you able deassemble the device
Also try to follow these steps hold volume up connect usb and see if edl comes in the computer if not then hold volume down and try if it still didn't work try both up and down volume and connect usb cable
Click to expand...
Click to collapse
I'm glad someone wants to help
Unfortunately I've tried everything physical, I have opened it up and I have found the software point on the main board of the internal. My only problem is, I can't find the right connector/cable so I can run a jtag and Flash the stock firmware directly to the software Point.
if suppose you don't see the edl port in manage, do make cap edl 9008, and use them for 25 seconds, you will see the device connected manually edl.