I had the dreaded broken USB issue. I ordered my stuff for wireless charging, but while I waited I cut the end off of a USB cord and connected the positive and negative to the positive and negative pins where the fast charge would go. Does anyone see an issue with this? Also used official Samsung box and cord
Look for an external battery charger then you buy a battery more and when the one battery is empty you can switch with the other full battery very nice no loading time. For my S4 i had one from Samsung OEM battery loading station where you put the battery in.
Shouldn't be a problem, on wireless charging you need negative and positive only from usb cable
You could always buy a battery charger for it, The advantage with this is if you have a second battery, you can charge that wiltse you're using the other in your phone.
Related
So I bought a cheap cable from eBay that converts microusb to the proprietary Galaxy connector on this device. Tried to charge the device but it entered a bootloop. Unplugged the cable and tried charging with the stock cable and left it overnight. Woke up and the device was completely dead.
Wouldn't boot at all.
Tore it open, unplugged the battery and plugged it back in. It booted! BUT the battery was critical and it shut off immediately. Tried charging again, no dice.
So I unplugged the battery and applied 4v to get some charge into it. Got the battery up to about 3.6V, booted again and it showed 3%. So in the time I had with the device turned on I tried both cables again but neither would charge the device. I used a multimeter to test the stock cable and it was all good, I even did a beep test between the 4 USB pins in the stock cable and the places they're wired up to inside the note and everything was fine so it's most likely not the cable.
Anyway the 3% is long gone now and I can't boot or charge. The device and battery are fine and definitely working, it just won't charge through USB no matter what. I've tried different power points, different adapters including stock and normal usb ports.
I've also cleaned both the plug and the jack with a toothbrush.
Could it be that the internal charging circuitry got fried when I tried the dodgy cable? If so, is there any way to fix/bypass this?
I'm at a complete loss so any help would be greatly appreciated.
Regards,
Nas.
I would not recommend to charge battery directly outside the device or even remove the battery at all.
First you gotta make sure your cables are capable of charge other galaxy devices if a friend has Tab 7 or Tab 10.1 or other note 10.1 or another try your cables to see if they really work.
Because it may just be your cable, remember batteries have their own circuits boards of sort and batteries are sometimes picky on how they are charge especially OEM batteries that are not suppose to ever be out of the device unless are change for a new one in a repair.
So first of all cable check it a must, again is not as simple as check if all the pins works as this is not a simple USB (Universal Serial Bus) port is a proprietary port and cable, check the port in the tablet too.
As well it may be just a defective battery or worst case even a board problem.
Unfortunately I have no other device to test it with. I might just buy another cable and see how I go.
I know about the circuits on the battery, but I always thought they were just there as a safety measure due to the potentially volatile nature of Li-Ion when it drops below a certain voltage. I'll probably take your advice and stay away from charging it externally, I only did it once to see if the tab died or it was just a dead battery. The voltage never dropped low enough to trigger the circuit to 'kill' it, evidenced by the fact that I could get it back up to 3% just applying a constant voltage.
I'm guessing you've hit it on the head with the last sentence, might be a board problem which would be quite sad. Silly reason for a great device to die.
Thanks a lot for the reply, I'll update this thread once I try an alternative cable for future reference.
Ok, So to update:
I've bought and tested 3 separate cables, all provide 4.99V inside the device, but none of this makes it to the battery so I'm fairly certain it's the charging IC that's dead.
I bought a new battery that was charged to 40% so I was able to flash the device to see if it was maybe the custom kernel messing something up. Flashed to stock via Odin, still not charging.
From what I've read, I need a cell balancing circuit (since the battery is 2-cell Li-Ion) and a charging IC. I've found a suitable IC for fairly cheap, but I'm not sure if the balancing circuit is necessary. The battery already has one of these inside, but I'm not sure if this is just for Voltage/Current protection or if it also balances.
MP24AG: http://eng.it-m.co.kr/cnt/prod/tep_5l/MP24AG.pdf
If anyone knows I'd be very grateful.
I have had my Verizon Galaxy S4 since February of this year. I've been using the stock Samsung AC charger that came with it. It's always charged the phone pretty fast if I wasn't using the phone. It would charge about 15% in 20 minutes. Now it's only charging about 3 or 4% in 20 or 30 minutes. Now I didn't do anything different to my phone. I've been on this same ROM for over a month and this is just now a problem in the last week. My wife has the exact phone and charger that I have and when I use her charger it charges just as rapidly as mine used to, so I know it's not the usb port on my phone itself. I haven't dropped or damaged my charger at all in any way either.
Does anyone have any ideas about why this is happening?
If it charges fast on you wife's charger you've pretty much answered your own question.
Try using her cable with your charger, if it still charges slow then get a new charger.
gadget! said:
If it charges fast on you wife's charger you've pretty much answered your own question.
Try using her cable with your charger, if it still charges slow then get a new charger.
Click to expand...
Click to collapse
Ok, I'll give that a shot. Thanks.
I had the same problem too ! Did a full battery reset and everything is going good now !
You have to charge it for 12 hours and drain your battery until your phone don't boot. Charge it and here you are !
Yeah these devices act funky every blue moon. My wifes didn't even recognize ANY oem charger for a week. Only detected others as USB devices causing slow charge rate. Removing dust, component cleaner, fresh install, all did no good. Eventually it just resolved the issue itself. All chargers work normally again.
change the usb cables
I also had the same problem before. I'd been using the original charger and usb cable and noticed that charging takes a lot of time than normal.
