I'm running android 6.0 on the blu studio g, the latest version of the studio g, yet I just found out that android 6 uses a systemless root system which hinders my ability to root my phone. Protocol says that I have to flash Super SU, but my phone has a bug that won't let me unlock the bootloader. I've used sp flash tool to flash to my phone, but when I use it to flash a custom recovery it skips recovery when I use the button combo, then reboots to normal android. When I use adb reboot recovery command, I end up at the stock recovery. No one has submitted an Sp Flash Tool rom so I can go back to an earlier android version, and no recovery I've tried will load. I can't root to install custom recovery, but I can't install custom recovery to root my device. Does anyone have any ideas? I'm at my wits end...
Hi !
I couldn`t find anything for your exact device variant here on xda
You may ask here https://forum.xda-developers.com/android/help
I would recommend you that never start anything on a device without being sure that it is available a way to restore it
Not all devices has support on xda , there are thousands and most of rooting / moding tools that there are outside xda are risky without a proper development support
Sometimes you may end up buy returning your device to the service center where only the technicians have the proper tools to recover it
Good luck
Related
Installing Clockworkmod Recovery on your Alcatel Onetouch Flash 6042D means that you will be able to flash new custom ROMs on it. Without custom recovery you cannot flash new ROMs. Also, it should be installed on rooted devices. Clockworkmod Recovery can also be used to backup your entire ROM.
WARNING: Installing a recovery may brick your phone...Don't Blame Me.. Do at your Own Risk...
Note:- Alcatel OneTouch Flash Recovery Uses a secured boot.img,so a custom recovery will cause boot loop..Please Download and Flash The unsecured boot.img from below link. And flash it with recovery..
You need:
1. A Windows PC
2. CWM recovery (Download)
3. Unsecured Boot.img (Download)
4. SP Flash tools (Download)
5. Driver (Download)
6. Scatter file (Download)
7.Alcatel Onetouch Flash 6042D
Follow these steps to flash custom recovery using sp flash tools:
Step 1: Extract/unzip all downloaded files.
Step 2: Open SP flash tool and load scatter file.
Step 3: Unselect all blocks and select only RECOVERY and BOOT.
Step 4: Click the location column of RECOVERY and BOOT and select downloaded
recovery and boot.
Step 5: Press and Volume Down + Power to Enter in CWM Recovery Mode.
If you face any problem contact me at facebook.....:fingers-crossed::fingers-crossed::fingers-crossed::fingers-crossed::fingers-crossed::fingers-crossed:
THANK YOU VERY MUCH...
I have tried all the recovery on the net but they all get boot loop..
And they can't format data and factory reset...
Now it a humble request to port rom for this devices....
Biman94 said:
THANK YOU VERY MUCH...
I have tried all the recovery on the net but they all get boot loop..
And they can't format data and factory reset...
Now it a humble request to port rom for this devices....
Click to expand...
Click to collapse
Thanks for your review...
i am currently working on AICP ROM 5.1.1..
I will upload it within 2 days...
Be Tuned....:highfive: :highfive: :highfive:
Okkk
I am waiting for it...
connecting in sp flash & mtk droid tools.
hai there
I have a peculiar problem here. I am not a programmer or some thing like that. But an avid fan of android.
I am not able to get my rooted 6042d detected in SP FT & MTK droid tools to take a back up. My system is Win.XP [SP3]. I even formatted the system twice to remove left overs. Even, I am clue less how to get it done. I installed the drivers provided by you. I think my ignorance of windows is the main hurdle here. Can you please guide me - how to? Sorry for the bother.
I wish to flash the secure CWM made by you and the LP style rom followed by it.
1. spft says 'the application failed to start because the application configuration is incorrect....reinstall..'
2.mtk droid tools says 'the device is not revealed.. connect or reconnect...' - on the right side -' in system already available android debug bridge 1.0.26'
thanks
PS: I know how to use both the tools, I did it with my previous device, also of MTK-zte.
Solution of your problem....
pinakini said:
hai there
I have a peculiar problem here. I am not a programmer or some thing like that. But an avid fan of android.
I am not able to get my rooted 6042d detected in SP FT & MTK droid tools to take a back up. My system is Win.XP [SP3]. I even formatted the system twice to remove left overs. Even, I am clue less how to get it done. I installed the drivers provided by you. I think my ignorance of windows is the main hurdle here. Can you please guide me - how to? Sorry for the bother.
I wish to flash the secure CWM made by you and the LP style rom followed by it.
