[Completed] htc M8 only 1x after reset - XDA Assist

Hello, having some troubles with data. Phone calls and text work fine. I have an HTC one m8, viperone rom, on PPC. A few nights ago I let my battery completely drain to the point that it would get stuck on boot screen. So I did a factory reset, that got me out of the bootloop but since then I only have data when im on 1x, nor 3g or 4g, says mobile data disconnected. I have been using roms for a few years, no expert but i know enough to check the basic when troubleshooting. So next i tried installing a new sim card, same issue. Next I flashed the same 5.1 rom, same issue. I downloaded the latest rom from viper, 6.1 installed fine but now no data at all. So tried all the reboots, reinserted the card, airplane mode, modes, etc.....
Do i need to install a new radio firmware? I currently have the 1.12
Or did I mess up the divice with the battery completely draining?
Hopefully its a noob error I can fix with some advice from you guru's
Much thanks in advance!!
Bill

Duplicate.
Thread closed.

Related

cant connect to data or wifi

i recently flashed mighty rom onto my sprint tp2 and lost all internet connection. when i try to setup a new connection sprint is not on the list. if some one could please help me out i would greatly appreciate it
ok so i wiped the memory clean and when it rebooted the wifi started working but still no data.. i installed the sprint carrier provision cab and still nothing.. when i went back to the carrier provision settings it still shows up telius tho. so idk whats goin on here.. some help would be cool
nobodys got anything on this?
You don't mention what ROM you flashed, but I had a similar problem when using NRG's stunning "Leo" ROM in 6.5.3. Nothing I could do would bring back the internet connection until I flashed MightyROM and things worked properly again. I suspect that flashing back to a stock Sprint ROM would also work, and that was my next step if MightyROM didn't fix it. Note that hard resets and re-flashes accomplished nothing. I'll re-load the NRG ROM when I've got more time to screw with this thing and see if the problem returns.

HTC Desire S lost ratio signal

Hi,
I Recently updated my HTC Desire S for the new version 2.10.401.5, with Android 2.3.5 and Sense 3.0.
I still have the stock rom and S-ON, the update run without problems, every thing works ok but i found a little big problem.
When my phone lost ratio signal for a couple of secons he doesn't recover it , i need put the phone in plane mode on and off to restart the connection.
This is really bad because on my work station a have low signal for my phone operator
Any one can help please ?
Regars
Have you tried reformatting your phone? Restore factory default? I suggest you to make a clean setup to your phone.
If that doesn't helps, it would probably your carrier problem, try contacting them. That's all I can help you here.
i think its prblem with latest radio..i had problems with wifi..or maybe is just carrier as nodeffect suggest

[Q] HELP! Desperate here. WIND htc amaze ROM

Hello,
Hope you guys can help me. I'm lost right now. (COMPLETE NOOB)
Yesterday I rooted my htc amaze 4g with Hasoon's tool and it worked. Then I installed the Speed 8.0 rom on my phone and everything worked except that it did not recognized my mobile data. I could not even see the 4g in the corner next to the signal symbol.
After that I thought my Wind phone might not be 100% compatible with that ROM (since the rom might be for tmobile phones or something) so I tried the FastAmaze rom but the same. Now I'm trying to go back to the Stock rom, but I cant.
I tried downloading the RUU but once I start the process, it can not be completed. I don't get an exact error it only tells me that the usb might not be connected to the phone or to check the battery. I tried the same thing many times.
I really need data on my phone (Plus I'm paying for it). Can someone help me to restore the STOCK rom or to get data in the Speed or Fast Amaze rom? To avoid future problems I would prefer to just stick to the Stock rom, but if is not possible then as long as I can get data on my phone I'm happy.
A 1000 thank you to all of you.
PLEASE HELP!!!! (Again, I'm desperate)

problems running ViperXL

Hello all,
I was running ViperXL 3.2.8, but i could not connect to a pc to access unless in bootloader so i went back to 3.2.6 works fine but now i cannot use data over 4g 3g or 2g. I then tried installing (Using venomhub) a new radio nothing changed then did ElementalX kernel it killed my phone and it took me two days before i could either get it to boot or it would boot but .com processes were crashing.
I am not back in to 3.2.6 but as i said i have no data please could someone advise a fix.
Thank you in advance.
Are your APNs correct?
Sent from my Evita
Still new to Android even after 6 years, APN's were blank but even after I manually input the details and hit save the list stays empty.
Just rebooting and trying again
Try flashing a different ROM and see if you get data.
Sent from my Evita
It looks like that is what im going to have to do.
Thank you for your help.

[Q] No Data after Flashing Custom Rom

Kind of long, but it's just a difficult explanation, please read and try to help me. Thank you.
Okay, so I have a really weird problem, and I can't seem to fix it at all. I unlocked the bootloader and rooted my Sprint Motorola Photon Q, and had no problem with data loss, then I flashed PAC Man Rom, and everything went fine and it flashed but then I noticed that I had no data. No 3G, 4G, or 4G LTE, the phone lost network signal, but what was weird is that I could still receive texts and phone calls.
So, then I read that wiping the Dalvik and the regular cache would fix it, and it didn't. Then, I also tried flashing a different ROM which also didn't fix it. I RSD back to stock firmware and the problem was gone. I even tried rerooting and just installing a different ROM but, it still had the same issue, so I just went back to stock again.
Can someone please help me fix this? I've looked everywhere and I can't really find anything to help me out with this.
Thank you in advance.
Is your provider Sprint as well...?
I'm not sure, data works here on custom ROM's... which version are you flashing? Have you tried CM11?
There's some new device unification going on, the newest KK builds are going to be under the "moto_msm8960" device instead of xt897...
No I haven't tried CM11. Where do I find the IMG for it at?
I have Flash Wireless, which is Sprint prepaid. I have tried CM11 and still nothing. I don't understand what is going on....I'm getting real frustrated because I want to put a good custom ROM on my phone....
thebizerker2014 said:
I have Flash Wireless, which is Sprint prepaid. I have tried CM11 and still nothing. I don't understand what is going on....I'm getting real frustrated because I want to put a good custom ROM on my phone....
Click to expand...
Click to collapse
Perhaps that's the issue. Did you check your APN settings? Is it using Sprint's network?

Categories

Resources