I found that it's on the usb cable. I accidentally found it when I used gsam battery monitor. It displays the current being received by your phone when charging. Using the original usb cable, it only gets around 600mah. I tried another usb cable (from a previous Samsung device) and now my phone gets 1,900mah (closed to the charger output of 2,000 mah).
Every since I changed the usb cable, my charging is fast now. Hope this helps.
I would try a new cable and Charger that is rated 2.1 amps or better if will be charged real quick
elchingon said:
I would try a new cable and Charger that is rated 2.1 amps or better if will be charged real quick
Click to expand...
Click to collapse
I noticed that using the Pure Nexus rom my charging time became significantly faster. In fact I can get a full charge from nearly dead in just over an hour. This is using the charger and cable that came with the phone.
I had the same problem too ! Did a full battery reset and everything is going good now !
MT tenso
How do you make full battery reset?
The charging rate is based on the output rating of the charger, which is determined by the resistance value between the Data+ and Data- USB pins. If you use a cheap cable with high(er) internal cabling resistance, that will throw off the detected charger output capacity rating, and knock you down to a lower charging current and longer charging time.
Also, one time, even with the original charger and original cable, I couldn't charge at anything more than the default USB 500mA. I ended up having to power off the phone, and power it on again, which fixed the charging current and speed problem.
Install this app & check if it is getting charged at max current; anything less than 1200 mA when screen on & 1900 mA when screen off, you need to change your cable or charger
https://play.google.com/store/apps/details?id=com.abmantis.galaxychargingcurrent.free
Sent from my GT-I9500 using Tapatalk
I read somewhere that if you activate airplane mode the battery is charging faster.
I know Adaptive Fast Charging doesn't kick in unless the battery is very low - less than 20%, I believe. And, yes, I have the 15 watt charger(s) that supports AFC/QC2.0
Does anyone know of a way, or if it's even possible, to trigger the phone to kick in fast charging at low, but not painfully low, rates?
Hi
My S6 always charges at the quickest speed possible because when I connect my Samsung Charger the phone tells me I have connected the fast charger and I know it is charging quickly because if I use another charger the time for a full charge will increase significantly. Are you using the official fast charger?
Yes, I've always experimented with the high-power charger that came with the phone.
Fast charging will speed up or slow down automatically based on how charged the battery is. The emptier the battery, the faster it will charge. This charge will slow down gradually as the battery fills up. I don't think there's a way to facilitate this, and even if there was, it probably would not be recommended to do as it might damage the battery.
Fast Charging is a concept, that comes into play when you are connected to the USB port of your PC. Typically when connected in MTP mode (or PTP FWIW), Phone charges slowly in order to prevent damage to the usb port. Certain kernels can permit fast charge provided your laptop has fastcharge usb.
For Wall charging, Rapidcharge technology does exist but requires original samsung charger. With any other OEM charger, it'd be a matter of luck since it'd need to have that 11th pin on the microusb.
Everything else that @Japultra is correct.
I'm almost too embarrassed to admit this, but it was the micro USB cord that wasn't letting my phone avail itself of the high-power adapters. I came across a thicker USB cable and, thinking/hoping that thicker cable also translated to higher gauge conducts, decided to try it out with my phone that was at 65%. Yup. The phone now indicated "fast charging".
I appreciate your forbearance, folks!
bwb8771 said:
I'm almost too embarrassed to admit this, but it was the micro USB cord that wasn't letting my phone avail itself of the high-power adapters. I came across a thicker USB cable and, thinking/hoping that thicker cable also translated to higher gauge conducts, decided to try it out with my phone that was at 65%. Yup. The phone now indicated "fast charging".
I appreciate your forbearance, folks!
Click to expand...
Click to collapse
So the original cable that came with the s6 wasn't working for you?
when i connect the cable every 1 min it stop charge and back charge again and in fact the battery is discharging if it was 55% it become 53% this when i disabled the fast charging in setting after android 6.0 marshmallow and when enable it device get hot very fast i could smell the heat easly? how to solve that
Sounds like a defective charger/USB cable/power source. In regards to it discharging and whatnot. Try with a different cable/charger/power source.
The heat is normal when you use Fast Charging, I thought everyone would've known this by 2016.
I use my phone's charger with a Sony USB cable. Because it has five pins on the inside, charges even faster than the four pins on my S6's OEM USB cable (and obviously more heat), the Indian version of the cable from Samsung has only four pins, they pulled one out, presumably thanks to idiots complaining about the heat.
Does this tablet require a special charger as i only seem to be able to get it to charge using the charger that came with it. if i try a power pack or any other charger it will not charge
It requires a 3amp or better charger at the standard 5V. I've successfully used battery banks and chargers that have 3amp or more. Most of the newest chargers and battery banks that support quick charging via the orange USB ports should provide 3amps and work fine from what I've experienced.
Sent from my LGMP450 using Tapatalk
What you might find is that the tablet does not report that it's being charged but it is actually being charged, very slowly and there's no indication of it taking place...
The way to check, is to plug in the tablet and note the battery percentage, leave it charging (with no indication that it is!) and then come back and check the battery percentage, you'll see that it's actually climbing up!
It does take a long time to charge on a 5V USB charger but the reason it doesn't show that it's charging is supposedly because the tablet needs to see at least 12 volts...
I've just ordered a 15v charger on Aliexpress for $5 shipped, to see if I can speed things up.
Still need to sort out the dead dock battery and may well get one from Aliexpress too...