1. spft says 'the application failed to start because the application configuration is incorrect....reinstall..'
2.mtk droid tools says 'the device is not revealed.. connect or reconnect...' - on the right side -' in system already available android debug bridge 1.0.26'
thanks
PS: I know how to use both the tools, I did it with my previous device, also of MTK-zte.
Click to expand...
Click to collapse
I recomend u to go to this link to solve your Spft problem...
and i think u must download your stock rom instead of making backup...
after this problem solved try to flash unsecured boot.img first..
then u can try flashing My CWM recovery or Philz Recovery
(philz recovery can be found here...)
and got to this link
you can understand what is your problem connecting in mtk driod tool...
I think u must flash it.. because its the problem of your phone...
and if u face any problem contact me or for instant help just take the help of Google BABA!!!...
thanks for the swift reply.
SPFT problem solved as you suggested. But the problem with DT persists.
I do not have the stock rom of onetouch flash 6042d. [ my device is wrongly showing idol3!]
I want to have a SPFT back up in Droid Tools to be on safe side with imie etc. [being able to run Droid tools.]
I highly appreciate what ever the hints/advice I need in this regard, if extended.
When your LP themed rom for our device will be out?
pinakini said:
thanks for the swift reply.
SPFT problem solved as you suggested. But the problem with DT persists.
I do not have the stock rom of onetouch flash 6042d. [ my device is wrongly showing idol3!]
I want to have a SPFT back up in Droid Tools to be on safe side with imie etc. [being able to run Droid tools.]
I highly appreciate what ever the hints/advice I need in this regard, if extended.
When your LP themed rom for our device will be out?
Click to expand...
Click to collapse
Here Check This Website......
After that I hope U can Understand your problem.....
Then Uninstall any previous driver installed of your phone on your pc....
then install the driver mention above....
and after that if the problem remains try to download and install proper adb driver by this....
I've been searching around XDA and other forums for a while and have been unable to find a solution
TLDR; I am unable to flash a custom recovery with MTK droid tools, SP flash tool, Flashify, Fastboot, Rashr, CWM magic, TWRP magic, CWM app, TWRP app and now i no longer have a recovery on my phone, not even the stock
Phone: Huawei Y360-U23
Android: Kitkat 4.4.2
Kernel: 3.4.67
So here goes, I wanted to flash cwm recovery as i have with my previous android phones, however it is unsupported on the CWM list, I also tried TWRP, my device is also unsupported.
-I did some reading around and found some guides on how to use MTK droid tools to back up and then SP flash tool to change my recovery
- I encountered errors but was able to fix most EXCEPT, Zero error, no space left on device , tried the recommended busybox fix and ensured all drivers were properly installed but did not help
- Fastboot gives me the error "remote partition 'recovery' not support flash"
- SP flash tool wouldnt do anything after i pressed the download button
- TWRP magic tool flashed my recovery mod but could not back up, but failed
- CWM magic tool flashed my recovery mod but when a backup was attempted this error was received " could not open /tmp recovery.log"
- Flashify and Rashr both failed to flash recovery
I tried to flash my recovery with the TWRP magic tool a final time but now my phone won't boot into recovery at all.
Please offer any help you can, it would be greatly appreciated
SirFitz said:
I've been searching around XDA and other forums for a while and have been unable to find a solution
TLDR; I am unable to flash a custom recovery with MTK droid tools, SP flash tool, Flashify, Fastboot, Rashr, CWM magic, TWRP magic, CWM app, TWRP app and now i no longer have a recovery on my phone, not even the stock
Phone: Huawei Y360-U23
Android: Kitkat 4.4.2
Kernel: 3.4.67
So here goes, I wanted to flash cwm recovery as i have with my previous android phones, however it is unsupported on the CWM list, I also tried TWRP, my device is also unsupported.
-I did some reading around and found some guides on how to use MTK droid tools to back up and then SP flash tool to change my recovery
- I encountered errors but was able to fix most EXCEPT, Zero error, no space left on device , tried the recommended busybox fix and ensured all drivers were properly installed but did not help
- Fastboot gives me the error "remote partition 'recovery' not support flash"
- SP flash tool wouldnt do anything after i pressed the download button
- TWRP magic tool flashed my recovery mod but could not back up, but failed
- CWM magic tool flashed my recovery mod but when a backup was attempted this error was received " could not open /tmp recovery.log"
- Flashify and Rashr both failed to flash recovery
I tried to flash my recovery with the TWRP magic tool a final time but now my phone won't boot into recovery at all.
