I am not able to boot to One Plus 3 , no adb devices found, only Fastboot devices found.
Please Help!!
When booting to One Plus i get the below:
boot: failed
boot_aging : failed
system : failed
recovery : failed
This is the oneplus one forum.
Related
Hi,
I managed to get stuck in a boot loop after installing CM 11 on ascend U9200.
I try to using adb shell, it says:
Code:
error: device unauthorized. Please check the confirmation dialog on your device.
iam at bootloop and stuck at logo huawei, of course I cannot boot my device to confirm authorization.
How can I use adb without first being authorized?
i was tried :
1) Remove /data/misc/adb/* - Failed, same problem
2) Try different ROMs - Failed, same problem
3) Try different usb cable OR usb port - Failed, same problem
4) Removed all drivers and installed them again - Failed, same problem
5) Updated android-sdk - Failed, same problem
I am using a Motorola X Play 32 Gb Dual Sim phone with a Marshmallow 6.0.1
I'm now stuck at bootup with Start Up Failed.
Startup failed Error
your device didn't start up successfully
use the software repair assistant on computer
to repair ur device.
connect ur device to your computer to get
the software repair assistant
AP fastboot flash mode (Secure)
hab check failed for boot
Failed to verify hab image boot
failed to validate boot image
Error: failed to pass validation. backup to fastboot
Fastboot Reason: Fall-through from normal boot mode
pls Help by step by step methods I am Stuck.....Please
Regards
Rohit Pande
Hi scorpionking3010
Thank you for using XDA Assist
We were able to determine that you have already posted your issue here. It would be convenient that you give some time for our experts to analyse and answer you. Therefore, I will be closing this request here.
If you feel that it's taking too much, you may *bump up* by reposting some additional information regarding it and so.
Thankful for your understanding.
Nice regards and good luck.
THREAD CLOSED
.
scorpionking3010 said:
I am using a Motorola X Play 32 Gb Dual Sim phone with a Marshmallow 6.0.1
I'm now stuck at bootup with Start Up Failed.
Startup failed Error
your device didn't start up successfully
use the software repair assistant on computer
to repair ur device.
connect ur device to your computer to get
the software repair assistant
AP fastboot flash mode (Secure)
hab check failed for boot
Failed to verify hab image boot
failed to validate boot image
Error: failed to pass validation. backup to fastboot
Fastboot Reason: Fall-through from normal boot mode
pls Help by step by step methods I am Stuck.....Please
Regards
Rohit Pande
Click to expand...
Click to collapse
So i have a zenfone 2 ze550ml that is stuck on asus logo. I have tried :
1) Entering recovery mode and saw the dead android logo with a “error!” Text.
2) “power+volume up” trick to enter recovery mode (didn’t work)
3)fastboot erase cache
4)adb sideload “zip file”
5)Asus Flash Tool
6)fastboot with system splashscreen droidboot img’s ( sucessful but still stuck on logo)
7)xFTSK was successful (but phone still stuck on logo)(not the 5 0’s)
8) all the fastboot command was a success, except the oem command
9) uninstall all the programs necessary, and install it again
10) use other devices to try (still doesn’t work)
When i was searching online i still couldn’t understand:
1 ) A problem with “fastboot oem partition /tmp/partition.tbl” the error command was "FAILED (remote: GPT command failed)"
2) unlocking the bootloader “unroot” with fastboot (could it be open through fastboot?)
3) how to use the TWRP (can’t understand)
I found a simillar thread : http://https://forum.xda-developers.com/general/help/asus-zenfone-a601cg-fastboot-removing-t3630569#post75658798
I have read :
http://https://forum.xda-developers.com/zenfone2/general/unbrick-vid-tutorial-restore-serial-t3411064/page1
All the 18 page and asked there
https://forum.xda-developers.com/zenfone-5/help/debrick-asus-zenfoen-5-fastboot-t3377455/page1
All the 48 page and ask there
What i’ve discovered
1) the problem is with the software not hardware
2)if you don’t have a loading under the “asus in search of incredible” that means the main board is broken. Reason: heat, to much flashing, etc
Conclusion:
1)change the main component(really really expensive)
2)change it if you get gpt error
I subscribed and ask to the threds, still got no reply. I want to know what the command is for and how to solve it.
Ps. I’ve flash this phone numerous times this is the first this ever happened.
And i ask someone at asus service center about it. Hope this will ease someone stress.
I will provide as much information as possible.
The last time my phone was working, it was had build number FRD-L04C567B402.
I wanted to install the Oreo update, so I unlocked my bootloader and install TWRP for honor 8. Everything was working at this point.
I attempted to update my phone using the rom L04C567B560 and the methods provided in the thread below (HuRUpdater method)
https://forum.xda-developers.com/honor-8/how-to/guide-how-to-install-oreo-update-t3825078
It was when I attempted to install oreo my phone bricked. When I turned it on, it would attempt to boot multiple times, and then go into recovery mode.
I used the dload method to try to reflash stock rom. The installation would stop and 5% then give an error. This method failed.
I used the Huawei Extractor and multi Tool to flash a stock rom. I got the error "the size or path does not match the file system markup." This method failed.
I used adb and bootloader to flash boot.img and recovery.img directly on the device. I got the error "FAILED (remote: partition length get error)". This method failed.
After some browsing I found the following thread and attempted to used it.
https://forum.xda-developers.com/honor-8/how-to/guide-comprehensive-method-to-unbrick-t3632998
I completed up to step 8, and that package installed. Notice how the guide mentions the phone is still bricked.
After that update.app got installed, the phone went into a endless boot loop.
Now when device bootloops to this default screen
ERROR Mode
Func NO: 8 (hifi image)
Error NO: 1(security verify failed)
When I press vol+ and power, I see on my device
ERROR Mode
Func NO: 8 (hifi image)
Error NO: 1(security verify failed)
When I press vol+, vol- and power, I see on my device
Func NO : 11 (recovery image)
Error NO : 2 (load failed!)
I can still enter fastboot mode, but erecovery is no longer available. TWRP is also not available.
When I attempt to flash anything (recovery.img, system.img, boot.img) in fastboot mode. I get the error "FAILED (remote: partition length get error)".
Currently unsure what to do next. Any suggestions?
hi guys i have the following problem: I was using PE 10 Plus edition and out of nowhere several applications began to close, so I decided to turn off my device ... when I turned it on again to see if it had been solved, I was surprised that it did not start and the following appeared:
"failed to validate boot image
ERROR: Failed to pass validation "
so I tried to solve that by going into Fastboot Flash Mode and flashing a STOCK ROM with ADB commands and it didn't work, after restarting I got a new error, it is the following:
"Error: failed to load kernel!
boot up failed "
from there I can not find a solution to my problem, I hope you can help me!
From already thank you very much!!!!