Please offer any help you can, it would be greatly appreciated
Click to expand...
Click to collapse
Hello,
You may try posting your query here Ask any Q Noobfriendly with all relevant details, the experts there maybe able to assist you.
-Vatsal
Vatsal said:
Hello,
You may try posting your query here Ask any Q Noobfriendly with all relevant details, the experts there maybe able to assist you.
-Vatsal
Click to expand...
Click to collapse
Thank you
Hello friends,
I often used to flash several ROM since I had my OnePlus One phone, and now I'm currently facing one "little" problem with my OP3.
I have recently flashed the new official LineageOs custom ROM (which normally support MultiROM), since the recovery. After the flash, the output mentionned a successful flash, but after reboot, my phone were unable to boot properly and the recovery was not here anymore...(black screen).
The only option available until now is the fastboot mode. I tried many methods, like flashing several recoveries, unbricking my phone with the official guide made by Naman Bhalla...but nothing to do in order to get a proper and working system with a fully functional recovery...
Could someone help me?
My friendships,
S0bek
Hi !
Start by reverting to stock oos from the dedicated forum
When you arrive to fastboot flash recovery.img , don`t boot into android , just power off the device and boot into recovery using the buttons combination
Good luck !
Good Morning everyone,
I followe all tutorial from youtube to XDA, also this:
https://forum.xda-developers.com/android/general/umidigi-g-root-gpu-cpu-booster-gaming-t3749862
But it not working,
The problem is that with last ROM 1.8 the falshing of TWRP is impossible, adb and fastboot will write, but not defintively.
I tryed to flash TWRP, unloking the oem, and boot recovery.img via fastboot, TWRP will run, but not write for real.
The point is that all tutorial start from having a custom recovery, but this device not allow to install nobody.
Some one saying that using the 1.6 firmware rom, is the only solution to have root, but this rom flashed from SP Flash tool, briked the phone.
My request is if someone for real rooted and installed TWRP in this device, if please can share a real working tutorial, based from adevice where is impossible flash a custom Recovery without root.
So need start form unrooted device.
Also tuturial mentioned in top, start from install magisk, with a custom recovey.
If someone having one line to bypass chinese MTK recovery, please share.
The device is a MTK6737, the roms available are here:
http://community.umidigi.com/thread-11437-1-1.html (this is the declared available for root, but form me brik the phone by sp flash tool)
I lost 3 days to try all, nothing worked at the end.
Hello, I have an X27 PLUS chinese phone with MT6572 processor and kitkat 442. I rooted him with Kingroot. Then I wanted to flash twrp. Аnd here I made a mistake. Since I didn't have a sd card, I decided to flash the TWRP directly on the phone with "Easy Magic TWRP" 2.8.1.0.
After the flash, it showed me that the installation was completed successfully. But the phone is already in boot loop. The only thing that works is Fast Boot. But I can't flash the stock image recovery file, it tells me that the flash sector can't be flashed (or doesn't support flash). I have a backup made with the help of Droid Tool and SP Flash Tool.The problem is that the flash tool cannot connect to the phone.
I have all the drivers installed, and before flashing the TWRP, the phone was recognized by the software.
Is there any way to solve this problem?
Ps:I am writing in the forum for the first time and I apologize if I am not in the right topic.
cybrax said:
Hello, I have an X27 PLUS chinese phone with MT6572 processor and kitkat 442. I rooted him with Kingroot. Then I wanted to flash twrp. Аnd here I made a mistake. Since I didn't have a sd card, I decided to flash the TWRP directly on the phone with "Easy Magic TWRP" 2.8.1.0.
After the flash, it showed me that the installation was completed successfully. But the phone is already in boot loop. The only thing that works is Fast Boot. But I can't flash the stock image recovery file, it tells me that the flash sector can't be flashed (or doesn't support flash). I have a backup made with the help of Droid Tool and SP Flash Tool.The problem is that the flash tool cannot connect to the phone.
I have all the drivers installed, and before flashing the TWRP, the phone was recognized by the software.
Is there any way to solve this problem?
Ps:I am writing in the forum for the first time and I apologize if I am not in the right topic.
Click to expand...
Click to collapse
Hey I got one of them x27 plus wish phone....mtk6572 4.4.2 kitkat .....for true info on device install "device info hw" green icon and activity launcher .....check out the info it gives compared to info from ph settings menu.....but my question did you find way to root of flash a generic android rom?
I used kingroot with laptop.